Preliminary spectrum shifter design for intermediate energy nuclear data benchmark experiments with DT neutrons

Integral benchmark experiments with DT neutrons are not always sufficient for nuclear data benchmarking in the MeV region, below 10 MeV. A neutron spectrum shifter, which will be placed between a sample and a DT neutron source, is effective to moderate DT neutrons incident to the sample. In order to estimate effects of the spectrum shifter, the ratio of the contribution of 14 MeV neutrons in the leakage neutron and gamma-ray spectra was calculated with MCNP-4C for an experimental configuration at FNS of JAEA, Japan. The calculations were carried out for a Li₂TiO₃ sample with a Be, D₂O, or ⁷LiD spectrum shifter. It was found out that the Be shifter was superior to others and the Be shifter was effective to decrease the contribution of 14 MeV neutrons especially for secondary gamma-ray spectrum measurements.     

Surface activity of aqueous solutions of cellulose acetate with low degree of substitution

Surface activity of aqueous solutions of cellulose acetate (CA) with total degree of substitution (〈F〉) ranging from 0.58 to 0.80 was examined. Critical micelle concentration (CMC) of the aqueous CA solutions, determined from the polymer concentration dependence of surface tension (γ), is unequivocally determined by 〈F〉, and an increase in 〈F〉 of CA brings about a lowering of the CMC. From light scattering measurements on aqueous solutions of CA with 〈F〉 = 0.8 at 20°C, it was revealed that in the vicinity of the CMC the micelles in the solution consist of c. four CA molecules, which is very close to the value obtained by analysing the data obtained from the mass action model. The surface tension of aqueous solutions of CA (〈F〉 = 0.8) in the polymer concentration range above the CMC was c. 0.74 times that of pure water over the temperature range 0–80°C.     

Observations of high-field domains in GaxIn1 ? xSb Gunn diodes

The properties of high-field domains in GaxIn1-xSb Gunn diodes (0.4 < x < 0.82) have been studied by measuring the surface potential on the diodes. The domain velocities vary with the Ga composition x, 5.3?6.1×106 cm/s for0.8 > x > 0.55 and 10×106 cm/s for x = 0.4, but they are almost independent of the applied voltage, even if the electron concentration is increased by the impact ionisation in the domain at high applied voltages for the small-x samples.     

Solar-hydrogen energy system-model applied to isolated island

Comparison between a petroleum energy system and a solar-hydrogen energy system is studied in the case where an industry is newly introduced to an isolated island. Assuming a hybrid energy system composed of petroleum, solar energy, hydrogen energy and electric energy, we investigate an optimum economy with the use of computer-aided LP (Linear Programming) and QP (Quadratic Programming) models taking account of the cost functions originated from the acquisition prices of the primary energy and the transport prices. Furthermore, the modified LP model makes it possible to take account of the uncertainties arising from the acquisition instability and environmental protection. Some conditions are clarified under which the introduction of a solar-hydrogen energy system is highly feasible.     

Acidophilic xylanase from Aureobasidium pullulans: efficient expression and secretion in Pichia pastoris and mutational analysis

A yeast-like fungus Aureobasidium pullulans var. melanigenum strain ATCC 20524 produces an extracellular acidophilic endo-1,4-beta-xylanase with an optimum pH of 2.0 [Ohta et al., J. Biosci. Bioeng., 92, 262-270 (2001)]. The xynI cDNA encoding the precursor protein (XynI) was expressed in the methylotrophic yeast Pichia pastoris under the control of the alcohol oxidase I gene promoter. The 34 amino acid prepro-signal peptide of the A. pullulans XynI directed the efficient secretion of 178 mg of active xylanase per liter of the culture medium. The secretion level of the xylanase with its own signal peptide was comparable to that of the mature protein fused to the prepro leader from Saccharomyces cerevisiae alpha-mating factor and twofold higher than that of the mature protein fused to the pre-type signal peptide from P. pastoris acid phosphatase. The N-terminal amino acid sequence and the apparent M(r) of 24 kDa of the secreted recombinant protein indicated the native-like processing of the A. pullulans XynI signal sequence in P. pastoris. The three-dimensional model and mutational analysis of the xynI gene product showed that Asp-73 and Glu-157 residues located at the upper and lower edges of the active site cleft, respectively, play a significant role in its low pH optimum.     

Gel permeation chromatography using controlled-porosity glass. II. Polyacrylamide aqueous solutions

In a study of polyacrylamide in solutions we have required the rapid characterization on chromatographies. The application to the aqueous solution of the GPC using controlled-porosity glass has been examined from both the viewpoint of the effect of salt addition and the GPC mechanism. An adequate addition to neutral salt, 0.005M KCI to the eluent, gave rise to the elution behaviors being in accord with the hydrodynamic volume concept of the GPC separation.     

Submicron bubble garnets and their characterizations

New Submicron (0.5-1.0 mum diam) bubble garnets have been developed. In order to reduce saturation induction4piMsas low as possible, suitable choice of amounts of nonmagnetic ions substituting for ferric ions in both tetrahedral and octahedral sites were studied in (YSm)3(FeAl)5O12, (YSmLu)3- (FeGaSc)5O12, (YSmLu)3(FeAlSc)5O12and (LaLuSm)3- (FeGa)5O12garnet systems. For example, in (YSmLu)3- (FeAlSc)5O12a film with the following properties was grown; strip widthw = 0.7mum, film thicknessh= 0.7mum, quality factorq=2.8, Curie temperatureTc= 140degC and4piMs=770G. The temperature properties of those films could be improved drastically by doping with a small amount of Gd ion. Wall mobilities μw of those films are in the region from 200 to 500cm/s/Oe. Preceding these material studies, several film characterization methods have been investigated. Film thickness was measured by Fluorescent X-ray method, strip width by using a highly sensitivity TV camera, and bubble collapse field by FMR resonance technique respectively.