Decomposition of Mullite by Silica Volatilization

Thermal decomposition of mullite into corundum was investigated using a high-temperature X-ray single-crystal camera equipped with a gas-flame furnace and by scanning electron microscopy and electron probe microanalysis (EPMA). When heated to ∼1750°C, mullite decomposed to corundum by the liberation of the SiO₂ component with topotaxial relations of:

• (1) 

  (310)_mull∥(001)_cor; [001]_mull∥[110]_cor
• (2) 

  (130)_mull∥(001)_cor; [001]_mull∥[110]_cor
• (3) 

  (110)_mull∥(001)_cor; [001]_mull∥[110]_cor

Thus, it was considered that, when mullite decomposed into corundum, their oxygen close-packed planes were almost preserved. The SEM photographs showed that the crystals of the developed corundum are prismatic and ∼5 μm wide. The EPMA showed that the phase boundary between mullite and developed corundum is discontinuous.     

The Influence Analysis that a Phase Characteristic of the High‐Level Earthquake Gives to Vibration Response Characteristic of the 550‐kV Disconnectors

We developed the 550‐kV disconnectors that strengthened earthquake proofing by the addition of the damper unit and weight reduction of conductive part based on the damage of the 550‐kV disconnectors by the Great East Japan earthquake (March 11, 2011) and inspected the earthquake proofing performance by shake table test. In shake table test, we performed the test by the artificial seismic wave that varied in phase characteristic in addition to the test by resonance method. And, in a high‐level earthquake area, we analyzed it about the influence that a phase characteristic of the artificial seismic wave gave to stress to occur in disconnectors. As a result, it is thought that the stress to occur in disconnectors is decided by a primary natural frequency basically because a bending strain to occur to the disconnectors in the time when the resonance frequency ingredient becomes the big acceleration response value grows big. But, on a particular phase condition, it was confirmed that the bending strain to occur in disconnectors might grow big conspicuously. As for this, the possibility is thought about by influence of higher natural frequency doing superposition.     

Computed tomographic evaluation of gas hole formation and structural quality in Gouda‐type cheese

Computed tomography (CT) was performed on Gouda‐type cheese during ripening to evaluate gas hole formation and structural quality. The cheese was exposed to different ripening conditions, including variations in ripening temperature and concentration of butyric acid bacteria. Computed tomography images were obtained every 2 weeks for 16 weeks to assess the volume, shape and location of gas holes. The results demonstrate that CT makes the nondestructive monitoring of cheese gas hole formation and evaluation of the structural features of cheese possible throughout the ripening period.     

Parameter identification of distributed parameter systems in the presence of measurement noise

A new approach to recursive parameter identification of second-order distributed parameter systems in the presence of measurement noise under unknown initial and boundary conditions is proposed. A two-dimensional low-pass filter is introduced to pre-filter the observed data corrupted by measurement noise. The low-pass filter is designed in the continuous time-space domain and discretized by bilinear transformation. Thus a discrete estimation model of the system under study is easily constructed with filtered input-output data for recursive identification algorithms. The recursive least squares method is still efficient in the presence of low measurement noise if the filter parameters are designed so that the noise effects are reduced sufficiently. Using filtered input data as instrumental variables, a recursive instrumental variable method is also presented to obtain consistent estimates when the digital low-pass filters are not designed successfully or when the output data is corrupted by high measurement noise. Illustrative examples are given to demonstrate the applicability of the proposed methods.     

Investigation of Water Tree Degradation in Dry‐Cured and Extruded Three‐Layer (E‐E Type) 6.6‐kV Removed XLPE Cables

Dry‐cured and extruded three‐layer (E‐E type) 6.6‐kV cross‐linked polyethylene (XLPE) cables were introduced into electric power systems more than 30 years ago, but they do not experience failures because of water tree degradation. Also, the degradation index of water treeing for these cables has not been established. Therefore, investigating results of residual breakdown voltage and water tree degradation of these cables will help us plan for cable replacement and determine water tree degradation diagnosis scheduling, and will be fundamental data for cable lifetime evaluation. In this study, the authors measured the ac breakdown voltages of dry‐cured and E‐E type 6.6‐kV XLPE cables removed after 18 to 25 years of operation and observed the water trees in their XLPE insulation. As a result, it was observed that breakdown voltages were larger than the maximum operating voltage (6.9 kV) and the ac voltage for the dielectric withstanding test (10.3 kV). Water trees were mainly bow‐tie water trees and their maximum length was approximately 1 mm. Although the number of measured cables was limited, the lifetime of this type of cable was estimated to be approximately 40 years, even experiencing water immersion.     

Effects of Microwave Heating on Lipoxygenase and Trypsin Inhibitor Activities, and Water Absorption of Winged Bean Seeds

Lipoxygenase and trypsin inhibitors in dry whole winged bean seeds were completely inactivated after microwave heating for 3.0 and 5.0 min, respectively. The soaking of the seeds, prior to microwave heating, considerably decreased the heating times needed to inactivate lipoxygenase and trypsin inhibitor. Furthermore, microwave heating was effective in increasing the rate of water absorption of the seeds.     

国与家之间：论上海里弄街区日常生活空间的断裂与统一

以当代城市普遍涌现的社会隔离现象为切入点,引出上海里弄街区中出现的毗邻隔离问题,并以此展开毗邻隔离与居住混合辩证关系的论述。指出,物理空间的接近并不能带来社会层面的混合。在对历史向度的里弄变迁进行梳理之后,选取虹口港里弄街区的日常生活空间作为研究对象。通过对社区认知边界的测定和生活空间利用模式的分析,对里弄街区中有关"三个世界"的日常生活空间异化与毗邻隔离展开讨论。最后,在明确日常生活空间社会意义的基础上,从国与家两个维度对社区融合视角下的日常生活空间组织做出总结。认为基于物质层面的日常生活空间维系,与社会层面的社区参与和居民赋权,是当前语境下上海里弄街区修补毗邻隔离问题,实现公共空间统一的必由之路。     

两相流射流的最小半径数值研究

针对大气中水射流的动态特性,使射流形状、特性难以精确预测,提出了判定射流缩流截面的准则,进行了多工况下自由射流非定常两相流数值解析,对射流特别是两相流分界面区域的能量分布及涡度进行了分析,根据VOF法对射流自由表面进行数值预测的结果,获得了射流缩流半径、射流膨胀率等重要参数,并对自由射流尺度效应进行了探讨。     

Crystal Structure and Defects of Ordered (Pb1-xCax)TiO3

Crystal structure and defects of ordered ((Pb_{1- x} Ca _x )TiO₃ ceramics have been investigated by transmission electron microscopy. The structure is determined to be tetragonal, belonging to point group 4 mm . Pb and Ca are in an ordered fcc arrangement on the A sites. In addition to the chemical ordering, there is ordering due to atomic shuffling or what has been referred to as electrical ordering. Two distinct sets of planar defects are observed in the same region. One set of planar defects are identified as antiphase boundaries that are the results of chemical ordering and the other set are displacement boundaries that are the results of electrical ordering.