Cardiovascular effects produced by R-(+)-8-hydroxy-2-(di-n-propylamino) tetralin in the preoptic area of conscious rats

The effect of ancrod-induced defibrinogenation on thrombosis and bleeding time was determined in anesthetized rats. Functional plasma fibrinogen levels were reduced 42, 71, 94 and 93% by ancrod doses of 5, 10, 20 and 30 U/kg, respectively, while a 2.5 U/kg dose was without significant effect. Ancrod inhibited vena cava thrombosis induced by partial stasis of blood flow combined with mild vascular injury. Thrombus weight was decreased 85 and 93% by the 10 and 20 U/kg doses, but was unaffected at lower doses. In contrast, ancrod doses of up to 30 U/kg did not significantly decrease carotid artery thrombi formed in response to oxidative transmural vessel injury. Ancrod caused a dose-dependent increase in bleeding time measured by puncturing small mesenteric arteries with a hypodermic needle. The bleeding time increase was approximately 38% in response to the 2.5 and 5 U/kg doses, and 182% in response to the 10 U/kg dose. These studies demonstrate that ancrod-induced reductions in plasma fibrinogen more effectively inhibit venous compared to arterial thrombosis, although these activities require doses that also increase bleeding time in small arteries.     

Removal of power line interference in signal-averagedelectrocardiography systems

A method for line interference reduction to be used in signal-averaged electrocardiography (SAECG) systems is proposed and its performance is analyzed. This new method is an adaptation of a previously reported technique for removal of line interference from conventional electrocardiograms. It involves the recording of a line reference signal simultaneous with the lead signals, so that a shifted and sealed version of it can be used to subtract line interference from the leads. It is shown that this line interference subtraction method can reduce line interference effectively and without introducing any additional noise into the ECG signal. It is also shown that Late Potential diagnostic decisions are not altered when this filter is applied. It is recommended that this technique be used in SAECG when line interference is unavoidable     

Requirements and Services for Metadata Management

Knowledge-intensive applications pose new challenges to metadata management, including distribution, access control, uniformity of access, and evolution in time. This paper identifies general requirements for metadata management and describes a simple model and service that focuses on RDF metadata to address these requirements.     

The Evolving Role of Fetuin-A in Nonalcoholic Fatty Liver Disease: An Overview from Liver to the Heart

Nonalcoholic fatty liver disease (NAFLD) is strongly associated to the features of metabolic syndrome which can progress to cirrhosis, liver failure and hepatocellular carcinoma. However, the most common cause of mortality in people with NAFLD is not liver-related but stems from atherosclerotic cardiovascular disease (CVD). The prevalence of NAFLD is on the rise, mainly as a consequence of its close association with two major worldwide epidemics, obesity and type 2 diabetes (T2D). The exact pathogenesis of NAFLD and especially the mechanisms leading to disease progression and CVD have not been completely elucidated. Human fetuin-A (alpha-2-Heremans Schmid glycoprotein), a glycoprotein produced by the liver and abundantly secreted into the circulation appears to play a role in insulin resistance, metabolic syndrome and inflammation. This review discusses the links between NAFLD and CVD by specifically focusing on fetuin-A’s function in the pathogenesis of NAFLD and atherosclerotic CVD.     

Lead recovery from aqueous environment by using porous carbon of citrus fruits waste: equilibrium,kinetics and thermodynamic studies

ABSTRACT

The mixture of citrus fruits (orange, grapefruit, mandarin, and lemon) wastes was utilized to obtain high surface area activated carbon (AC) by H₃PO₄ activation. The production conditions were optimized and the optimum conditions were determined. The optimal-activated carbon (CFWAC) was characterized by various physicochemical techniques. CFWAC was also used as a sorbent for Pb (II) ions from water. Batch experiments were performed to explore the adsorption capacity and mechanism. The Langmuir isotherm and pseudo-second-order kinetic model showed good fitness to the experimental data. The maximum Pb (II) adsorption capacity of CFWAC was found to be 163.93 mg/g.     

Segmentation of abdominal organs from CT using a multi-level,hierarchical neural network strategy

Precise measurements on abdominal organs are vital prior to the important clinical procedures. Such measurements require accurate segmentation of these organs, which is a very challenging task due to countless anatomical variations and technical difficulties. Although, several features with various classifiers have been designed to overcome these challenges, abdominal organ segmentation via classification is still an emerging field in order to reach desired precision. Recent studies on multiple feature–classifier combinations show that hierarchical systems outperform composite feature–single classifier models. In this study, how hierarchical formations can translate to improved accuracy, when large size feature spaces are involved, is explored for the problem of abdominal organ segmentation. As a result, a semi-automatic, slice-by-slice segmentation method is developed using a novel multi-level and hierarchical neural network (MHNN). MHNN is designed to collect complementary information about organs at each level of the hierarchy via different feature–classifier combinations. Moreover, each level of MHNN receives residual data from the previous level. The residual data is constructed to preserve zero false positive error until the last level of the hierarchy, where only most challenging samples remain. The algorithm mimics analysis behaviour of a radiologist by using the slice-by-slice iteration, which is supported with adjacent slice similarity features. This enables adaptive determination of system parameters and turns into the advantage of online training, which is done in parallel to the segmentation process. Proposed design can perform robust and accurate segmentation of abdominal organs as validated by using diverse data sets with various challenges.     

Activities of MFI-Supported Rhenium Catalysts for the Aromatization of Methane: Effect of Cationic Form of the Inorganic Carrier

MFI type inorganic carrier was used in two different cationic forms, hydrogen and calcium respectively. MFI-supported molybdenum and rhenium catalysts were prepared. The activities of the catalysts were compared for the aromatization reaction of methane. Higher activity values were attained with the catalysts supported on HZSM-5. Aromatics were also observed with the catalysts supported on CaZSM-5, despite their deficiency in acid sites. Highly dispersed rhenium is expected to be formed with the use of the inorganic carrier in calcium form. On the other hand, lower reaction rates were observed with rhenium supported on CaZSM-5, in spite of the improved dispersion of the active rhenium species on this catalyst. This was interpreted in terms of the critical role of the acid sites in the conversion of methane to aromatics, compared to the improved dispersion of the active metal.     

Biobased flexible polyurethane foams manufactured from lactide-based polyester-ether polyols for automotive applications

In this study, biobased polyester-ether polyols derived from meso-lactide and dimer acids were evaluated for flexible polyurethane foams (PUF) applications. Initially, the catalyst concentration was optimized for the biobased PUF containing 30% of biobased polyol (70% petroleum-based polyol). Then, the same formulation was used for biobased PUF synthesis containing 10%–40% of biobased polyols. The performance of biobased PUF was compared with the performance of the control foam made with 100% petroleum-based polyol. The characteristic times (cream, top of the cup, string gel, rise, tack-free) of biobased PUF were determined. The biobased PUF were evaluated for the mechanical (tensile and compressive) and morphological properties. As the wet compression set is important for automotive applications, it was measured for all biobased PUF. The thermal degradation behavior of biobased PUF was also evaluated and compared with the control foam. The effect of different hydroxyl and acid values of polyols on the mechanical properties of biobased PUF is also discussed. The miscibility of all components of PUF formulations is crucial in order to produce a foam with uniform properties. Thus, the miscibility of biobased polyols with commercial petroleum-based polyol was studied.