Surfactant behavior and its influence on the viscosity of associative thickeners solutions, thickened latex dispersions, and waterborne latex coatings

Surfactants, varying in their chemical composition and hydrophobic behavior, are used in the formulation of a waterborne coating. These differences influence their aggregation in micellar structures, their interaction with associative thickeners, and in particular, the synergies present in their competitive adsorptions on the disperse phases in a waterborne coating. Adsorption of HEUR thickeners on latexes and the ability of surfactants to displace them from those surfaces is an important variable in the dispersion’s viscosity. With large particle latexes, viscosity increases arise primarily from the network built through the interaction of HEURs with surfactants in the aqueous phase. Fluorescence is used to verify the mechanism by which surfactants enhance associative thickener viscosities. That is best achieved with nonionic surfactants, because of their synergies with large hydrophobe HEURs at low concentration. With decreasing latex particle size the adsorbed species is an important contributor to the dispersion’s viscosity through its contribution to the latex’s effective volume fraction increase and when the size of the adsorbed HEUR is matched to the separation distances of the latex at 0.25 volume fraction. Achieving controlled shear-thinning behavior in small particle size latex paints with the economic constraints on the amount of HEUR required to obtain 90 KU viscosities are discussed. Presented at the 80th Annual Meeting of the Federation of Societies for Coatings Technology, October 30–November 1, 2002, in New Orleans, LA. Polymer and Coatings Dept., Fargo, ND 58103.     

A PET study of the neural systems of stuttering

The cause of stuttering is unknown. Failure to develop left-hemispheric dominance for speech is a long-standing theory although others implicated the motor system more broadly, often postulating hyperactivity of the right (language nondominant) cerebral hemisphere. As knowledge of motor circuitry has advanced, theories of stuttering have become more anatomically specific, postulating hyperactivity of premotor cortex, either directly or through connectivity with the thalamus and basal ganglia. Alternative theories target the auditory and speech production systems. By contrasting stuttering with fluent speech using positron emission tomography combined with chorus reading to induce fluency, we found support for each of these hypotheses. Stuttering induced widespread overactivations of the motor system in both cerebrum and cerebellum, with right cerebral dominance. Stuttered reading lacked left-lateralized activations of the auditory system, which are thought to support the self-monitoring of speech, and selectively deactivated a frontal-temporal system implicated in speech production. Induced fluency decreased or eliminated the overactivity in most motor areas, and largely reversed the auditory-system underactivations and the deactivation of the speech production system. Thus stuttering is a disorder affecting the multiple neural systems used for speaking.     

Adaptive tracking control of manipulators: Theory and experiments

This paper considers the trajectory tracking problem for uncertain robot manipulators and proposes two adaptive controllers as solutions to this problem. The first controller is derived under the assumption that the manipulator state is measurable, while the second strategy is developed for those applications in which only position measurements are available. The adaptive schemes are very general and computationally efficient since they do not require knowledge of either the mathematical model or the parameter values of the manipulator dynamics, and are implemented without calculation of the robot inverse dynamics or inverse kinematic transformation. It is shown that the control strategies ensure uniform boundedness of all signals in the presence of bounded disturbances, and that the ultimate size of the tracking errors can be made arbitrarily small. Experimental results are presented for a PUMA 560 manipulator and demonstrate that accurate and robust trajectory tracking can be achieved by using the proposed controllers.     

Geographic epidemiology of gonorrhea in Baltimore, Maryland, using a geographic information system

Ws/Ws rats are deficient in both mucosal- and connective tissue-type mast cells. To study the role of mast cells in active anaphylaxis, changes in vascular permeability in the trachea upon intravenous antigen challenge with Evans blue dye were examined in Ws/Ws, heterogenic Ws/+, and normal +/ + rats sensitized with the nematode Nippostrongylus brasiliensis. Antigen challenge resulted in fatal anaphylactic shock in some +/+ and Ws/+ rats, but not in Ws/Ws rats. Marked dye leakage developed within 30 min in the trachea of +/+ and Ws/+ rats, while Ws/Ws rats showed no substantial increases in the levels of vascular permeability. Ex vivo stimulation of sensitized lung fragments from +/+ animals with specific antigen induced significant releases of histamine and leukotriene (LT) C4, while sensitized Ws/Ws rat-lung fragments did not. In Ws/Ws rats, levels of nematode-specific IgE, IgG1 and IgG2a antibodies as well as levels of lung eosinophilia were not significantly different from those in +/+ rats. These results show that mast cell-deficient Ws/Ws rats fail to develop active anaphylaxis, and this is mediated probably by the lack of mast cell-derived mediators required for initiation of the reaction.     

