Vapor absorption by LiBr aqueous solution in vertical smooth tubes

Heat and mass transfer in a falling film vertical in-tube absorber was studied experimentally with LiBr aqueous solution. The presented results include the effect of solution flow rate, solution subcooling and cooling water temperature on the absorption in a smooth copper tube 16.05 mm I.D. and 400 mm long. The experimental data in the previous report for a 1200-mm-long tube was also re-examined and compared. It was demonstrated by the observation of the flow in the tube that the break down of the liquid film into rivulets leads to deterioration of heat and mass transfer at lower film Reynolds number or in longer tubes. An attempt to evaluate physically acceptable heat and mass transfer coefficients that are defined with estimated temperature and concentration at the vapor–liquid interface was also presented.     

Suppression of photo-induced dilation in cyanide treated hydrogenated amorphous silicon films

Effects of cyanide (CN) treatment with hydrogenated amorphous silicon (a-Si:H) films have been investigated. The decrease of ΔV/V was observed in cyanide treated a-Si:H films and the successive thermal annealing at 200°C after CN treatment induced the further reduction of the ΔV/V. XPS spectra show the indirect evidence that the cyanide species is present within 10 nm from the hydrogenated amorphous silicon surface. The results of CN treatment with a-Si:H solar cells are demonstrated.     

Preparation of spinel-type ferrite thin films by the dip-coating process and their magnetic properties

Films of spinel-type ferrite, MFe₂O₄ (M=Ni, Co, Mg, Li_0.5Fe_0.5) have been prepared by a dip-coating method from the sol-gel process. Ferric nitrate, nickel nitrate, cobalt nitrate and lithium nitrate were used as raw materials, and glycerol and formamide were used as solvents. A film was prepared by dipping a silica glass plate. The spinel-type ferrite was obtained by heat-treatment at 700–900°C for 2 h in air. The film thickness was about 0.8 m. The saturation magnetization, _r, of the film and powder with composition 50NiO·50Fe₂O₃ was 196 emu cm^–3 and 29.1 emu g^–1, respectively, and the coercive force,H _c, was 140 and 95 Oe, respectively, after heat-treatment at 800°C for 2 h. In particular, the films were shown to have a much largerH _c than the powder. The grain growth of spinel ferrite may be subject to restriction because it is in progress above an amorphous base-plate. The crystals are therefore aligned with the base-plate and have uniaxial anisotropy.     

Conductivity of the one-dimensional quantum sine-gordon system (g 2 = 4π) with impurities

We have considered the behavior of the conductivity or the dielectric function of the one-dimensional (1-D) quantum sine-Gordon system (g² = 4) for two models of impurities. We have used a Fermi-Bose relation and a self consistent t-matrix approximation. As for the conductivity at zero temperature, it appears when the concentration of impurities becomes larger than the critical concentration of impurities. It shows the linear increase near the critical concentration. As for the dielectric constant, its behavior is model dependent. We have numerically calculated the frequency dependence of the conductivity at zero temperature. The real part shows the second order increase near the critical frequency. The imaginary part shows the linear decrease from the origin.     

Model-less visual servoing using modified simplex optimization

This article describes a robot positioning task with respect to a static target by visual servoing. The vision system is uncalibrated, and the kinematic model of the robot may be totally unknown. The displacements of the robot at joint level are generated in real time in order to minimize the objective function. The objective function includes the quadratic error between the current and the desired target images. A simplex method is used to minimize the objective function, and a Newton-like method is also used near convergence. We successfully validated this method with simulations under the graphic library OpenGL. This work was presented in part at the 10th International Symposium on Artificial Life and Robotics, Oita, Japan, February 4–6, 2005     

Nickel sulphide-induced rhabdomyosarcomata in rats

Fifty-nine Fischer rat tumors and eleven Hooded rat tumors induced by intramuscular injection of Ni3S2 were examined and their histopathologic and cytologic characteristics studied. Nine out of eleven Hooded rat tumors metastasized whereas 15 out of 59 Fischer rat tumors metastasized within 30 days. Histopathological characterization of the Ni3S2-induced tumors was made according to their preponderant cellular constitution. They were grouped into six types: well-differentiated rhabdomyosarcomas, poorly-differentiated rhabdomyosarcomas, embryonal rhabdomyosarcomas, mesenchymal tumors, leiomyosarcoma-like tumors and fibrosarcoma-like tumors. Forty-seven of total of 70 were rhabdomyosarcomas. Tumors with shorter latent periods in Fischer rats and tumors with fleshy and soft texture demonstrated a higher incidence of metastases.     

Bupivacaine-induced seizure after accidental intravenous injection, a complication of epidural anesthesia

A technique is presented to eliminate the residual gradient more completely after removing the main pulmonary band at the time of primary repair of ventricular septal defect. The band and underlying pulmonary artery are circumferentially excised, except for a small posterior part, and pulmonary artery is reanastomosed.