Re-evaluation of Radiation-Energy Transfer to an Extraction Solvent in a Minor-Actinide-Separation Process Based on Consideration of Radiation Permeability

ABSTRACT

Absorbed-dose estimation is essential for evaluation of the radiation tolerance of minor-actinide-separation processes. We propose a dose-evaluation method based on radiation permeability, with comparisons of heterogeneous structures seen in the solvent-extraction process, such as emulsions forming in the mixture of the organic and aqueous phases. A demonstration of radiation-energy-transfer simulation is performed with a focus on the minor-actinide-recovery process from high-level liquid waste with the aid of the Monte Carlo radiation-transport code PHITS. The simulation results indicate that the dose absorbed by the extraction solvent from alpha radiation depends upon the emulsion structure, and that from beta and gamma radiation depends upon the mixer-settler-apparatus size. Non-negligible contributions of well-permeable gamma rays were indicated in terms of the plant operation of the minor-actinide-separation process.     

Combustion synthesis of AlN doped with carbon and oxygen

Carbon-and-oxygen-doped AlN specimens were prepared by combustion synthesis using Al, graphite, and AlN. Graphite addition changed the product color from white to blue. By XRD, the lattice constant increased slightly with increasing carbon content. Blue AlN powder was synthesized with a molar ratio of the diluent AlN of 0.2-0.5 with a fixed graphite content of 0.05. At an AlN molar ratio exceeding 0.6, carbon was not successfully incorporated due to the lower reaction temperature. Calcination at 800°C in air removed residual graphite without changing the crystal structure or product color. Oxygen, nitrogen, and carbon analyses revealed that blue AlN powders contained 0.45-0.54 mass% carbon and 1.4-1.6 mass% oxygen, while the undoped AlN contained 0.021 mass% carbon and 0.94 mass% oxygen. The origin of the white-to-blue color change was investigated via reflection measurements. Blue AlN exhibits an absorption peak at 634 nm (1.96 eV). From first-principles electronic structure calculations, the C-doped AlN and carbon-and-oxygen-doped AlN with a 1:1 ratio could be classified as p-type, whereas the O-doped AlN and 1:3 carbon-and-oxygen-doped AlN were n-type. One reason for the absorption peak at 634 nm may be a transition from the conduction band to an upper unoccupied state. These results suggest the possible control of optical and electronic properties of AlN via carbon-and-oxygen doping.     

Temperature-responsive culture surfaces for insect cell sheets to fabricate a bioactuator

ABSTRACT

For the first time, we have fabricated insect-derived cell sheets by using temperature-responsive culture surfaces having a phase-transition temperature below 25°C. We prepared the temperature-responsive cell culture surfaces (tissue culture polystyrene, TCPS) by grafting a copolymeric gel consisting of hydrophobic N-tert-butylacrylamide (tBAAm) and N-isopropylacrylamide (IPAAm) units. First, to characterize the hydrophilic and hydrophobic properties of the copolymeric gel-grafted surfaces, static water contact angles of each surface were measured at various temperatures. By increasing the amount of tBAAm in the grafted copolymeric gel, the transition temperature of the gel was shifted to lower temperatures. At 25°C, the grafted copolymeric gel was dehydrated, and the insect-derived cells (AeAl2 cells) adhered on all the copolymeric gel-grafted surfaces. At 20°C, AeAl2 cells cannot adhere on the P(IPAAm-1.62tBAAm)-TCPS surface (the initial molar ratio of IPAAm and tBAAm (tBAAm?=?1.62 mol%)) better than on other surfaces (TCPS and tBAAm?=?4.88, 8.17 mol%). These two findings implied that the lower critical solution temperature of the copolymeric gel-grafted-TCPS existed from 20°C to 25°C. The laminin-coated P(IPAAm-1.62tBAAm)-TCPS surface showed temperature-dependent cell attachment and detachment properties, while AeAl2 cells were not detached from the extracellular matrix uncoated P(IPAAm-1.62tBAAm)-TCPS surface. AeAl2 cells and insect muscle cells were harvested as the respective sheets.     

Engineering of Lipid Nanoparticles by the Multifunctionalization of the Surface with Amino Acid Derivatives for the Neutralization of a Target Toxic Peptide

Protein affinity reagents (e.g., antibodies) are often used for basic research, diagnostics, separations, and disease therapy. Although a lot of “synthetic” protein affinity reagents have been developed as a cost-effective alternative to antibodies, their low biocompatibility is a considerable problem for clinical application. Lipid nanoparticles (LNP) represent a highly biocompatible drug delivery agent. However, little has been reported that LNP itself works as a protein affinity reagent in living animals. Here, LNP is engineered for binding to and neutralizing a target toxic peptide in living animals by multifunctionalization with amino acid derivatives. Multifunctionalized LNP (MF-LNP) is prepared using amino acid derivative-conjugated lipids. Optimized MF-LNP exhibits nanomolar affinity to the target toxic peptide and inhibits toxic peptide-dependent hemolysis and cytotoxicity. In addition, MF-LNP captures and neutralizes the toxic peptide after intravenous injection in the bloodstream; in addition, MF-LNP does not release the toxic peptide in the accumulated organ. These results reveal the potential of using LNP as a highly biocompatible protein affinity reagent such as an antidote.     

Restraint Method for Overcoming Heating Irregularity and Improving Heating Equipment Efficiency for Beverage Cans Using High‐Frequency Induction Heating

We were able to reduce heating irregularities in equipment for heating beverage cans by using the high‐frequency induction heating method and determining the resulting improvement in the heating efficiency. The heating irregularity between the top and bottom of the can was reduced to less than 3°C by improving the arrangement of the heating coils for the beverage can by thinning the winding and changing the circuit configuration. The efficiency of power conversion was improved from 93.0% to 97.4%. In this paper, the configuration of the equipment and the experimental results are reported.     

