Combustion synthesis of AlN doped with carbon and oxygen

Carbon-and-oxygen-doped AlN specimens were prepared by combustion synthesis using Al, graphite, and AlN. Graphite addition changed the product color from white to blue. By XRD, the lattice constant increased slightly with increasing carbon content. Blue AlN powder was synthesized with a molar ratio of the diluent AlN of 0.2-0.5 with a fixed graphite content of 0.05. At an AlN molar ratio exceeding 0.6, carbon was not successfully incorporated due to the lower reaction temperature. Calcination at 800°C in air removed residual graphite without changing the crystal structure or product color. Oxygen, nitrogen, and carbon analyses revealed that blue AlN powders contained 0.45-0.54 mass% carbon and 1.4-1.6 mass% oxygen, while the undoped AlN contained 0.021 mass% carbon and 0.94 mass% oxygen. The origin of the white-to-blue color change was investigated via reflection measurements. Blue AlN exhibits an absorption peak at 634 nm (1.96 eV). From first-principles electronic structure calculations, the C-doped AlN and carbon-and-oxygen-doped AlN with a 1:1 ratio could be classified as p-type, whereas the O-doped AlN and 1:3 carbon-and-oxygen-doped AlN were n-type. One reason for the absorption peak at 634 nm may be a transition from the conduction band to an upper unoccupied state. These results suggest the possible control of optical and electronic properties of AlN via carbon-and-oxygen doping.     

Augmentation of boiling heat transfer from horizontal cylinder to liquid by movable particles

This paper presents a series of experimental results on a passive augmentation technique of boiling heat transfer by supplying solid particles in liquid. A cylindrical heater 0.88 mm in diameter is placed in saturated water, in which a lot of mobile particles exist, and the nucleate and film boiling heat transfer characteristics are measured. Particle materials used were alumina, glass, and porous alumina, and the diameter ranged from 0.3 mm to 2.5 mm. Particles are fluidized by the occurrence of boiling without any additive power, and the heat transfer is augmented. The maximum augmentation ratio obtained in this experiment reaches about ten times the heat transfer coefficient obtained in liquid alone. The augmentation ratio is mainly affected by the particle material, diameter, and the height of the particle bed set at no boiling condition. The augmentation mechanism is discussed on the basis of the experimental results. © 2001 Scripta Technica, Heat Trans Asian Res, 31(1): 28–41, 2002     

The significance of urinary N-acetyl-beta-D-glucosaminidase for predicting early stage diabetic nephropathy

We studied urinary N-acetyl-beta-D-glucosaminidase (NAG) in the early stage of diabetic nephropathy in 27 non-insulin-dependent diabetes mellitus (NIDDM) patients with a microalbumin level below 20 mg on 24-hour urine sample. Microalbumin and NAG excretion were measured in 24-hour urine samples collected on three separate occasions within seven days of admission. Creatinine clearance was determined simultaneously. There was a significant negative correlation between the creatinine clearance and 24-hour urinary NAG (r = -0.38, p < 0.05). Elevation of urinary NAG may indicate decreased renal function during early stage NIDDM nephropathy.     

A study of suppression of vapor explosions by adding inversely soluble polymers

The mechanism of the suppression of vapor explosions by adding inversely soluble polymers in water is studied. Vapor explosion experiments and quench experiment are conducted using a silver test piece. Polymetric solution (polyethylene oxide), of concentrations from 0 to 500 wppm, whose normalized viscosity (by water) varies from 1.00 to 2.00, is used. No vapor explosion is observed in the aqueous polymer solution at a concentration higher than 200 wppm. Quench experiments using the silver test piece submerged in the polymer solution and water are performed in order to examine the stability of film boiling. The suppression of the vapor film collapse is attributed to the precipitation of polyethylene as a gel around the vapor film. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(4): 297–306, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10037     

Inhibition of natural killer cell cytotoxicity by cell growth-related molecules

Certain MHC class I molecules on target cells are known to inhibit the cytotoxic action of NK cells. By using monoclonal antibody (mAb) Cho-1, we have found inhibitory non-MHC class I cell surface molecules that are noncovalently-associated with 200 kDa and 40 kDa antigens. Poly I-C-induced rat NK cells were not cytotoxic to rat fetus-derived fibroblast WFB cell line. In contrast, NK cells were cytotoxic to H-ras oncogene-induced transformants of WFB, W14 and W31. FACS analysis indicated that mAb Cho-1 reacts with WFB, but not with W14 and W31 cells. Thus, this antigen may disappear concomitantly with cell growth and transformation. Cho-1 antigens were also expressed on other NK-resistant lines, such as mouse BALB3T3 fibroblast, EL-4 lymphoma and human fibroblast HEPM. However, they were not expressed on NK-sensitive mouse YAC-1 and H-ras transformant (Brash) of BALB3T3 cells. Furthermore, treatment of target cells with IFN-gamma clearly induced the cell surface expression of Cho-1 antigens, and conferred a resistance to NK cytolysis on target cells. These data strongly suggest that Cho-1 antigen expression may correlate with target cell susceptibility to NK cells. Indeed, treatment of NK-resistant WFB as well as HEPM cells with F(ab')2 fragments of mAb Cho-1 resulted in the acquisition of susceptibility to NK cytolysis. Cho-1 antigens may be novel molecules that regulate the NK resistance of cells.     

