Temperature dependence of hydrogenated amorphous silicon thin-film transistors

The temperature dependence characteristics of hydrogenated amorphous silicon thin-film transistors were investigated. The results indicate that as the temperature was increased, the threshold voltage and the field-effect mobility were first increased, and then decreased, which may be controlled by different mechanisms at low and high temperatures. In addition, if the temperature was higher than 420 K, the Fermi level was promoted to the degenerate-like states, the current channel always existed due to the temperature effect, and the threshold voltage became negative.     

Double-step generation of ellipses

The principle of double-step incremental generation of nonparametric curves on a discrete plane is used to develop a double-step algorithm for scan converting ellipses in sixteen separate segments. The algorithm iterates only half as many times as current algorithms, while each iteration demands the same number of operations or slightly fewer operations than M. Pitteway's (1967, 1985) algorithm (previously the fastest one). This marked gain in the speed of scan conversion is due to the fact that the middle pixel in a two-step increment is obtained without computation     

β放射性气体浓度计的新分度方法

本文介绍β放射性气体浓度计的一种新的分度方法——泄漏元件排气法。其特点是一只元件可分度放射性气体浓度计的许多读出数(甚至是几个量程),操作方便。     

Improved coupled-mode theory of anisotropic optical waveguides

A coupled-mode equation for anisotropic waveguide systems of arbitrary cross section and general dielectric distribution is derived. Numerical results comparing the exact calculations to those of the method of Hardy et al. (Opt. Lett., vol.11, 742-4, 1986) show that the same accuracy can be obtained not only for TE, but also for TM mode coupling in the case of anisotropic waveguides, and the improved coupled-mode theory is applicable to the situation when moderately strong coupling occurs under the condition where the edge-to-edge separation of two coupled guides D₂ is about 0.1 μm     

Fuel management of the HTR-10 including the equilibrium state and the running-in phase

The mode of fuel management of the HTR-10 was studied, including the simulation of the fuel shuffling process and the measurement of the burnup of a fuel element. The prior consideration was the design of the equilibrium state. Based on this the fuel loading of the initial core and the fuel shuffling mode from the initial core through the running-in phase into the equilibrium state were studied. The code system VSOP was used for the physical layout of the HTR-10 at the equilibrium state and in the running-in phase. For the equilibrium state, in order to lessen the difference between the peak and the average burnup, 5-fuel-passage-through-the-core was chosen for the fuel management. The average burnup of the spent fuel for the equilibrium core is 80 000 MWd t⁻¹, and the peak value of it is less than 100 000 MWd t⁻¹ when the burnup of the recycled fuel element is under 72 000 MWd t⁻¹. The mixture of fuel element and graphite element was used for the initial core loading, the volume fractions of the fuel and the graphite elements were 0.57 and 0.43, respectively. During the running-in phase, the volume fraction of graphite will decrease with the fresh fuel elements being loaded from the top of the core and the graphite elements discharged from the bottom of the core. The fuel shuffling mode is similar to that of the equilibrium state. The burnup limit of recycled fuel element is also 72 000 MWd t⁻¹ and the peak burnup is less than 100 000 MWd t⁻¹. Finally the core will be full of fuel elements with a certain profile of burnup and reaches the equilibrium state. According to the characteristics of the pebble-bed high temperature gas-cooled reactor, a calibrating method of concentration of ¹³⁷Cs was proposed for the measurement of fuel burnup.     

Economic analysis and optimization of tool portfolio in semiconductor manufacturing

The tool portfolio of a plant refers to the makeup, in quantity and type, of processing machines in the plant. It is determined by taking into consideration the future trends of process and machine technologies and the forecasts of product evolution and product demands. Portfolio planning is also a multicriteria decision-making task involving tradeoffs among, investment cost, throughput, cycle time, and risk. Tool portfolio planning is a complex task that has strong bearing on manufacturing efficiency. In the first part of this paper, a multicriteria economic decision model is presented for optimal configuration. of the portfolio and to determine the optimal factory loading. The second and third parts of the paper contain applications of the model. If plants are closely located or have a twin-plant design, portfolio planning at multiple plants can be integrated to enhance the overall effectiveness of portfolios. In the second part, a novel methodology for arbitrating capacity backup between plants is described. Because the economic model is constructed upon a valuation of both cycle time and throughput, it is a suitable method for the evaluation of cycle time reduction projects. The application procedure is outlined in the third part.     

STUDY ON RESIDUES OF ~（14）C－FENITROTHION IN MODEL RICE－FISH ECOSYSTEM AND FIELD RICE－FISH ECOSYSTEM

ＳＴＵＤＹＯＮＲＥＳＩＤＵＥＳＯＦ~（１４）Ｃ－ＦＥＮＩＴＲＯＴＨＩＯＮＩＮＭＯＤＥＬＲＩＣＥ－ＦＩＳＨＥＣＯＳＹＳＴＥＭＡＮＤＦＩＥＬＤＲＩＣＥ－ＦＩＳＨＥＣＯＳＹＳＴＥＭＺｈａｎｇＺｈｏｎｇｌｉａｎｇ（张仲良）；ＷａｎｇＨｕａｘｉｎ（王化新）；Ｇ?..     

Enhancement of oxide break-up by implantation of fluorine inpoly-Si emitter contacted p+-n shallow junctionformation

In this study, it is demonstrated that the incorporation of fluorine can enhance poly-Si/Si interfacial oxide break-up in the poly-Si emitter contacted p⁺-n shallow junction formation. The annealing temperature for breaking up the poly-Si/Si interfacial oxide has been found to be as low as 900°C. As a result, the junction depth of the BF₂-implanted device is much larger than that of the boron-implanted device     

10Gbit/S以太网,RPR和MPLS协同工作:城域网的未来

随着数据业务的发展,目前在城域网领域出现了3种很有希望的新技术:MPLS(多协议标记交换)、10 Gbit/s以太网和弹性分组环(RPR).这三种技术都各自有着自己的特点和优点,然而仅仅采用某一项技术并不能解决网络中的全部问题,将这三种技术综合应用就成为一种必要,本文将简要分析这几种技术,及其它们综合起来协同工作的必要性和现实意义.