Characterization and electrochemical properties of CF4 plasma-treated boron-doped diamond surfaces

The effect of CF₄ plasma etching on diamond surfaces, with respect to treatment time, was investigated using scanning electron microscopy (SEM), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), and electrochemical measurements. SEM observations and Raman spectra indicated an increase in surface roughening on a scale of 10–20 nm, and an increase in crystal defect density was apparent with treatment time in the range of 10 s to 30 min. In contrast, alteration of the diamond surface terminations from oxygen to fluorine was found to be rather rapid, with saturation of the F/C atomic ratio estimated from XPS analysis after treatment durations of 1 min and more. The redox kinetics of Fe(CN)₆^3−/4− was also found to be significantly modified after 10 s of CF₄ plasma treatment. This behavior shows that C–F terminations predominantly affect the redox kinetics compared to the effect on the surface roughness and crystal defects. The double-layer capacitance (C_dl) of the electrolyte/CF₄ plasma-treated boron-doped diamond interface was found to show a minimum value at 1 min of treatment. These results indicate that a short-duration CF₄ plasma treatment is effective for the fabrication of fluorine-terminated diamond surfaces without undesirable surface damage.     

A Nonvolatile Organic Memory Device Using ITO Surfaces Modified by Ag‐Nanodots

We report on a single‐layer organic memory device made of poly(N‐vinylcarbazole) embedded between an Al electrode and ITO modified with Ag nanodots (Ag‐NDs). Devices exhibit high ON/OFF switching ratios of 10⁴. This level of performance could be achieved by modifying the ITO electrodes with some Ag‐NDs that act as trapping sites, reducing the current in the OFF state. Temperature dependence of the electrical characteristics suggest that the current of the low‐resistance state can be attributed to Schottky charge tunnelling through low‐resistance pathways of Al particles in the polymer layer and that the high‐resistance state can be controlled by charge trapping by the Al particles and Ag‐NDs.     

Analysis of brushless three-phase synchronous generator without exciter

Recently, a demand for small-capacity generators has been increasing as electric sources in small ships and automobiles or as portable electric sources driven by engines. It is desired that the structure of small-capacity generators be simple and robust, and that the generators be highly reliable, easily maintained and controlled. This paper describes an analysis of the original brushless synchronous generator without exciter. The output voltage can be adjusted in the wide range by controlling the stator dc current. To analyze the characteristics of this generator, the finite element method is applied. It is found that the results of theoretical analysis agree well with the experimental results.     

Steady-state torque control system with secondary-current feedback for three-phase squirrel-cage induction motors

This paper presents a highly stable steady-state torque control system with a feedback of a secondary current signal. The torque control system is constructed with a feedback of the secondary current (I₂) signal using a quick response magnetic-field sensor constructed with an amorphous core multivibrator bridge, which can solve the secondary resistance change problem for temperature variation in the IM. Moreover, we added a state feedback to the system to improve the response speed for the unit step function of a torque order. The I₂ sensor method has advantages especially at a low-speed range, in which conventional method using an integrator shows control errors.     

Gene Transfer Systems and Molecular Cloning in Group N Streptococci: A Review

Plasmid deoxyribonucleic acid of group N streptococci codes for a wide variety of important metabolic properties associated with dairy fermentations. The increasing knowledge of the genetics of these bacteria has created exciting possibilities for genetically constructing improved starter strains. A review of current literature is presented on the genetics of group N streptococci, especially the development and implications of gene transfer and molecular cloning systems for further genetic studies and for strain improvement. Functional properties of plasmid deoxyribonucleic acid and gene transfer systems, which include transduction, conjugation, transformation, and protoplast fusion, are reviewed and followed by a discussion of recent advances in gene cloning.     

