Toward a better understanding of multifunctional cement-based materials: The impact of graphite nanoplatelets (GNPs)

The impact of graphite nanoplatelets (GNPs) on the physical and mechanical properties of cementitious nanocomposites was investigated. A market-available premixed mortar was modified with 0.01% by weight of cement of commercial GNPs characterized by two distinctively different aspect ratios.The rheological behavior of the GNP-modified fresh admixtures was thoroughly evaluated. Hardened cementitious nanocomposites were investigated in terms of density, microstructure (Scanning Electron Microscopy, SEM and micro–Computed Tomography, μ-CT), mechanical properties (three-point bending and compression tests), and physical properties (electrochemical impedance spectroscopy, EIS and thermal conductivity measurements). At 28 days, all GNP-modified mortars showed about 12% increased density. Mortars reinforced with high aspect ratio GNPs exhibited the highest compressive and flexural strength: about 14% and 4% improvements compared to control sample, respectively. Conversely, low aspect ratio GNPs led to cementitious nanocomposites characterized by 36% decreased electrical resistivity combined with 60% increased thermal conductivity with respect to the control sample.     

Methanol and proton transport through chitosan-phosphotungstic acid membranes for direct methanol fuel cell

Composite chitosan-phosphotungstic acid membranes were synthesized by ionotropic gelation. Their liquid uptake is higher for thin membranes (23 ± 2 μm), while it is lower (~70%) for thicker membranes (50-70 μm). Polarization curves recorded using single module fuel cell at 70°C allowed to estimate a peak power density of 60 mW cm⁻² by using 1 M as methanol and low Pt and Pt/Ru loadings (0.5 and 3 mg cm⁻²) at the cathode and at the anode, respectively. Electrochemical impedance spectroscopy was used to estimate the membrane conductivity and to model the electrochemical behavior of methanol electrooxidation inside the fuel cell revealing a two-step mechanism mainly responsible of overall kinetic losses. Transport of methanol inside the membrane was studied by potentiostatic measurements, allowing to estimate a methanol diffusivity of 3.6 × 10⁻⁶ cm² s⁻¹.     

Chemical Characterization of Sorbitan Tri-Stearate Commercial Samples and Their Determination in Confectionery Fats by HPLC High-Resolution Mass Spectrometry

Nominal sorbitan tristearate (E492) commercial samples are widely used generally as emulsifiers and particularly as anti-bloom agents in confectionery products. In spite of this generalized use, their qualitative and quantitative evaluation is poorly documented in literature and the relative works go back to the last decades of last century. In the present work, a deep study by HPLC-High Resolution Mass Spectrometry of qualitative composition of five E492 commercial samples was made up showing a very complex pattern of stearic and palmitic acid esters with the sorbitol anhydrides, sorbitan, and isosorbide. A clear distinction of sorbitan mono-, di-, tri-, and tetra-esters, of sorbitol penta- and hexa-esters and isosorbide mono- and di-esters was achieved. Contemporarily, difference in the qualitative pattern between E492 commercial samples coming from different suppliers was established. As a consequence, quantitative evaluation can be reliably obtained by using as calibration standard the same E492 present in real samples. The accuracy and recovery of the method were determined allowing in this way a reliable application to commercial confectionery products. The detailed knowledge of STS composition may be of great help to orient the synthesis conditions in order to modulate its properties as a function of various experimental necessities.     

NaWuReT-Workshop: Forschung in der Reaktionstechnik für und mit der Gesellschaft

In this article, the results of the NaWuReT (Early Career Reaction Engineers) workshop on the topic “Are we doing relevant science?” are presented. The topics “(In)surmountable hurdles for Citizen Scientists in reaction engineering?” and “Circular Economy in reaction engineering with/for society?” were discussed. Therefrom, a variety of ideas and suggestions were extracted.     

