新型阳离子聚合物NCP的合成及应用

介绍了用高分子反应法在固态条件下合成高阳离子度阳离子聚合物NCP的方法,确定了其最佳反应条件,测定了聚合物阳离子度和反应效率.采用L9（34）正交试验法得出合成NCP的最佳反应条件为：聚合物与阳离子化试剂质量比为11：3;催化剂用量为1.072%,反应时间为2.5 h;反应温度为80℃.实验结果表明,在反应体系中加入催化剂和少量有机或无机溶剂可显著提高反应速率和效率;使用少量润湿剂,可最大限度地限制副反应,造成反应部位的局部浓度高,提高反应效率.阳离子聚合物NCP可作为增粘降滤失剂用于配制正电性钻井液,效果优良,且耐温性能良好,同时基于阳离子与阴离子聚合物在溶液中生成凝胶状沉淀物的特性,NCP还可用于解决注聚区块生产井产出水中含高浓度聚合物的问题.     

Phase equilibria of quasi-binary systems consisting of multicomponent polymers 1 and 2. IV: Poly(ethylene oxide)/poly(propylene oxide) systems

To confirm the reliability of the theory of phase equibria of multicomponent polymer 1/multicomponent polymer 2 systems (i.e. quasi-binary systems) and the method of computer experiment based on this theory (Brit. Polym. J., 23 (1990)285; 23 (1990)299; Polym. Int., 29 (1992)219), could point curves (CPC), two-phase volume ratios ( R ) and critical solution points (CSP) have been determined experimentally for the quasi-binary mixtures of poly(ethylene oxide) (M¯_w = 647, M¯_w/M¯_n = 1.15; M¯_w and M¯_n, the weight-average and numberaverage molecular weights, respectively) and poly(propylene oxide) (M¯_w = 2028, M¯_w/M¯_n = 1.08; and M_w = 2987, M_w/M_n = 1.13). The hydroxyl end groups of both polymers were methoxylated in advance by the Cooper & Booth method (Polymer, 18 (1977)164). The thermodynamic interaction parameter between both polymers, χ₁₂, and the concentration dependence parameters for the above quasi-binary systems were determined by the method proposed in a previous paper (Brit. Polym. J., 23 (1990)299). CPC, R and CSP values calculated on the basis of the theory are in good agreement with the values determined experimentally.     

放射性核素迁移的实验室研究——Ⅱ.用混合裂变产物溶液研究核素在地质材料上的吸附

应用裂变产物混合物做为示踪剂研究了~(137)Cs,~(141,144)Ce,~(103,106)Ru,~(103,106)Ru,~(95)Zr,~(95)Nb,~(89,90)Sr在花岗岩、凝灰岩、页岩上的吸附行为。应用批式技术测定了吸附比。核素的γ放射性是用连有SCORPIO-3000多道计算机系统的Ce(Li)探测器测量的。β放射性~(89,90)Sr是放化分离后在G-M计数器上测量的。结果表明:凝灰岩、页岩能强烈吸附Ce,Nb,Zr;吸附Cs居中;吸附Sr,Ru较差;花岗岩的吸附性能都差。     

Synthesis of diamond crystals and films using an oxygen-acetylene flame under atmosheric pressure

Diamond growth with rates up to 100 to 140 μm/hr was achieved using an oxygen-acetylene combustion spraying technique in an atmospheric environment. Investigations on the processing indicated that the gas flow ratio, substrate position, substrate temperature, temperature distribution, and substrate pretreatment were the most important factors affecting the growth of diamond crystals. Evaluation by means of X-ray diffraction, Raman spectroscopy, scanning electron microscopy, and electron probe microanalysis showed that the synthesized diamond was nearly perfect in morphology, structure, and purity.     

α-Fe_2O_3(SO_4~(2-),Sn)气敏电阻的温度响应特性

在气敏温度区域内研究了α-Fe_2O_3(SO_4~(2-),Sn)材料的电阻-温度特性,认为表面结构的变化导致温度特性出现峰值并呈现气敏性。可利用空气中电阻温度特性提供的信息改性或发现新的气敏材料。     

Solubility of amaranth seed proteins in sodium sulphate and sodium chloride: the main factor in quantitative extraction for analysis

Nitrogen was extracted more efficiently from amaranth seed with 0.04 M Na₂SO₄ (5% w/v) than with either 0.09 M or 0.17 M NaCl (5% or 10% w/v), despite both solutions having the same ionic strength (μ= 1). Solubility of saline soluble proteins (albumin ± globulin) was very poor in either water or 1M NaCl, but increased in 0.4M NaCl at alkaline pH between 7 and 10. Globulins were very soluble in 0.4M NaCl at a pH 9. Albumin was the main storage protein. Saline soluble proteins formed very weak gels.     

RE／S值对控轧低碳Mn－Nb－RE钢硫化物成分和形貌的影响

用扫描电镜测定了含０．０４１％～０．０７６％ＲＥ的低碳Ｍｎ－Ｎｂ－ＲＥ钢中硫化物的成分、大小和形貌。ＲＥ／Ｓ值为２．８～３．０时，钢中的硫化物充分变质。     

氨合成塔出口氨含量偏低原因分析及对策

阐述UHDE合成塔运行现状 ,分析氨净值达不到设计值的原因 ,提出相应的解决措施     

复合材料压缩破坏模式的缺陷敏感性

本文基于弹塑性分叉理论研究单向纤维增强复合材料的压缩破坏模式和压缩强度对缺陷的敏感性问题。对于常见复合材料,所得结论是:无缺陷或者小缺陷情况的破坏模式为倾斜破坏带;大缺陷情况的破坏模式为水平破坏带;形成水平破坏带的压力值小于形成倾斜破坏带的压力。     

适用于稠油开采的游梁式抽油机设计分析

在稠油开采中,抽油杆在液体中运动时,所受到的摩擦阻尼力很大,有时高达几十千牛。上冲程时,该力有加大悬点载荷的作用;下冲程时,该力使抽油杆下行困难,甚至悬点载荷为零。为了开采稠油,必须根据其特点设计适应的游梁式抽油机。文章分析了稠油用抽油机的受力特点,提出了该类抽油机的设计要求。