Near-field corrections to site attenuation

The theoretical model used for calculating normalized site attenuation for broadband antennas in ANSI C63.4-1992 and for antenna calibration in ANSI C63.5-1988 includes only the radiation terms in the electric field. The omission of the near field terms leads to errors of as much as 2.0 dB at 30 MHz for horizontally polarized antennas separated by 3 m. Corrected values of normalized site attenuation and E _D^max are presented for the 30-300 MHz frequency range     

A base-band NDS electrode configuration for HACT devices

Heterostructure Acoustic Charge Transport (HACT) devices have been fabricated with a new nondestructive sense (NDS) electrode structure that provides for the recovery of base-band signals without the use of an integrating capacitor. This electrode structure provides an output signal comprising an RF carrier at the SAW frequency, amplitude modulated by the sampled input signal which has been delayed by a period proportional to the output electrodes distance from the input diode. The output of the NDS electrode structure is subsequently demodulated to provide the base-band signal     

合成己二腈反应技术研究——(Ⅴ)己二腈工业反应过程模拟与反应器改造

对己二腈工业反应器提出了两釜串联带回流的模型,通过模拟计算得出模型的级间返混系数 f=6的结论。该模型能较好地预测工业反应器中物料组分浓度变化和气、液两相的流动特性;指出了现工业反应器的鼓泡中和段体积偏小是造成己二酸浓度偏高的关键;提出了可以通过增加串连一个鼓泡预反应段的改造方案,能有效地降低己二酸的浓度,从7%降至4%左右,从而能较好地减缓腐蚀和结焦。     

Two methods of determining the ultimate long-term shear strength of clayey soils

A comparison is made between different alternate schemes for determination of the strength of soils possessing rheological properties on the basis of our own experimental data. An original method is proposed for determination of the ultimate long-term strength from tests on the conditionally instantaneous failure of soil after preliminary deformation in a creep regime, as well as from tests in a controlled-deformation regime. Translated from Osnovaniya, Fundamenty i Mekhanika Gruntov, No. 1, pp. 14–18, January–February, 1996.     

Increasing the service properties of weld joints by electrohydroimpulse treatment

Known examples of the positive influence of electrohydroimpulse treatment on the quality of weld joints of various steels, particularly including an increase in their long-term and cyclic strength and also corrosion resistance, are analyzed. It is shown that in this case there is a reduction in residual macro- and micro-stresses and also a change in the parameters of the dislocation structure of the joint metal in the direction of stabilization of it.Translated from Problemy Prochnosti, No. 4, pp. 119–123, April, 1996.     

The electrostatic problem for the SAW interdigital transducers inan external electric field. II. Periodic structures

For pt.I see ibid., vol.43, no.6, pp.1150-9 (1996). An exact solution of the electrostatic problem for calculating the surface charge and electric field distributions in an arbitrary periodic interdigital transducer (IDT) is given using the results of our companion paper. An arbitrary external electric field may be specified along the electrode structure with the unit cell containing one electrode, or several electrodes, of different widths. The potentials of the electrodes that may be specified are also arbitrary. It is shown that in the case without an external field, the solution includes all the known results as special cases. The case of shorted electrodes in the external electric field is investigated in detail. The surface charge and electric field distributions are calculated for a spatially harmonic external field with an arbitrary wavenumber. The results of the calculations are represented graphically for various ratios between the period of the electrode structure and the wavelength of the external field for the case of a unit cell containing one or two electrodes of different widths     

Value analysis of intermittent generation sources from the systemoperations perspective

The objective of this study is to determine the economic and operational impact on energy cost of incorporating large photovoltaic (PV) and wind energy conversion systems (WECS) into the electric utility generation mix. In most cases, PV and WECS power outputs are subtracted from the utility load with the expectation that conventional generation would meet the residual load. This approach is valid for small penetration levels and/or for PV and WECS facilities connected near load centers, However, several constraints such as thermal generation characteristics, fuel supply and delivery, spinning reserve requirements, and hydro availability are not adequately represented in this process. To determine the optimal value of large-scale PV and WECS applications, a new methodology that would take into account the aforementioned constraints as well as a more global penetration is developed. Results indicate that while high hydro availability increases PV penetration levels, high ramping rates can also significantly increase penetration levels     

Shear horizontal wave propagation in periodically layeredcomposites

The transverse resonance approach to guided wave analysis is applied to shear horizontal (SH) wave propagation in periodically layered composites. It is found for SH waves that at high values of the guided wavevector β, the wave energy is trapped in the slower of the two media and propagates accordingly at the slower wavespeed. At low values of β, however, the modes demonstrate a clustering behavior, indicative of the underlying Floquet wave structure. The number of modes in a cluster is observed to correlate with the number of unit cells in the layered plate. New physical insights into the behavior of these systems are obtained by analyzing the partial waves of the guided SH modes in terms of Floquet waves. We show that the fast and slow shear waves in the periodically layered composite play an analogous role to the longitudinal and shear partial waves comprising Lamb waves in a homogeneous plate     

Mean residence time of gas in mechanically agitated gas–liquid contactors

In the present study of gas–liquid contactors, mean residence/contact time was calculated from knowledge of superficial velocity and the gas phase hold-up, for various gas rates and impeller geometry and speeds, and compared with values obtained from RTD measurements. A new correlation, involving Flow Number, Froude Number, system geometry and the physical properties, is proposed. This uses the authors data and those available in literature.