花岗岩的黑火药爆炸切割技术

本文介绍了爆炸切割与光面爆破的区别；系统阐述了石材切割技术方案选择、黑火药爆炸切割参数的确定、切割工艺、起爆技术及切割实例。     

Ceramics composites from iron ore tailings and blast furnace slag

The search for materials and methods capable of reducing human impacts on the environment is of utmost importance nowadays. This study's primary purpose was to analyze the technical feasibility of ceramic composites production utilizing Fundão Dam's Iron Ore Tailings (IOT), Blast Furnace Slag (BFS) from charcoal, and Foundry Sand (FS) as partial substitutes for the traditional raw materials – sand and clay – for application in building industry materials. The composites were molded in rectangular specimens and fired at temperatures of 900, 950, 1000, 1050, and 1200 °C. The developed materials were analyzed and characterized by X-Ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Energy Dispersive Spectroscopy (EDS), Thermogravimetry (TGA), and Differential Thermal Analysis (DTA). The obtained materials had flexural strength modulus of up to 12.19 MPa, water absorption ranging from 2 to 22%, linear shrinkage ranging from 0.02 to 6.50%, and apparent density ranging from 2.03 to 1.63 g/cm³. The study of the internal structure formation process revealed the formation of amorphous structures in the composites. The results demonstrated that these waste materials may be jointly used in construction materials, contributing to the reduction of natural resource extraction, besides enabling their correct disposal, minimizing environmental impacts, and improving the life quality of the surrounding communities.     

碱度对包钢高炉渣物理性能的影响

摘要：为探明二元碱度对包钢高炉渣物理性能的影响机理，基于包钢7号高炉渣化学组成，添加纯试剂CaO、SiO2调整炉渣的二元碱度。通过实验研究二元碱度对包钢7号高炉渣熔化温度、黏度和熔化性温度的影响规律；同时采用Factsage70热力学软件，计算了不同碱度下炉渣的液相线温度和热焓值。结果表明：随着碱度升高，炉渣熔化温度不断升高，黏度和熔化性温度先降低后升高，碱度在1.1～1.3之间，碱度每提高0.1，炉渣半球温度提高4.67℃，软熔区间为3.33～4.60℃；碱度在1.1～1.4之间，1450℃以上炉渣黏度均低于0.5Pa·s，流动性良好；Factsage7.0计算结果表明：随着碱度的升高，炉渣的液相线温度不断升高，热焓值不断降低。综合考虑碱度对包钢炉渣熔化温度、熔化性温度、热焓和黏度的影响规律，建议包钢高炉渣的碱度应控制在1.1～1.3之间。     

Evaluation of air blast parameters in block cave mining using particle flow code

Air blast, a sudden mass movement of air, can occur in underground mining system where caving develops an extensive mass of unsupported rock spanning a large void. Air blast can result in injury to mine personnel, damage to equipment or disrupts mine operation. Evaluation of air blast parameters is, therefore, an essential part to develop strategies to mitigate the hazard. The properties of a muckpile or a caved zone are significant factors affecting the magnitude of air blast in particular on the undercut and extraction levels. This research investigates the effect of muckpile properties on air flow using the numerical code, PFC2D. The critical parameters such as thickness, block size and porosity (swell factor) of the muckpile have been studied to quantify how much they could change the magnitude of air pressures and velocities while the air flows through the muckpile. It was found that the porosity of the muckpile is the most effective parameter on the magnitude of air blast and by designing a thick layer of blasted rock with low porosity in the caved zone, the intensity of the air blast can be significantly reduced. The findings of this study can be used to design air blast plugs or bulkheads in order to isolate any potential air blast from the active workings, or to quantify the minimum thickness of the muckpile above extraction levels to manage air blast hazards.     