A novel robust current control approach using adaptive line enhancer for three‐phase current‐source active power filter

An effective system control method is presented for applying a three‐phase current‐source PWM converter with a deadbeat controller to active power filters (APFs). In the shunt‐type configuration, the APF is controlled such that the current drawn by the APF from the utility is equal to the current harmonics and reactive current required for the load. To attain the time‐optimal response of the APF supply current, a two‐dimensional deadbeat control scheme is applied to APF current control. Furthermore, in order to cancel both the delay in the two‐dimensional deadbeat control scheme and the delay in DSP control strategy, an Adaptive Line Enhancer (ALE) is introduced in order to predict the desired value three sampling periods ahead. ALE has another function of bringing robustness to the deadbeat control system. Due to the ALE, settling time is made short in a transient state. On the other hand, total harmonic distortion (THD) of source currents can be minimized compared to the case where ideal identification of the controlled system can be made. The experimental results obtained from the DSP‐based APF are also reported. The compensating ability of this APF is very high in accuracy and responsiveness although the modulation frequency is rather low. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 50–61, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20014     

Gel chromism and anomalous luminescence in poly(3-alkylthiophene)

The absorption spectrum of poly(3-alkylthiophene) gel changes drastically in association with a volume instability upon changing the solvent composition and also the temperature. In the expanded state in chloroform and at high temperature, the photoluminescence is much enhanced compared with the shrunken state in ethanol and at low temperature. This gel chromism and anomalous luminescence are discussed in terms of the change of effective conjugation length induced by the steric hindrance and the dynamics of the photoexcited species.     

Syntheses and conformational studies of poly(S-menthyloxycarbonylmethyl l- and d-cysteines)

S-menthyloxycarbonylmethyl l- and d-cysteines were prepared by the reaction of l- or d-cysteine and (?)-menthyl chloroacetate in liquid ammonia and were then polymerized to poly(S-menthyloxycarbonylmethyll- and d-cysteines) by the N-carboxyanhydride (NCA) method. From the results obtained by means of infra-red spectra, X-ray diffractions, optical rotatory dispersions (o.r.d.), and circular dichroisms (c.d.), $\text{poly}\text{(S-}\text{menthyloxycarbonylmethyl-}\text{l}\text{-cysteine}\text{)}$ was found to be a right-handed α-helix in the solid state and in ethyl ether/chloroform and chloroform solutions. Similarly, $\text{poly}\text{(S-}\text{menthyloxycarbonylmethyl-}\text{d}\text{-cysteine}\text{)}$ was a left-handed α-helix. The helix-coil transition of these polymers was observed in the vicinity of 3–4% trifluoroacetic acid (TFA) in chloroform/TFA mixtures.     

Preparation of siloxane-like films by glow discharge polymerization

Glow discharge polymerizations of tetramethoxysilane (TMOS), tetramethylsilane/oxygen mixture (½ molar ratio) (TMS/O₂), hexamethyldisiloxane (HMDSO), and tetramethyldisiloxane (TMDSO) were carried out for the preparation of thin, polymeric films with siloxane structures. The chemical composition of the formed polymers was examined by elemental analysis, infrared spectroscopy, and electron spectroscopy for chemical analysis (ESCA) in connection with polymerization conditions, especially, a level of the radiofrequency (rf) input power per mass of the monomers (W/FM value). The polymers prepared from HMDSO at fairly low W/FM values resembled in chemical composition the conventionally polymerized polydimethylsiloxane. The surface properties of the formed polymers also were evaluated by the measurement of surface energy.     

A Recommendation System Keeping Both Precision and Recall by Extraction of Uninteresting Information

A recommendation system which recommends interesting information to the target user must guarantee high precision and recall. However, there is trade-off between precision and recall. In this paper, we propose a web page recommendation method balancing both of them by take advantage of uninteresting information. The proposed method extracts the interest and uninterest indicators from not only historical interesting web pages but also uninteresting ones in a target genre. The historical interesting and uninteresting information is derived based on the browsing time and bookmarking. The proposed method can keep precision and recall by excluding the uninteresting information from the recommended ones based on the interest and uninterest indicators. The experimental result proved that the proposed method can improve the precision and recall than an existing method.