Electrochemical noise analysis for estimation of corrosion rate of carbon steel in bicarbonate solution

We have investigated the electrochemical noise behavior of carbon steel in fully deaerated aqueous bicarbonate solutions, and discussed the optimum conditions of the noise analysis for estimating corrosion rate of the steel. Noise of the potential difference and of the short-circuit current between two identical steel coupons were successfully measured. The time-series noise patterns were transformed into frequency domain by fast Fourier transformation, and then their power spectrum densities (PSDs) at a frequency were determined to be compared with the corrosion rate. The PSDs of the potential and of the current varied with changing environmental factors of bicarbonate concentration, pH, and immersion time. The factors also controlled the corrosion rate of the steel. The PSDs were associated with the corrosion rate, and then it was found that the PSDs of the potential and of the current showed linear correlation with the corrosion rate in log-log scale. There was also linear relationship between the corrosion rate and a spectral noise resistance obtained from the PSDs of the potential and the current. The linearities of the three correlations were better at a lower analyzed frequency. Furthermore, the PSDs of the current and the noise resistance indicated more linear correlation with the corrosion rate than that of the potential. As the simplicity of the measurement system is additionally considered, it is concluded that the PSD of the current noise at an analyzed frequency of 3 mHz is the optimum conditions for estimating the corrosion rate from 10⁻² to 10⁰ A m⁻² in this study.     

Detection of hypervascular hepatocellular carcinoma by using spiral volumetric CT: comparison of US and MR imaging

BACKGROUND: Most hepatocellular carcinomas (HCCs) are hypervascular and arise in the liver with chronicity. Spiral volumetric CT (SVCT) is a new rapid-scan technique that offers whole-liver scanning during the arterial-dominant phase. The main aim of the present study is to evaluate the detectability of hypervascular HCC with SVCT as compared with ultrasonography (US) and magnetic resonance (MR) imaging. METHODS: Forty-three hypervascular HCCs in 512 patients with chronic liver disease were examined with US, precontrast SVCT, postcontrast SVCT during the arterial-dominant phase (CT-ADP) and during the equivalent-phase (CT-EP) noncontrast MR imaging and angiography including SVCT during arteriography and arterial portography. Angiographic and follow-up findings were used as the gold standard if the lesion was not confirmed histologically. RESULTS: The sensitivity was 61% with precontrast CT, 84% with CT-ADP, 58% with CT-EP, 70% with US, 72% with MR, and 95% with the combination of these five modalities. Five HCCs (12%) were detected with only CT-ADP. The vascularity of HCC was correctly evaluated as hypervascular in 38 nodules (88%) with the combination of precontrast CT and CT-ADP. CONCLUSIONS: We suggest that the combination of precontrast SVCT and CT-ADP is an essential modality to screen for HCC in patients with chronic liver disease. CT-EP did not contribute to the detection of hypervascular HCC.     

Bottom-up multi-agent reinforcement learning by reward shaping for cooperative-competitive tasks

Applied Intelligence - A multi-agent system (MAS) is expected to be applied to various real-world problems where a single agent cannot accomplish given tasks. Due to the inherent complexity in the...     

Investigation of CH4 Reforming with CO2 on Meso-Porous Al2O3-Supported Ni Catalyst

Meso-porous Al₂O₃-supported Ni catalysts exhibited the highest activity, stability and excellent coke-resistance ability for CH₄ reforming with CO₂ among several oxide-supported Ni catalysts (meso-porous Al₂O₃ (Yas1-2, Yas3-8), -Al₂O₃, -Al₂O₃, SiO₂, MgO, La₂O₃, CeO₂ and ZrO₂). The properties of deposited carbons depended on the properties of the supports, and on the meso-porous Al₂O₃-supported Ni catalyst, only the intermediate carbon of the reforming reaction formed. XRD and H₂-TPR analysis found that mainly spinel NiAl₂O₄ formed in meso-porous Al₂O₃ and -Al₂O₃-supported catalysts, while only NiO was detected in -Al₂O₃, SiO₂, CeO₂, La₂O₃ and ZrO₂ supports. The strong interaction between Ni and meso-porous Al₂O₃ improved the dispersion of Ni, retarded its sintering and improved the activated adsorption of CO₂. The coking reaction via CH₄ temperature-programed decomposition indicated that meso-porous Al₂O₃-supported Ni catalysts were less active for carbon formation by CH₄ decomposition than Ni/-Al₂O₃ and Ni/-Al₂O₃.     

Spatial distribution of silica fillers in phase-separated rubber blends investigated by three-dimensional elemental mapping

The distribution of nano-sized silica in binary rubber blends is characterized by scanning transmission electron microscopy (STEM) tomography combined with energy dispersive X-ray spectrometry (EDX). 3D distribution of silica is visualized by STEM-EDX tomography with the tilt-series of silicon elemental maps, while the phase-separated morphologies of polyisoprene rubber (IR) and styrene-butadiene rubber (SBR) are visualized by STEM-tomography in high-angle-annular-dark field (HAADF) mode. The combination of STEM-EDX and STEM-HAADF tomography enables us to determine the distribution of silica between the two rubber phases quantitatively even with high contents of silica up to 70 phr (weight parts per hundred rubber). It is found that silica is preferentially distributed in the SBR phase, but it is also distributed in the IR phase when the IR fraction in the total rubber components is higher than 40 wt%. The preferential distribution of silica in the SBR phase improves the dispersion of the IR domains. This is the first use of this technique for a multicomponent polymer system, showing the advantage to characterize the complicated multicomponent polymer composite morphologies.