An analytical grain-barrier height model and its characterizationfor intrinsic poly-Si thin-film transistor

An analytical model for the grain-barrier height of the intrinsic poly-Si thin-film transistors (TFTs) is developed, in which the grain-barrier height for the applied gate voltage smaller than the threshold voltage is obtained by solving the charge neutrality equation and the grain-barrier height for the applied gate voltage larger than the threshold voltage is obtained by using the quasi-two-dimensional (2-D) method. Good agreements between experimental and simulation results are obtained for a wide gate voltage range     

A microprocessor-based toggle-control lighting system

Analysis, design, practical consideration, and implementation of a microprocessor-based toggle-control lighting system are presented. The system is primarily configured with a power factor corrector (PFC), a square-wave voltage generator, a manually controlled toggle switch, and two relays. Toggling the toggle switch can select a different number of lamps in operation, resulting in a mutual dimming feature. A fluorescent lamp lighting system with this specific ballast gains the merits of lower system cost and more flexibilities in lighting fixture design, as compared to conventional systems     

Transdermal Iontophoretic Delivery of Thyrotropin-Releasing Hormone Across Excised Rabbit Pinna Skin

Enhanced transport of a model peptide drug thyrotropin-releasing hormone (TRH), a tripeptide of molar mass 362 g and a pK_a 6.2, through excised rabbit pinna skin was achieved by means of iontophoresis with continuous current or monophase periodically pulsed current. The resulting flux in the steady state was proportional to the applied current density. In the transdermal iontophoretic delivery of TRH, the pulsed iontophoretic flux exceeded that obtained with a continuous current. At a low ionic strength, an increased degree of protonation in TRH increased the rate of permeation. The flux of TRH in a buffer at pH 4 is greater than that at pH 8 when the ionic strength is 0.1 M. At a greater ionic strength, the trend is reversed. The enhanced flux of unprotonated TRH during transdermal iontophoresis is attributed largely to electro-osmotic volume flow. An increased rate of permeation of TRH crossing the skin is achieved at low ionic strength, moderate pH, and a large duly cycle of current; the frequency of pulsed current had no significant influence on the rate of transdermal iontophoretic delivery of TRH.     

The As-prepared surfaces of C-axis-oriented Nd1Ba2Cu3Oy thin films characterized using scanning probe microscopes

Recently, superconducting Nd₁Ba₂Cu₃O_y (Ndl23) thin films with high superconducting transition temperature (T _c) have been successfully fabricated at our institute employing the standard laser ablation method. In this paper, we report the results of surface characterization of the Nd123 thin films using an ultrahigh vacuum scanning tunneling microscope/spectroscopy (UHV-STM/STS) and an atomic force microscope (AFM) system operated in air. Clear spiral pattern is observed on the surfaces of Nd123 thin films by STM and AFM, suggesting that films are formed by two-dimensional island growth mode. Contour plots of the spirals show that the step heights of the spirals are not always the integer or half-integer number of thec-axis parameter of the structure. This implies that the surface natural termination layer of the films may not be unique. This result is supported byI-V STS measurements. The surface morphology of the Nd123 thin films is compared with that of thec-axis-oriented Y₁Ba₂Cu₃S_y thin films. Surface atomic images of the as-prepared Nd123 thin films are obtained employing both STM and AFM. STS measurements show that most of the surfaces are semiconductive. The results of STS measurements together with the fact that we are able to see the surface atomic images using scanning probe microscopes suggest that exposure to air does not cause serious degradation to the as-prepared surfaces of Nd123 thin films.     

氧化铝厂渣浆泵机械密封的失效形式及改进措施

本文介绍了渣浆泵机械密封的失效形式,并根据长期现场工作经验,分析了机械密封泄漏的主要原因,据此提出了改进措施,通过对动静环密封面倒角,改变密封面尺寸及载荷系数后有效地解决了由于径向跳动过大而引起的密封面刮碰擦裂的失效问题。     

In situ polymerization and characterization of polyester‐based polyurethane/nano‐silica composites

Polyester‐based polyurethane/nano‐silica composites were obtained via in situ polymerization and investigated by Fourier‐transform infrared spectroscopy (FTIR), or FTIR coupled with attenuated total reflectance (FTIR‐ATR), Transmission electron microscopy (TEM), atomic force microscopy (AFM), an Instron testing machine, dynamic mechanical analysis (DMA) and ultraviolet‐visible spectrophotometry (UV‐vis). FTIR analysis showed that in situ polymerization provoked some chemical reactions between polyester molecules and nano‐silica particles. FTIR‐ATR, TEM and AFM analyses showed that both surface and interface contained nano‐silica particles. Instron testing and DMA data showed that introducing nano‐silica particles into polyurethane enhanced the hardness, glass temperature and adhesion strength of polyurethane to the substrate, but also increased the resin viscosity. UV‐vis spectrophotometry showed that nano‐silica obtained by the fumed method did not shield UV radiation in polyurethane films. Copyright © 2003 Society of Chemical Industry     

汽车发动机电机铁芯用钢(ADW2)的研制开发

鞍钢研制开发的汽车发动机启动电机用钢是针对汽车电机铁芯用钢（定、转子）而开发的电机钢类产品。介绍了该产品的研制过程及规格、特点。通过批量试制及装机试验，产品巳满足用户的使用要求。     

Renal R2 chemoreceptor activity is attenuated after back heating in the rat

The aim of the present study was to determine the afferent connections of the nucleus accumbens in snakes, in particular its catecholaminergic input. For that purpose, in vitro and in vivo applications of retrograde tracers in the nucleus accumbens of Elaphe guttata were combined with tyrosine hydroxylase (TH) immunohistochemistry. Both techniques revealed telencephalic inputs to the nucleus accumbens originating from the diagonal band of Broca, ventral pallidum, amygdaloid complex, and dorsal cortex. Major diencephalic inputs arise from the dorsomedial thalamic nucleus and the hypothalamus. In the brainstem, a few retrogradely labeled cells were observed in the raphe nucleus and the locus coeruleus. Considerably more cells were found in the midbrain tegmentum. Within the confines of the locus coeruleus and, in particular, the midbrain tegmentum, retrogradely labeled cells stained also for TH suggesting that those areas constitute the major catecholaminergic input to the nucleus accumbens of snakes. The experimental approach used in the present study, in particular the in vitro technique, seems to be very suited for studying the development of basal ganglia organization of reptiles in the near future.     

Synthesis, characteristics and oxygen-sensitive properties of SrMgxTi 1 − xO3 nanocrystals

SrMg_xTi_{1 - x}O₃ nanocrystals (x = 0.1–0.6) were synthesized by the stearic acid gel method. Powder samples were characterized by X-ray diffraction and X-ray photoelectron (XP) spectroscopy. The results showed that the lattice parameter a and the O 1s XP spectrum changed not only with the Mg content x but also with the grain size d of the samples. The conductivity of a thick film specimen fabricated on an aluminium oxide wafer was investigated in a nitrogen—oxygen atmosphere.     

MEASUREMENT OF THE SPECIFIC SURFACE AREA OF POWDERS BY THIN LAYER WICKING

The specific surface areas (A) of different clay mineral powders were measured by both the BET method and by thin layer wicking. The values of A for the BET and the wicking experiments coincided within a few percent. Thus, the simple and inexpensive thin layer wicking approach may well suffice to obtain reliable specific surface area values for most powders. From the wicking data it is also possible to obtain a rough estimate of the average particle size.