Event-triggered variable horizon Supervisory Predictive control of hybrid power plants

The supervision of a hybrid power plant, including solar panels, a gas microturbine and a storage unit operating under varying solar power profiles is considered. The Economic Supervisory Predictive controller assigns the power references to the controlled subsystems of the hybrid cell using a financial criterion. A prediction of the renewable sources power is embedded into the supervisor. Results deteriorate when the solar power is unsteady, owing to the inaccuracy of the predictions for a long-range horizon of 10 s. The receding horizon is switched between an upper and a lower value according to the amplitude of the solar power trend. Theoretical results show the relevance of horizon switching, according to a tradeoff between performance and prediction accuracy. Experimental results, obtained in a Hardware In the Loop (HIL) framework, show the relevance of the variable horizon approach. Power amplifiers allow us to simulate virtual components, such as a gas microturbine, and to blend their powers with that of real devices (storage unit, real solar panels). In this case, fuel savings, reaching 15%, obtained under unsteady operating conditions lead to a better overall performance of the hybrid cell. The overall savings obtained in the experiments amount to 12%.     

1.8 V千兆以太网接收器模拟前端预均衡电路

介绍了一种用于1.8 V电源电压下的千兆以太网接收器的模拟前端预均衡电路。电路分为三个部分:预处理电路、基带漂移补偿电路和可变增益放大电路,主要实现回波消除、基带漂移补偿和电路增益自动控制等功能。为了与百兆模式兼容,提出了一种预处理电路。仿真结果表明,该电路可以很好地实现回波消除的功能,能够对由于基带漂移引起的信号失真给以补偿,可以提供16级不同的增益,并进行频率补偿。电路采用0.18μm标准CMOS工艺实现。     

烟气轮机特殊状态下的保护

从烟气轮机超速的极限开始 ,分别按照阀门的关闭时间为 1 .5s和 6s的两种典型状态 ,对烟机在联轴节断裂等特殊工况下的超速情况进行了分析。最后 ,对烟气轮机在特殊工况下的保护提出了建议。     

高压变频器在煤气加压机中的应用

2005年11月份邯郸钢铁厂8万煤气柜外送煤气加压机采用高压变频技术改造。其原因是该加压机外送量波动较大，采用普通阀门调节打回流，将会浪费大量电能，采用变频技术改造后，节能效果非常明显。     

Stabilization of inter-area and/or oscillatory modes in large-scale power system by voltage impedance power system (VIPS) apparatus based on decentralized control scheme

New technologies such as power electronics have made it possible to change continuously the impedance of a power system not only to control power flow but also to enhance stability. A power system incorporating a variable impedance apparatus such as a variable series capacitor (VSrC) and high-speed phase shifter (HSPS) is called VIPS (Variable Impedance Power System) by the authors. This paper proposes a novel control method of VIPS apparatus such as VSrC and HSPS installed at an interconnecting point for stabilizing inter-area unstable and/or oscillatory modes. The proposed design method of the control system is a kind of hierarchical decentralized control method of a large-scale power system based on a Lyapunov function. Under the proposed control scheme, each subsystem can be stabilized independently by local controllers such as AVR, speed governor and PSS, and then the whole interconnected system can be stabilized by VIPS apparatus taking into account interactions between subsystems. The effectiveness and robustness of the VIPS apparatus control are shown by numerical examples with model systems including a large-scale power system.     

变井储系数的确定方法及其在反褶积分析中的应用

中针对变井储试井分析问题，给出了确定变井储系数及计算续流量的方法，并用反褶积分析积分析方法解释了未出现径向流的早期测压数据，给出了解决早期试井资料分析问题的有效方法。     

热泵型一拖二变频空调器的开发

将国内外最新的变容量控制、电子膨胀阀控制、室内外机独立解耦控制和智能旁通除霜控制等控制方法与计算机仿真优化设计应用于热泵型变频一拖二空调系统的开发,给出了系统的原理、结构,并进行了实验研究。结果表明,系统运行稳定可靠,性能系数达到国内同类产品的领先水平,并超过了国家单元分体热泵空调器的节能标准。也为多元变容量空调系统奠定了理论与实验基础。     

A scheme to randomly generate surface dust points for the 3D complex variable boundary element method (CVBEM)

A scheme to randomly generate dust points on the surface of a three-dimensional (3D) object is proposed. This scheme will potentially eliminate the bias of a density of points which are approximately equally spaced on the surface, as well as eliminate possible weighting requirements for areas of higher density. This method has the potential to reduce computational effort, as fewer points might be required to define the surface area. The global trial function vector can be assigned to these dust points and then entered into the complex variable boundary element method (CVBEM) commercial code. This scheme can be applied to each piece of a system that is comprised of a connected multiple geometry. A noticeable benefit of this approach is that the same problem can be studied several times, using a new random distribution of surface points each time. The smallest error can then be determined and that run selected. The Mathematica code used to generate the scheme is attached as an appendix.     

中央空调系统水泵变频应用中存在的几个问题

本文分析了中央空调系统中水泵变频及其运行管理方面所存在的影响节能效果与运行管理质量的几个主要问题 ,提出了相应的解决办法 ,并对中央空调系统水泵变频决策与运行管理提出了几点建议。