高炉炉缸凝铁层的组成分析与导热系数测定

摘要：高炉炉缸内衬表面形成稳定的凝铁层将保护高炉炭砖并延长高炉寿命。利用光学数码显微镜观察统计分析高炉凝铁层生产样品，探究不同焦炭体积占比对凝铁层导热系数的影响。利用元素分析（XRF）、X射线衍射分析（XRD）、扫描电镜(SEM-EDS)等手段分析凝铁层的组成，并观察其微观形貌。利用瞬态平面热源法（TPS）测定凝铁层的导热系数，进一步分析其组成与导热系数之间的关系。结果表明,凝铁层由铁、充满铁水的焦炭、石墨碳、少量渣相组成，凝铁层内部没有气隙。凝铁层生产样品的导热系数测定范围为27.21～97.38W/(m·K)，导热系数（λ）与其组成的焦炭面积比（Sc=22%～48%）之间的线性关系为：λ=-257.47Sc +157.65。模拟实验凝铁层的导热系数范围为30.54～53.95W/(m·K)，该值远大于目前数学模型中采用的凝铁层导热系数（2～4W/m·K），随着焦炭粒度的增加，凝铁层的导热系数先增加后减小。凝铁层中导热系数（λ）与焦炭体积分数Vc（Vc=39%～50%）的线性关系为：λ=-80.50Vc +78.56。研究结果进一步明确了凝铁层的物相组成及其导热系数，为高炉长寿的研究指明了方向。     

工程水压爆破在煤层爆破中的应用

通过黑岱沟露天煤矿的工程试验总结了工程水压爆破技术(水土复合填塞炮孔)的原理及在露天煤矿爆破施工中的应用效果。在露天煤矿爆破施工中采用工程水压爆破技术,可以提高煤层爆破的大块率,降低单位立方岩石耗药量,降低爆破气体的温度,同时可以降低煤层爆破失火率、粉尘排放量,有效地控制爆破飞石。     

Counter-intuitive collapse of single-layer reticulated domes subject to interior blast loading

A commercial finite element package, LS-DYNA, was employed to simulate the response of a single-layer reticulated dome to an interior blast. The dome, which was initially stressed by static preloading, encountered an interesting phenomenon namely counter-intuitive collapse, which was found during the blast analysis. The Johnson–Cook constitutive model for mild steel was used to identify different failure modes of the dome for more than 2430 samples. A seemingly counter-intuitive collapse was identified due to dynamic instability. This unusual collapse was explained using total potential curves, and the critical blast load was defined. The effect of different static preloads, which is the other determination factor of counter-intuitive collapse, was investigated. A relationship between collapse and static/dynamic loads was also obtained. The results indicate that single-layer reticulated domes, with large initial stresses, may collapse at lower dynamic loads than expected.     

爆炸冲击波超压加载伪随机网壳的分布规律研究

采用缩比模型爆炸试验与数值仿真相结合的方法,开展了爆炸冲击波超压加载伪随机网壳的分布规律研究。首先,选取具有代表性的某伪随机140面体网壳结构,开展了缩比模型爆炸试验,获得了表面特征测点的冲击波超压数据;之后,对比分析了试验与仿真结果的误差及原因,以试验数据为基础,建立了爆炸冲击波与某伪随机140面体网壳结构相互作用的数值仿真模型,并对空中爆炸和地面爆炸的3种不同距离共6种工况下,网壳结构的特征表面超压作用过程进行了计算和分析,拓展了试验结果;最后,对伪随机网壳表面冲击波超压分布规律进行了研究,并提出了增强网壳结构安全性的防护措施,为伪随机网壳结构抗冲击安全设计提供了参考。结果表明:与传统对称网壳结构相比,伪随机网壳在超压峰值分布规律和作用机制等方面都更为复杂,受到结构伪随机特性的影响,在相似位置表面,超压峰值也有明显差异;网壳迎爆面底部和中部超压峰值与其他部位相比,一般较高;在网壳外一定距离构筑防爆墙和加固网壳中部及底部节点的方法,可提升伪随机网壳结构的抗冲击安全性。