A 0.25-/spl mu/m CMOS quad-band GSM RF transceiver using an efficient LO frequency plan

This paper describes a single-chip CMOS quad-band (850/900/1800/1900 MHz) RF transceiver for GSM/GPRS applications. It is the most important design issue to maximize resource sharing and reuse in designing the multiband transceivers. In particular, reducing the number of voltage-controlled oscillators (VCOs) required for local oscillator (LO) frequency generation is very important because the VCO and phase-locked loop (PLL) circuits occupy a relatively large area. We propose a quad-band GSM transceiver architecture that employs a direct conversion receiver and an offset PLL transmitter, which requires only one VCO/PLL to generate LO signals by using an efficient LO frequency plan. In the receive path, four separate LNAs are used for each band, and two down-conversion mixers are used, one for the low bands (850/900 MHz) and the other for the high bands (1800/1900 MHz). A receiver baseband circuit is shared for all four bands because all of their channel spaces are the same. In the transmit path, most of the building blocks of the offset PLL, including a TX VCO and IF filters, are integrated. The quad-band GSM transceiver that was implemented in 0.25-/spl mu/m CMOS technology has a size of 3.3/spl times/3.2 mm/sup 2/, including its pad area. From the experimental results, we found that the receiver provides a maximum noise figure of 2.9 dB and a minimum IIP3 of -13.2dBm for the EGSM 900 band. The transmitter shows an rms phase error of 1.4/spl deg/ and meets the GSM spectral mask specification. The prototype chip consumes 56 and 58 mA at 2.8 V in the RX and TX modes, respectively.     

Fast DCT algorithm with fewer multiplication stages

A novel fast DCT scheme with reduced multiplication stages and fewer additions and multiplications is proposed. The proposed algorithm is structured so that most multiplications tend to be performed at the final stage, which reduces the propagation error that could occur in the fixed-point computation. Minimisation of the multiplication stages can further decrease the error     

Virtual circuit connection method for RSVP multicasting supportingheterogeneous receivers on the ATM network

The authors suggest a novel virtual circuit connection method based on the reverse traversing technique to minimise the waste of network bandwidth resources, when the Internet protocol multicast is interoperated using the resource reservation protocol over an asynchronous transfer mode network. Simulation results show that, as the number of receivers increases, the bandwidth requirements on all links of the network of the proposed scheme become more advantageous than those of other conventional methods     

Interleukin-2 enhancement of cytotoxicity by humanized monoclonal antibody M195 (anti-CD33) in myelogenous leukemia

The mass childhood immunization programme has traditionally been viewed as a safe and effective preventative measure by health promoters, primary health care professionals and governments. This consensus has meant that immunization has rarely been viewed as ethically problematic. A number of recent changes in the context of the delivery of health care, particularly the emphasis on consumerism and the effect of the marketization of services, makes timely an examination of ethical, social and political issues. This article examines four main grounds for problematizing the mass childhood immunization programme. These are: clinical research evidence about the safety and efficacy of vaccines; the masking of wider social and political determinants of ill health; the contradictory strictures about collective and individual rights in relation to immunization; and the uniqueness of childhood immunization as a physical intrusion into a healthy body. The implications of these ethical issues are discussed in relation to informed consent and the need for a 'greenfield' review that includes the views of dissenting parents, lawyers and moral philosophers, as well as health professionals.     

An ARQ scheme using combined QPSK and BPSK transmissions

We propose a hybrid ARQ scheme which uses QPSK modulation for the first transmission and BPSK modulation for retransmissions. The throughput performance of the proposed ARQ scheme is better that those of ARQ schemes purely using QPSK modulation or purely using BPSK modulation for transmissions. Furthermore, the proposed scheme does not require any operation of error correction as usually required in hybrid ARQ schemes. Therefore, the ARQ scheme proposed in this paper can be easily implemented     

Role of vagus nerves in resiniferatoxin-induced bronchoconstriction of guinea pigs

To study the role of vagal afferent C-fibers in resiniferatoxin (RTX)-induced bronchoconstriction in vivo, 30 guinea pigs weighing 347 +/- 28 g were evenly and randomly divided into five groups: Group 1, control; 2, chronic vagotomy; 3, local capsaicin (acute); 4, local capsaicin (chronic); and 5, systemic capsaicin. Each animal was anesthetized with pentobarbital sodium, cannulated with a tracheal cannula and venous catheter, paralyzed with gallamine triethiodide, and artificially ventilated. All animals were pretreated with atropine and phenoxybenzamine. Immediately after RTX was intravenously injected, each animal in the control group exhibited profound decreases in maximal expiratory flow, dynamic respiratory compliance, and total lung capacity, as well as an increase in functional residual capacity, indicating severe airway constriction. Animals in Groups 2-4 exhibited partial abolishment, while those in Group 5 showed complete abolishment of the RTX-induced bronchoconstriction. In 12 additional animals (6 animals each in control and chronic vagotomy groups), chronic vagotomy caused also suppressive effects on capsaicin-induced airway constriction. At one min, our data demonstrate that 36-51% of noncholinergic bronchoconstriction is due to the vagal component while the remaining constriction is due to the nonvagal component. Thus, the nonvagal component plays a significant role in this type of tachykinin-mediated airway constriction.     

ETR Ⅱ-30调速器液压控制系统

ETRⅠ-30调速器是瑞士爱舍维斯工厂生产的具有PID调节规律的电液调速器。本文对其液压控制系统作了较详细的介绍,供有关人员参考。     

Application of evolutionary programming to transient andsubtransient parameter estimation

This paper presents an artificial intelligence approach of using evolutionary programming to estimate the transient and subtransient parameters of a generator under normal operation. The estimation using evolutionary programming is compared with that using a corrected extended Kalman filter. The comparisons with both simulation and micromachine test results show that evolutionary programming is robust to search the real values of parameters even when the data are highly contaminated by noise, while with the extended Kalman filter, the estimation tends to diverge with such data     

Effect of type of processing on the microstructural features and mechanical properties of Al-Cu/SiC metal matrix composites

In this study, an aluminum based metallic matrix (Al-2wt.% Cu) was reinforced with SiC particulates using a conventional casting technique and a new disintegrated melt deposition technique. Microstructural characterization studies conducted on the samples taken from disintegrated melt deposition technique revealed a more uniform distribution of SiC particulates and good interfacial integrity between SiC particulates and metallic matrix when compared to the conventionally cast composite samples. Results of ambient temperature mechanical tests demonstrate an increase in 0.2% YS and ultimate tensile strength of samples taken from disintegrated melt deposition technique when compared with the unreinforced and conventionally cast composite samples. The results of microstructural characterization and mechanical testing were finally rationalized in terms of the nature of processing technique employed to reinforce Al-2wt.% Cu metallic matrix with SiC particulates.