Depicting the role of gas-solid interactions on the hydrodynamics of converging pneumatic riser

The understanding of the flow characteristics and effect of gas-solid interactions in pneumatic risers is fundamental to investigate to ensure effective design cost-effective operation. Thus, to understand the effect of gas-solid interactions on the hydrodynamics of newly proposed conversing risers, this study mainly focused on predicting pressure drop in the dilute phase pneumatic conveying system. The experiments were conducted in a converging riser having a convergence angle of 0.2693°. Various solid particles such as sago, black mustard, and alumina have been considered to study the effect of particle sizes and density on the pressure drop. The experimental outcomes indicate that the total pressure drop increases with an increase in the solid density and gas mass flow rate. Moreover, smaller particle sizes are also increased the pressure drop. An empirical correlation is developed for the prediction of total pressure drop ΔP_T in converging pneumatic riser via dimensional analysis. All dependent variables such as particle and air density, drag force, acceleration due to gravity, the mass flow rate of air and particle, the diameter of particle and converging riser, the height of converging riser were considered to develop the empirical correlation. The established relationship is tested, and experimental data have been fitted for its validation. The estimated relative error of less than 0.05 proved the significance of the developed correlation. Hence, it can be stated that the established relationship is useful in studying the effects of various parameters on the pressure drop across the length of the conversing riser.     

Imperative role of electron microscopy in toxicity assessment: A review

Electron microscope (EM) was developed in 1931 and since then microscopical examination of both the biological and non-biological samples has been revolutionized. Modifications in electron microscopy techniques, such as scanning EM and transmission EM, have widened their applicability in the various sectors such as understanding of drug toxicity, development of mechanism, criminal site investigation, and characterization of the nano-molecule. The present review summarizes its role in important aspects such as toxicity assessment and disease diagnosis in special reference to SARS-COV2. In the biological system, EM studies have elucidated the impact of toxicants at the ultra-structural level in various tissue in conformity to physiological alterations. Thus, EM can be concluded as an important tool in toxicity assessment and disease prognosis.     

Study of crystal structure,dielectric, magnetic and magnetoelecrtic properties of xCoFe2O4-(1-x)Na0.5Bi0.5TiO3 composites

Multiferroic composites of spinel ferrite and ferroelectric xCoFe₂O₄ – (1-x)Na_0.5Bi_0.5TiO₃ (with x = 0.10,0.30,0.50) were efficiently prepared by standard solid state reaction mechanism. X-ray diffractometer was used to analyze crystal structure of the prepared composites. The observed XRD patterns of the composites comprise peaks of both the phases i.e. ferrite and ferroelectric, with no sign of secondary peaks. Rietveld refinement of XRD data further confirms the coexistence of these two phases with cubic (Fd3m) and rhombohedral (R3c) symmetry corresponding to ferrite and ferroelectric phase respectively. The 3-dimensional overview of crystal structure of pure CoFe₂O₄ and Na_0.5Bi_0.5TiO₃ and of composite 0.50CoFe₂O₄?0.50Na_0.5Bi_0.5TiO₃ is generated by using refined parameters. The dielectric constant (ε´) and dielectric loss (tanδ) values were recorded as a function of frequency ranging from 100?Hz to 7?MHz and at different temperatures. Both ε´ and tanδ follow dispersion pattern at lower frequencies while show frequency independent behavior at higher frequencies. The magnetic evaluation carried by analyzing M-H hysteresis loop reveals the ferrimagnetic characteristics of these composites. The highest value of magnetic moment is 1.12μ_B observed for composite 0.50CoFe₂O₄ – 0.50Na_0.5Bi_0.5TiO_3. Magnetoelectric (ME) voltage coefficient (α) was also demonstrated to observe the interaction between ferrite and ferroelectric phases. The highest value of α (72.72μV/Oe cm) is obtained for low ferrite composition 0.10CoFe₂O₄ – 0.90Na_0.5Bi_0.5TiO₃, which suggests the dependence of magnetoelectric response on the resistivity of the composites.     

An efficient verifiable (t,n)-threshold secret image sharing scheme with ultralight shares

Multimedia Tools and Applications - A secret sharing scheme partitions a secret into a set of shares and distributes them among the eligible participants, with each participant receiving one share...     

