Voltage sag compensation with minimum energy injection by use of a micro‐SMES

This paper presents a method to compensate voltage sags with minimum energy injection for a series‐connected voltage restorer using a micro‐SMES. A circuit for extracting the fundamental symmetrical components from sag voltages and a minimum energy injection algorithm is described. Simulations of voltage sag compensation have been carried out using PSCAD/EMTDC for various faults. The simulation results confirm the validity of the proposed method and show the possibility of reducing the size of energy storage devices. © 2002 Wiley Periodicals, Inc. Electr Eng Jpn, 141(3): 70–80, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10047     

Expectation of LET∞ for a tritium beta particle

The expectation of LET_∞ (unrestricted linear energy transfer) for a tritium beta particle around its parent nucleus in water has been calculated by the use of the energy-range relation of electrons. The amount of energy deposited by a beta particle with a certain initial energy over the interval of one micron at a definite position is obtained from the relation by the calculus of difference, and the probability that the event takes place per decay of tritium is estimated from the energy spectrum of tritium beta particles. The calculated values of expectations of LET_∞ are higher at positions close to the parent nucleus.     

Quantitative evaluation of generator power control effect of FACTS controllers for power system stabilization

The advancement of power electronics technologies has significantly developed the power system stabilizing controllers. Quantitative as well as qualitative evaluation of their effectiveness in power systems is a matter of great importance for the feasibility investigation of these apparatus. In this paper, the possible control region of FACTS controllers with series and/or shunt configuration in a single machine to infinite bus system is formulated in the powerangle curve with a set of algebraic equations. The effectiveness of TCPST (Thyristor‐Controlled Phase Shifting Transformer), SSSC (Static Synchronous Series Compensator), and TCSC (Thyristor‐Controlled Series Compensator) for the improvement of the transient stability is evaluated quantitatively as a numerical example. The correctness of the proposed method has been confirmed by analysis based on the electromagnetic transients simulation with a detailed system model. © 2001 Scripta Technica, Electr Eng Jpn, 138(3): 43–51, 2002     

Efficient photodiode-waveguide coupling for hybrid integrated optical circuits

A GalnAsP edge-detecting photodiode was coupled with an SiO2-TiO2 single-mode waveguide in a simple hybrid integration scheme. The newly developed edge-detecting photodiode with a window region was used to improve photodiode durability.     

Enzyme-linked immunosorvent assay using vertical microreactor stack with microbeads

The advantages of vertical microreactor stack with three-dimensional (3D) structure for immunoassay are discussed. The vertical microreactor stack uses vertical fluid flow operation with multifunctional fluid filters. The multi function of fluid filter is very effective for micromixing and passive valve operation. The mechanism of micromixing is discussed by using computational fluid dynamics (CFD), and we know that the mixing mechanism based on Coanda effect. To evaluate the micromixing performance of fluid filter, we demonstrated enzyme reaction with unique repeat mixing operation. As the results, we proved that the fluid filter has very effective mixing performance. The detection limit, which demonstrated by competition enzyme-linked immunosorvent assay (ELISA), is comparable with recommended detection limit, which suggested by Japanese ministry for the environment.     

Microstructure and properties of (Sr, Ca)CuO2/(Sr, Ca)RuO3 multilayers

Epitaxial multilayer thin films of infinite-layer (Sr, Ca)CuO₂ and perovskite (Sr, Ca)RuO₃ have been prepared on (100) SrTiO₃ substrates by multitarget rf magnetron sputtering. X-ray diffraction analyses revealed that the multilayer structure of (Sr, Ca)CuO₃/(Sr, Ca)RuO₃ was successfully fabricated with a minimum layer thickness of 20 Å. Transmission electron microscopy measurements of the multilayers indicated that there was no dislocation which normally exists in single-layer films with an infinite-layer structure. Resistivities of multilayer films at room temperature ranged from 1 to 10 m cm and showed semiconductor-like dependence against the temperature.     

Two-stage nuclear demagnetization refrigerator

Two-stage nuclear demagnetization has been performed using PrCu₆ and Cu as coolants. The Cu nuclear stage reached temperatures as low as 10 K with a rate of temperature rise of less than a few K/h. The corresponding conduction electron temperature is estimated to be less than 50 K. A nuclear orientation thermometer of Al ⁵⁴Mn has been successfully used to measure temperatures down to 10 K.Supported by the Japan Society for the Promotion of Science.     

Waveguide polarization-independent optical circulator

We fabricated a new type of waveguide polarization-independent optical circulator which does not need a polarization-beam splitter. The circulator is based on a non-reciprocal Mach-Zehnder interferometer which consists of two waveguide Faraday rotators, two thin-film half-waveplates and two planar lightwave circuit-type 3-dB couplers. The fabricated circulator provides a 14.0-23.7-dB isolation and a 3.0-3.3 dB insertion loss at λ=1.55 μm. This circulator presents a new possibility for developing non-reciprocal devices in the field of integrated optics     

Stabilization of a Power System Including Inverter‐Type Distributed Generators by a Virtual Synchronous Generator

The capacity of distributed generators (DGs) connected to the grid by inverters is growing year after year. The inverters are generally controlled by a phase locked loop (PLL) in order to achieve synchronization with the power system frequency. Power systems may become unstable as the capacity of the inverter‐type DGs continues to increase, because the inverter frequency is controlled just to follow the frequency determined by other synchronous generators. It has been suggested that inverters be controlled to behave like a synchronous generator. This concept is referred to as the virtual synchronous generator (VSG). In this paper, a control scheme for a VSG is presented, and the design method for the required energy storage and the capacity for grid stabilization control by a VSG is investigated by computer simulations.     

CRISPR Therapeutics for Duchenne Muscular Dystrophy

Duchenne muscular dystrophy (DMD) is an X-linked recessive neuromuscular disorder with a prevalence of approximately 1 in 3500–5000 males. DMD manifests as childhood-onset muscle degeneration, followed by loss of ambulation, cardiomyopathy, and death in early adulthood due to a lack of functional dystrophin protein. Out-of-frame mutations in the dystrophin gene are the most common underlying cause of DMD. Gene editing via the clustered regularly interspaced short palindromic repeats (CRISPR) system is a promising therapeutic for DMD, as it can permanently correct DMD mutations and thus restore the reading frame, allowing for the production of functional dystrophin. The specific mechanism of gene editing can vary based on a variety of factors such as the number of cuts generated by CRISPR, the presence of an exogenous DNA template, or the current cell cycle stage. CRISPR-mediated gene editing for DMD has been tested both in vitro and in vivo, with many of these studies discussed herein. Additionally, novel modifications to the CRISPR system such as base or prime editors allow for more precise gene editing. Despite recent advances, limitations remain including delivery efficiency, off-target mutagenesis, and long-term maintenance of dystrophin. Further studies focusing on safety and accuracy of the CRISPR system are necessary prior to clinical translation.