Evaluation of standing‐sitting support system with passive rotational seat mechanism in standing motion

Since a decrease in muscle mass of elderly people, the physical burden of them in standing‐sitting motion of a seat are increasing than young people. For this problem, several standing‐sitting support systems have been developed, and evaluations of these systems focusing on a reduction of physical load have been discussed. However, these evaluations are of support systems with an active actuators or of support systems when they use a handrail and a standing aid. Thus, an evaluation of a support system with only passive actuators has not been reported. In this paper, in standing motion with using a standing‐sitting support system with passive rotational seat mechanism which our group proposes, we objectively evaluate an effectiveness of the passive rotational seat mechanism by statistical analysis.     

Motion control of underactuated linkage robot based on gymnastic skill

In this paper, a reproduction of a swing‐up and a giant swing motion of underactuated robots based on technique of the horizontal bar gymnast is discussed with focusing on an equivalent center of mass (ECM) of underactuated robots and the gymnast. At first, the behaviors of the ECM of the gymnast (ECMG) are analyzed by using a motion capturing technique and an efficient motion of the ECMG for the swing‐up and for the giant swing motion are identified from analysis results, respectively. Next, a partial linearization method, which can realize that the ECM of the Acrobot (ECMA) replicates this efficient motion, is designed and reproduces the underactuated robots the swing‐up and giant swing motion like the gymnast. Finally, an effectiveness of the proposed controller is shown by numerical simulations.     

Changing Microspatial Patterns of Sulfate-Reducing Microorganisms (SRM) during Cycling of Marine Stromatolite Mats

Microspatial arrangements of sulfate-reducing microorganisms (SRM) in surface microbial mats (~1.5 mm) forming open marine stromatolites were investigated. Previous research revealed three different mat types associated with these stromatolites, each with a unique petrographic signature. Here we focused on comparing “non-lithifying” (Type-1) and “lithifying” (Type-2) mats. Our results revealed three major trends: (1) Molecular typing using the dsrA probe revealed a shift in the SRM community composition between Type-1 and Type-2 mats. Fluorescence in-situ hybridization (FISH) coupled to confocal scanning-laser microscopy (CSLM)-based image analyses, and ³⁵SO₄ ²⁻-silver foil patterns showed that SRM were present in surfaces of both mat types, but in significantly (p < 0.05) higher abundances in Type-2 mats. Over 85% of SRM cells in the top 0.5 mm of Type-2 mats were contained in a dense 130 μm thick horizontal layer comprised of clusters of varying sizes; (2) Microspatial mapping revealed that locations of SRM and CaCO₃ precipitation were significantly correlated (p < 0.05); (3) Extracts from Type-2 mats contained acylhomoserine-lactones (C4-, C6-, oxo-C6 C7-, C8-, C10-, C12-, C14-AHLs) involved in cell-cell communication. Similar AHLs were produced by SRM mat-isolates. These trends suggest that development of a microspatially-organized SRM community is closely-associated with the hallmark transition of stromatolite surface mats from a non-lithifying to a lithifying state.     

Absolute Configuration of β- and α-Asymmetric Carbons within β-O-4-Structures in Hardwood Lignin

In this study, we investigated the proportion of erythro- and threo-forms of β-O-4-ether structures and their enantiomeric compositions in hardwood lignin by applying the ozonation method to birch wood meal. Optical activity was not substantially observed in either the erythronic or threonic acids obtained as the ozonation products of β-O-4-structures in birch wood meal. The proportions of the four stereoisomeric forms {(αS,βR)-erythro, (αR,βR)-threo, (αS,βS)-threo, and (αR,βS)-erythro forms} were estimated to be 37-38%, 13-14%, 12-13%, and 36-37% based on the yields of erythronic and threonic acids, and on their optical activities. The proportions suggest that the entire components of β-O-4-ether structures in birch wood lignin have R- and S-configurations at the β-carbon in approximately the same quantities {(βR)-β-O-4-structure: (βS)-β-O-4-structure = 50–52:48–50}; i.e., that the β-ether structures are essentially racemic. This estimation implies that, during lignin biosynthesis, an equal number of enantiomeric forms of β-O-4-bonded quinone methides were formed by radical coupling reactions.     

Hydrostatic Pressure Influences HIF-2 Alpha Expression in Chondrocytes

Hypoxia-inducible factor (HIF)-2α is considered to play a major role in the progression of osteoarthritis. Recently, it was reported that pressure amplitude influences HIF-2α expression in murine endothelial cells. We examined whether hydrostatic pressure is involved in expression of HIF-2α in articular chondrocytes. Chondrocytes were cultured and stimulated by inflammation or hydrostatic pressure of 0, 5, 10, or 50 MPa. After stimulation, heat shock protein (HSP) 70, HIF-2α, nuclear factor kappa B (NF-κB), matrix metalloproteinase (MMP)-13, MMP-3, and vascular endothelial growth factor (VEGF) gene expression were evaluated. The levels of all gene expression were increased by inflammatory stress. When chondrocytes were exposed to a hydrostatic pressure of 5 MPa, HIF-2α, MMP-13, and MMP-3 gene expression increased significantly although those of HSP70 and NF-κB were not significantly different from the control group. In contrast, HIF-2α gene expression did not increase under a hydrostatic pressure of 50 MPa although HSP70 and NF-κB expression increased significantly compared to control. We considered that hydrostatic pressure of 5 MPa could regulate HIF-2α independent of NF-κB, because the level of HIF-2α gene expression increased significantly without upregulation of NF-κB expression at 5 MPa. Hydrostatic pressure may influence cartilage degeneration, inducing MMP-13 and MMP-3 expression through HIF-2α.