Significantly high electromagnetic shielding effectiveness in polypyrrole synthesized by eco-friendly and cost-effective technique

A facile and eco-friendly synthesis of polypyrrole from monomer pyrrole using nominal amount of ferric chloride hexahydrate (FeCl₃.6H₂O) oxidant in aqueous solution by chemically oxidative polymerization method has been reported. The use of aqueous solvent and ferric chloride hexahydrate salt in polypyrrole synthesis have an eco-friendly route favorable for the production of polypyrrole in large quantities. The synthesized polypyrrole samples exhibit good electrical conductivity (2 S/cm) and yield of 80% for reaction time of 8 hr at 5°C. Quality and properties of polypyrrole samples have been thoroughly investigated with varying reaction time and temperature while other synthesis parameters like molar ratio of oxidant to monomer, oxidant concentration, and solvent were kept constant. X-ray diffraction analysis of polypyrrole with a shorter reaction time shows the presence of iron oxide (Fe₂O₃) peaks. The complete reaction may not occur at shorter reaction times due to which residual ferric ions converted into Fe₂O₃. X-ray photoelectron spectroscopy measurement of polypyrrole also confirms the formation of Fe₂O₃. Appropriate selection of reaction time and temperature produced pure phase polypyrrole with high yield and good conductivity. Synthesized polypyrrole by our eco-friendly and cost-effective technique exhibits prominent electromagnetic shielding effectiveness value of 30 dB in the X-band (8–12 GHz).     

Pd–NPs@MMT–K10 Catalysis of Suzuki–Miyaura Cross-coupling Reaction: In Situ Generation and Ex Situ Use

Catalysis Letters - Due to high surface area and low swelling property, Montmorillonite–K10 (MMT–K10) has been gaining widespread applications in heterogeneous catalysis as a material...     

pH‐sensitive crosslinked guar gum‐based superabsorbent hydrogels: Swelling response in simulated environments and water retention behavior in plant growth media

Crosslinked guar gum‐g‐polyacrylate (cl‐GG‐g‐PA) superabsorbent hydrogels were prepared to explore their potential as soil conditioners and carriers. The hydrogels were prepared by in situ grafting polymerization and crosslinking of acrylamide onto a natural GG followed by hydrolysis. Microwave‐initiated synthesis under the chosen experimental conditions did not exhibit any significant improvement over the conventional technique. The optimization studies of various synthesis parameters, namely, monomer concentration, crosslinker concentration, initiator concentration, quantity of water per unit reaction mass, particle size of backbone, and concentration of alkali were performed. The hydrogels were characterized by wide‐angle X‐ray diffraction, scanning electron microscopy, Fourier transform infrared spectroscopy, and solid‐state ¹³C‐NMR spectroscopy. Swelling behavior of a candidate hydrogel [GG‐superabsorbent polymer (SAP)] in response to external stimuli, namely, salt solutions, fertilizer solutions, temperature, and pH, was studied. The GG‐SAP exhibited significant swelling in various environments. The effect of GG‐SAP on water absorption and the retention characteristics of sandy loam soil and soil‐less medium were also studied as a function of temperature and moisture tensions. The addition of GG‐SAP significantly improved the moisture characteristics of plant growth media (both soil and soil‐less), showing that it has tremendous potential for diverse applications in moisture stress agriculture. © 2014 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2014 , 131, 41060.     

Performance enhancement and energy reduction using hybrid cryogenic distillation networks for purification of natural gas with high CO2 content

A novel concept of hybrid cryogenic distillation network has been explored which maximizes the benefits of both desublimation or solid-vapor based separation as well as distillation or vapor-liquid equilibrium based separation during the separation of carbon dioxide from methane or natural gas. Process network synthesis has been performed for four case studies with high carbon dioxide (72 mole%) and medium carbon dioxide (50 mole%) natural gas feed streams. The benefits of optimal locations for cryogenic packed beds were investigated. A conventional cryogenic network consisting of multiple distillation columns with butane as additive for extractive distillation was also studied and presented in this paper. Process modeling of cryogenic distillation network with MESH equations was attempted using an integrated dual loop (C+3) convergence and the results were compared with Aspen Plus simulator for benchmarking. The prediction of solidification region was employed using experimental data from literature to avoid solidification regions in the column. The proposed hybrid cryogenic distillation network showed promising potential for energy and size reduction.