Phase formation,structure and properties of light-weight aluminosilicate proppants based on clay-diabase and clay-granite binary mixes

One of the drawbacks of fusible clays is the narrow sintering interval due to a sharp increase in the amount of iron-silicate melt at a temperature of 1000–1100 °C, which hardens in the form of a glass phase upon cooling. This leads to a relatively low mechanical strength of the calcined samples and causes the danger of melting the granular material surface from such clays during the firing process. To increase the strength of samples of fusible clays, the influence of diabase and granitoid rocks was considered. It was found that the strengthening effect of diabase and granitoid rock additives in an amount of 20–50% in a mixture with fusible clay is due to an increase of total content of the crystalline phase (mullite, cristobalite and residual quartz) from 18–20% in clays without additives to 22–28 % - in mixtures with diabase and to 28–34% - with granitoid additives) at a temperature of 1050–1100 °C. This increase is due to the activation of synthesis processes of secondary mullite and crystallization from alkali-rich feldspar melt of amorphous silica, released from the structure of clay minerals. The established influence of the igneous rocks used made it possible to develop compositions and propose process flow sheet for producing aluminosilicate proppants based on fusible clays. The use of granitoid and diabase rocks in an amount of 20–70% with fusible clays produces lightweight aluminosilicate proppants with bulk density of 1.40–1.46 g/cm³ at temperature range of 1050–1100 °C, which can endure destructive pressures up to 34.5–52 MPa.     

油页岩矿物质催化半焦燃烧特性及机理

利用微型流化床反应分析仪（MFBRA）研究了油页岩矿物质催化半焦燃烧特性，重点考察了半焦内部矿物质和外部页岩灰床料对半焦燃烧的催化作用，揭示了流化床反应器中半焦燃烧过程和机理。结果表明：内部矿物质和外部床料对半焦燃烧均具有明显催化作用，而两者共同催化效果最为显著。矿物质中CaO和Fe₂O₃对半焦燃烧具有催化活性，CaO催化作用强于Fe₂O₃。油页岩半焦燃烧反应活化能在60.41~78.97 kJ/mol之间，矿物质的催化作用会明显降低反应活化能。流化床反应器中，矿物质对半焦燃烧的催化作用主要表现在四个反应，即：挥发分裂解和燃烧、半焦表面炭燃烧、半焦内部炭燃烧以及一氧化碳燃烧。     

A design of experiments investigation into dry separation using a Knelson Concentrator

Enhanced gravity, or centrifugal, separators have revolutionised gold processing over the past decades, significantly increasing the recovery of fine (−100 μm) free gold. One of the main drawbacks of centrifugal gravity concentrators is the large volume of water required (even if it is all recycled). With water becoming an ever increasingly important “commodity”, reducing this is of importance both from an environmental and a monetary point of view. This work investigated operating a laboratory scale Knelson Concentrator with a dry feed and using air as the fluidising medium. The feed used was a synthetic mixture of tungsten and quartz, used to mimic a gold ore. The response surface method and central composite design techniques were used to design the experiments and to model the results, with the experimental variables being the bowl speed (G-Level), air fluidising pressure and the feed rate. The models corresponded well to the experimental results, indicating that for this experimental setup, the optimal conditions were a bowl G-Level of 40 G, a feed rate of 220 g/min and an air fluidising pressure of 8 psi.     

Experimental study on the permeability and self-healing capacity of geosynthetic clay liners in heavy metal solutions

Geosynthetic clay liners (GCLs), which have a very low permeability to water and a considerably high self-healing capacity, are widely used in liner systems of landfills. In this study, a series of experimental tests were carried out under complex conditions on typical commercial GCLs from China. In particular, the effects of pH values and lead ions (Pb²⁺) were tested in addition to other factors. The swelling properties of natural bentonite encapsulated between geotextile components in the GCLs were tested first. The swelling capacity was reduced rapidly at pH values < 3 and concentrations of Pb²⁺ >40 mM. Permeability tests on GCLs with different concentrations of lead ions were then performed by using the self-developed multi-link flexible wall permeameter, and data showed that increases in lead ion concentrations greatly improved the permeability. Finally, self-healing capacity tests were conducted on needle-punched GCLs under different levels of damage. Results showed that the GCLs have a good self-healing capacity with small diameter damage holes (2 mm, close to three times the original aperture), but with a damage aperture larger than 15% of the sample area, the self-healing capacity could not prevent leakage; hence, in certain situations it will be necessary to repair the damage to meet the anti-seepage requirement.     