Novel KCND3 Variant Underlying Nonprogressive Congenital Ataxia or SCA19/22 Disrupt KV4.3 Protein Expression and K+ Currents with Variable Effects on Channel Properties

KCND3 encodes the voltage-gated potassium channel K_V4.3 that is highly expressed in the cerebellum, where it regulates dendritic excitability and calcium influx. Loss-of-function K_V4.3 mutations have been associated with dominant spinocerebellar ataxia (SCA19/22). By targeted NGS sequencing, we identified two novel KCND3 missense variants of the K_V4.3 channel: p.S347W identified in a patient with adult-onset pure cerebellar syndrome and p.W359G detected in a child with congenital nonprogressive ataxia. Neuroimaging showed mild cerebellar atrophy in both patients. We performed a two-electrode voltage-clamp recording of K_V4.3 currents in Xenopus oocytes: both the p.G345V (previously reported in a SCA19/22 family) and p.S347W mutants exhibited reduced peak currents by 50%, while no K+ current was detectable for the p.W359G mutant. We assessed the effect of the mutations on channel gating by measuring steady-state voltage-dependent activation and inactivation properties: no significant alterations were detected in p.G345V and p.S347W disease-associated variants, compared to controls. K_V4.3 expression studies in HEK293T cells showed 53% (p.G345V), 45% (p.S347W) and 75% (p.W359G) reductions in mutant protein levels compared with the wildtype. The present study broadens the spectrum of the known phenotypes and identifies additional variants for KCND3-related disorders, outlining the importance of SCA gene screening in early-onset and congenital ataxia.     

α-Alumina and spinel react into single-phase high-alumina spinel in <3 seconds during flash sintering

In situ X-ray diffraction measurements at the Advanced Photon Source show that α-Al₂O₃ and MgAl₂O₄ react nearly instantaneously and completely, and nearly completely to form single-phase high-alumina spinel during voltage-to-current type of flash sintering experiments. The initial sample was constituted from powders of α-Al₂O₃, MgAl₂O₄ spinel, and cubic 8 mol% Y₂O₃-stabilized ZrO₂ (8YSZ) mixed in equal volume fractions, the spinel to alumina molar ratio being 1:1.5. Specimen temperature was measured by thermal expansion of the platinum standard. These measurements correlated well with a black-body radiation model, using appropriate values for the emissivity of the constituents. Temperatures of 1600-1736°C were reached during the flash, which promoted the formation of alumina-rich spinel. In a second set of experiments, the flash was induced in a current-rate method where the current flowing through the specimen is controlled and increased at a constant rate. In these experiments, we observed the formation of two different compositions of spinel, MgO•3Al₂O₃ and MgO•1.5Al₂O₃, which evolved into a single composition of MgO•2.5Al₂O₃ as the current continued to increase. In summary, flash sintering is an expedient way to create single-phase, alumina-rich spinel.     

Modelling observed California Current mesoscale eddies and the ecosystem response

Satellite and in situ observations are used to test model dynamics for the California Current System (CCS). The model and data are combined to reconstruct the mesoscale ocean structure during a given three-week period. The resulting physical flow field is used to drive a 3D ecosystem model to interpret SeaWiFS and in situ chlorophyll-a (chl-a) variations. With this approach a more complete and consistent picture of the physical and ecosystem processes of the CCS is obtained, providing the basis for addressing fundamental questions about dynamics and predictability of the coastal ocean.     

Playing on a holo-stage: towards the interaction between real and virtual performers

This paper presents a number of ongoing projects that will be valuable to the development of technologies for digital theatre and performance. This paper describes an EU ACTS project called RESOLV which develops an integrated system to capture real 3D environments using laser and video. Current research on motion tracking, statistical behaviour modelling and simulation is presented, and possible applications, both for visual augmentation and audio generation, are discussed. The projects presented were not originally designed in the domain of theatre and performance, however their results and output seem to be well suited to be applied in this area.     

VFC-SMOTE: very fast continuous synthetic minority oversampling for evolving data streams

Data Mining and Knowledge Discovery - The world is constantly changing, and so are the massive amount of data produced. However, only a few studies deal with online class imbalance learning that...     

A Case of Double Standard: Sex Differences in Multiple Sclerosis Risk Factors

Multiple sclerosis is a complex, multifactorial, dysimmune disease prevalent in women. Its etiopathogenesis is extremely intricate, since each risk factor behaves as a variable that is interconnected with others. In order to understand these interactions, sex must be considered as a determining element, either in a protective or pathological sense, and not as one of many variables. In particular, sex seems to highly influence immune response at chromosomal, epigenetic, and hormonal levels. Environmental and genetic risk factors cannot be considered without sex, since sex-based immunological differences deeply affect disease onset, course, and prognosis. Understanding the mechanisms underlying sex-based differences is necessary in order to develop a more effective and personalized therapeutic approach.