Preparation of a Near-Infrared Ray Absorption Film from N-Phenylthiocarbamoyl Chitosan Derivative

We recently observed that the decanoylation of N-phenylthiocarbamoyl chitosan (2) with a mixture of decanoic anhydride and pyridine at 60 °C for 24 h afforded N,N-(decanoyl)phenythiocarbamoyl-/2-isothiocynato chitosan decanoate (3b) rather than the expected product N,N-(decanoyl)phenylthiocarbamoyl chitosan decanoate (3a). This result suggested that some of the N,N-(decanoyl)phenylthiocarmbamoyl groups had been converted to isothiocyanate groups during the decanoylation process. The subsequent reaction of compound 3b with aniline gave N,N-(decanoyl)phenylthiocarbamoyl/N-phenylthiocarbamoyl chitosan decanoate (4) in high yield. A solution of compound 4 in CHCl₃ was then added to a solution of copper decanoate (5) in the same solvent, and the resulting mixture was cast onto a glass plate to give a cast film. The film was annealed at 200 °C in an oven to give a greenish film, which showed good near-infrared absorption characteristic in the range of 800–2200 nm.     

Synthesis and luminescence of Sr2CeO4 fine particles

Fine particles of a blue emission phosphor Sr₂CeO₄ have been synthesized using a chemical co-precipitation technique, and the textual and luminescent properties were compared with the one synthesized by the conventional solid-state reaction method. Particle size and distribution of the Sr₂CeO₄ fine powder prepared by the co-precipitation process were smaller and narrower than those obtained by the samples prepared from the conventional one. The emission intensity of the fine particles was equal to that of the larger particles prepared from the solid-state reaction, on the contrary to the general tendency that emission intensity decrease with particle size reduction. Although no Ce³⁺ peaks were observed in EPR measurements, X-ray photoelectron spectra of the samples clearly elucidated the existence of Ce³⁺ only on the surface of Sr₂CeO₄.     

370 W output power GaN-FET amplifier for W-CDMA cellular base stations

A single-ended amplifier using small packaged GaN-FETs exhibits a record 2.14 GHz W-CDMA output power. The amplifier, composed of paralleled 48 mm gate periphery FET die, delivers a peak saturated output power of 371 W with a linear gain of 11.2 dB at a drain voltage of 45 V under 2.14 GHz 3GPP W-CDMA signal input. The output power density (output power/package size) of 1.1 W/mm/sup 2/ is twice as high as that of the existing over 300 W GaAs-FET amplifiers. A low 5 MHz offset ACLR of -36 dBc with a drain efficiency of 24% is also obtained at 8 dB power back off from the saturated output power.     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Color registration error reduction method compensating the influence of belt thickness variation in electrophotographic process

This paper proposes a new belt drive control method for reducing a belt velocity-fluctuation that is caused by a belt thickness-variation in the circumferential direction. A belt driving system performs feedback control with a rotary encoder-output mounted on a driven roller. This proposed method correct the reference value of the feedback control for the purpose of the belt velocity regulation. The correction includes two steps. The first step acquires the encoder-output of the driven roller and calculates the rotational angular velocity-fluctuation with one cycle of the belt rotation. The second step converts from the velocity-fluctuation to the correction value of the feedback reference. The correction value cancels a detection error of the driven roller caused by the belt thickness-variation. After these steps, the belt driving system controls the belt velocity as compensating the belt velocity-fluctuation. Experimental result showed the significant fluctuation reduction on a typical tandem-engine printer.     

Environmental effect on room- temperature ductility of isothermally forged tial- base alloys

Isothermally forged TiAl-base alloys (Al-rich, Mn-containing, and Cr-containing TiAl) were heat-treated in various conditions, and equiaxed grain structures consisting of γ and α₂ or Β phases were obtained. The heat-treated alloys were tensile tested in vacuum and air at room temperature, and the environmental effect on tensile elongation was studied. The ductility of the alloys consisting of equiaxed γ grains and a large amount of α₂ grains was not largely affected by laboratory air, and a decrease in the amount of α₂ grains resulted in a large reduction of ductility in air. The Β phase in the Cr-containing alloy improved the ductility in vacuum, but it resulted in a large reduction of ductility in air. Formerly with Kougakuin University, Shinjyuku-ku, Tokyo, Formerly with National Research Institute for Metals, Meguro-ku, Tokyo,     

Immunoassay method for the determination of immunoglobulin G using bacterial magnetic particles.

We have developed a novel immunoassay method using bacterial magnetic particles for the determination of immunoglobulin G (IgG). Fluorescein isothiocyanate (FITC) conjugated anti IgG-bacterial magnetic particles were prepared. The fluorescence quenching caused by agglutination of FITC-anti IgG antibody-bacterial magnetic particle conjugates was measured by using a fluorescence spectrophotometer. The aggregates based on specific immunoreaction were separated by a gelatin solution. The aggregation of bacterial magnetic particle conjugates was enhanced by application of a magnetic field. The relative fluorescence intensity correlated linearly with a concentration of IgG in the range 0.5-100 ng/mL.     

Successful eradication of H. pylori in an elderly patient with gastric cancer after effective UFT-E therapy

The patient was a 83-year-old female with 2' T2-type gastric cancer associated with positive H. pylori in the lesser curvature of the stomach. The patient was treated with oral UFT-E alone in a daily dose of 400 mg. The tumor exhibited an O' IIa + IIc-like appearance 4 weeks after the start of administration and became scarred 8 weeks later, revealing marked tumor reduction in a short period of time. At 8 weeks, biopsy showed marked polymorphonuclear cells infiltration of gastric mucosa with no evidence of malignancy. In an attempt to eradicate H. pylori, 30 mg of lansoprazole, 400 mg of clarithromycin, and 2.0 g of ecabet-Na (3.0 g of Gastrom) were administered for 2 weeks. H. pylori was found to have been successfully eradicated, and the inflammatory lesions were no longer visible histologically. UFT-E was highly effective in this patient, and the eradication of H. pylori may contribute to the prevention of cancer recurrence.     

Restoration of the red colour of photo-bleached carthamine in calcium-alginate gel membranes

The restoration of the red colour of carthamine (photo-bleached in polymeric heterosaccharide gels) was investigated using sodium salts, potassium salts, and alkali. Ca-alginate gel was stained with carthamine, and the red-dish membranes were exposed to fluorescent light for 2·5, 4·0 and 20 h (at 28°C). The resulting orange-yellow gel membranes were treated with Na- or K-citrate solution and the restoration of the red colouration was followed spectrophoto-metrically. The results indicate that the red colour of carthamine can be retained within the gel membranes, while yellow-coloured compounds were removed and/or transformed by the alkaline salt solutions.