四川某稀土矿选矿试验研究

针对四川某稀土矿选矿工艺存在的稀土回收率低的问题，开展了一系列选矿试验研究。试验结果表明，在矿浆质量浓度为30%，粗选NaOH用量为600g/t，水玻璃用量为3000g/t，EF1106用量为3500g/t，起泡剂用量为60g/t情况下，采用一粗、三精、两扫、中矿按顺序返回的选矿流程，可获得稀土REO的品位和回收率分别为66.32%和79.88%的稀土浮选精矿。与该选厂的生产指标相比，稀土回收率提高了13.93%。     

基于萤石溶解/表面转化的含钙矿物表面定向调控浮选技术及机理研究

研究了萤石在白钨矿和方解石表面溶解和转化的可能性, 发现萤石可以在特定的捕收剂体系下作为抑制剂实现含钙矿物的浮选分离。浮选实验结果表明, 萤石作为抑制剂, 在白钨矿和方解石的浮选中, 用量小、作用效果明显; 动电位检测结果证实了萤石能明显降低方解石的动电位, 但对白钨矿基本没有影响; XPS检测结果证明了萤石对方解石的作用主要在于对Ca-O键能的减弱和Ca-F基团的生成, 即在方解石表面生成CaF2膜; AFM检测则可直观观察到方解石表面经过萤石处理之后出现明显的起伏, 印证了离子的侵蚀与CaF₂膜的生成。     

Critical state model for structured soil

Structure is an evident determinant for macroscopic behaviors of soils. However, this is not taken into account in most constitutive models, as structure is a rather complex issue in models. For this, it is important to develop and implement simple models that can reflect this important aspect of soil behavior. This paper tried to model structured soils based on well-established concepts, such as critical state and sub-loading. Critical state is the core of the classic Cam Clay model. The sub-loading concept implies adoption of an inner (sub-loading) yield surface, according to specific hardening rules for some internal strain-like state variables. Nakai and co-workers proposed such internal variables for controlling density (ρ) and structure (ω), using a modified stress space, called t_ij. Herein, similar variables are used in the context of the better-known invariants (p and q) of the Cam Clay model. This change requires explicit adoption of a non-associated flow rule for the sub-loading surface. This is accomplished by modifying the dilatancy ratio of the Cam Clay model, as a function of the new internal variables. These modifications are described and implemented under three-dimensional (3D) conditions. The model is then applied to simulating laboratory tests under different stress paths and the results are compared to experiments reported for different types of structured soils. The good agreements show the capacity and potential of the proposed model.     

硫酸铵法利用中低品位锂瓷土矿制备碳酸锂技术研究

针对江西宜丰地区氧化锂质量分数<2.0%以下中低品位锂瓷土矿,研究了硫酸铵法提取碳酸锂技术路线。首先,利用二步焙烧工艺,有利于脱氟、提高锂浸出率,并且能够有效防止结窑现象发生。在浸出液除杂过程中,采用成矾除铝的方法将大量溶出的铝离子转变为KAl（SO₄）₂·12H₂O、NH₄Al（SO₄）₂·12H₂O等有价值复盐,规避了传统石膏法产生的大量固废,有70%的铝离子被转变为矾盐晶体,同时带出大量的结晶水,减轻后续浓缩压力,对比传统的石膏法产生大量固废而言,其优点是显而易见的。碳化反应产品的XRD以及氧化锂含量分析表明,碳酸锂的纯度达到99%以上,全程锂收率为50%~60%。作为提锂实验对比,采用宜春414矿锂质量分数为4.0%的锂云母,由于414矿样中铝的相对含量更低,导致相同的除杂难度下得到的414矿样中浸出液锂离子浓度更高,浓缩倍数更小,414矿样的锂回收率更高。实验结果表明,中低品位锂瓷土提锂的工艺规律,通过适当改变参数,能够应用于难度更低的高品位的锂云母提锂过程。     

王庄油田粘土矿物转化对储层的影响

王庄油田是水敏性稠油油藏的典型代表，其水敏性在热采过程中的变化直接关系到油田开发方式的选择。针对这一问题，从直接影响水敏性变化的储层粘土矿物入手，在模拟地层环境的基础上通过室内高温高压静态和动态物模实验，并结合X衍射、扫描电镜、元素分析、粒度检测等多种分析测试手段，研究了粘土矿物在100-300℃之间的变化过程，从而找到水敏性的变化规律，进而从机理上解释了渗透率的变化原因，为数值模拟和开发方案制定提供室内研究依据。