Methanol Conversion to Hydrocarbons (MTH) Over H-ITQ-13 (ITH) Zeolite

Product flexibility is key to meeting fluctuating chemicals demands in the future. In this contribution, the methanol to hydrocarbons (MTH) reaction was investigated over two Ge-containing H-ITQ-13 samples, one with needle-like (H-ITQ-13(N), with (Si+Ge)/Al) = 42) and another with plate-like (H-ITQ-13(P), with (Si+Ge)/Al > 100) morphology. The samples were characterised using XRD, BET, SEM/EDS and FTIR spectroscopy, and their MTH performance was compared with the performance of H-ZSM-5 and H-ZSM-22. Similar specific surface areas (413 and 455 m² g^?1 for H-ITQ-13(N) and (P), respectively) and similar acid strength (Δν ~ ?327(?310) cm^?1) was observed for the two H-ITQ-13 samples. Testing of H-ITQ-13(N) at weight hourly space velocity (WHSV) = 2–8 h^?1 at 350–450 °C revealed that C₅₊ alkenes were the main products (35–45 % selectivity at 400 °C), followed by propene and butene. A low but significant selectivity for aromatic products was observed (6–8 % selectivity at 400 °C). Product selectivity was found to be independent of deactivation. The methanol conversion capacity of H-ITQ-13(N) was 120–150 g methanol g^?1 catalyst at 400 °C. Testing H-ITQ-13 at high (30 atm) and ambient pressure, respectively, at 350 °C showed that a high pressure led to enhanced C₅₊ selectivity, but close to a tenfold decrease in methanol conversion capacity. H-ITQ-13(P) was tested at 400 °C and 2 h^?1. It gave lower conversion than H-ITQ-13(N). Furthermore, when compared at the same conversion level, H-ITQ-13(P) gave higher C₅₊ alkene selectivity, lower aromatics selectivity, and a higher propene to ethene ratio than H-ITQ-13(N). The H-ITQ-13 samples yielded a product spectrum intermediate of H-ZSM-22 and H-ZSM-5. The effluent product cut-off of H-ITQ-13 was similar to that of H-ZSM-5 with tetramethylbenzene as the largest significant product, while H-ZSM-22 produced mainly linear and branched alkenes. The lifetime of H-ITQ-13(N) was clearly enhanced compared to H-ZSM-22, but inferior to H-ZSM-5.     

Cfd analysis and airflow measurements to approach large industrial halls energy efficiency: A case study of a cardboard mill hall

This paper deals with numerical methods for predicting air flow patterns in large industrial halls. Some major findings of the investigation of the airflow patterns in paper machine hall of Umka Cardboard Mill are presented in the paper. The main reason for the interest in this problem is to find optimal locations for extract air intake connections of the ventilation system connected to the exhausted air waste heat utilization. Previous studies have shown that the amount of heat released from the cardboard machine to the surrounding air in the hall and extracted by the series of ceiling mount axial fans was almost 30% of the total waste heat from the paper machine's drying section. These results have indicated the need for the waste heat utilization, but also for the optimization of the ventilation system. CFD simulation for predicting of air flow patterns was applied. The accuracy of the simulation was evaluated by comparing its results with the results of field measurements. Simulation results served well for qualitative analysis, gave better insight in general air movements inside the hall and indicated the extract air intake locations. By utilizing the waste heat from proposed optimal locations, fuel savings of 5% and reduction of 1140 t/year in CO₂ emissions can be achieved.