Molecular and geographic patterns of tuberculosis transmission after 15 years of directly observed therapy

Stevioside is a sweet-tasting glycoside, composed of stevia, a diterpenic carboxylic alcohol with three glucose molecules, mainly used as a substitute for non-alcoholic sweetener. It has previously been shown to reduce blood pressure in studies in animals and human. The effect of intravenous stevioside on the blood pressure was studied in spontaneously hypertensive rats (SHR). The hypotensive effect on both systolic and diastolic blood pressure was dose-dependent for intravenous doses of 50, 100 and 200 mg/kg in conscious SHR. The maximum reductions in systolic and diastolic blood pressure were 31.4 +/- 4.2% and 40.8 +/- 5.6% (mean +/- SEM) respectively and the hypotensive effect lasted for more than 60 min with a dose of 200 mg/kg. Serum dopamine, norepinephrine and epinephrine levels were not changed significantly 60 min after intravenous injection of stevioside 100 mg/kg in anesthetized SHR. The present data show that stevioside given intravenously to conscious SHR was effective in blood pressure reduction and there was no change in serum catecholamines in anaesthetized animals with this natural compound.     

Performance relationships in PVC–plasticizer dry blending

The phenomenon of plasticizer acceptance by poly(vinyl chloride) (PVC) in hotprocess dry blending is examined via scanning electron microscopy, mercury intrusion porosimetry, and torque rheometer measurements. The effects of granule porosity, resin molecular weight, and synthesis recipe in PVC manufacture by the suspension process are related to the rate of plasticizer acceptance. For a PVC resin to dry blend, i.e., to become a free-flowing powder when mixed with plasticizer under hot-processing conditions, the resin granules must be porous. Porosity arises from interstices between primary PVC particles. At a given granule porosity, an increase in primary particle agglomeration adversely affects dry blend performance. At constant molecular weight and for resins manufactured by a given recipe, dry-blend performance is quantitatively described by granule porosity. With an increase in resin molecular weight, a greater granule porosity is required to maintain an equivalent dry-blend time (DBT). Accordingly, for most suspending agent recipes, DBT is dependent directly upon granule porosity and inversely upon molecular weight. However, if the suspending agent used in resin manufacture is an excessively rapid film former, dry-blend performance with molecular weight variation is dependent upon the suspending agent's concentration, not upon granule porosity, which must be adequate, nor upon the resin's molecular weight. An interfacial film-forming suspending agent enhances fusion of primary PVC particles at the suspension granule—water interface, increasing the granule's “pericellular membrane” thickness. This membrane, a PVC skin, does not significantly influence dry-blend performance with low- or intermediate-viscosity plasticizers. The particle skin does impede dry-blend rates with high-viscosity, poorly solvating plasticizers, but this effect can be negated in part by increasing the diameter of pore openings in the topographical skin. Dry blending occurs below the glass transition temperature (T_g) of PVC with low-viscosity plasticizers and above the T_g with high-viscosity, poorly solvating modifiers. The influence of resin and plasticizer variables indicates the dry-blend phenomenon to be a diffusion-controlled process. The rate of dry blending is dependent upon two mechanisms: (1) the rate of pore penetration—which exposes the plasticizer to a much greater surface area than if it remained exterior, encapsulating the granule—and (2) the rate of plasticizer diffusion into the PVC matrix.     

Factors affecting the corrosion rate of steel in carbonated mortars

The corrosion of steel in carbonated mortar has been investigated by monitoring polarization resistance, corrosion potential and mortar resistivity. The results suggest that factors such as relative humidity and chloride contamination affect the corrosion rate via their influence on mortar resistivity. To account for the observed electrochemical relationships, most notably the linear correlation between corrosion rate and conductivity, and the exponential increase in corrosion rate with fall in corrosion potential, it is proposed that the corrosion kinetics of steel in carbonated mortar are subject to anodic control with the anodic reaction rate being limited by the resistance of the mortar. In this model, termed anodic resistance control, resistivity is viewed as a factor which may limit a half reaction rate in a similar way to diffusion and activation polarization. It is also shown that, when such a model is operating, the use of polarization resistance to monitor corrosion rate changes may still be justified provided the cathodic reaction rate is an exponential function of potential.     

Software: Hero or Zero?

People might love to support underdogs, but they also love to kick them when they're down. And, at this point in time at least, software is the world's technological underdog!