Synthesis and characterization of an interpenetrating polymer network composed of poly(methacrylic acid) and poly(vinyl alcohol)

Temperature and pH‐responsive interpenetrating polymer network (IPN) hydrogels, constructed with poly(methacrylic acid) (PMAA) and poly(vinyl alcohol) (PVA), by a sequential IPN method, were studied. The characterization of IPN hydrogels was investigated by Fourier‐transform infrared spectroscopy, differential scanning calorimetry (DSC) and swelling under various conditions. The IPN hydrogels exhibited relatively high swelling ratios, in the range 230–380 %, at 25 °C. The swelling ratios of the PMAA/PVA IPN hydrogels were pH and temperature dependent. DSC was used for the quantitative determination of the amounts of freezing and non‐freezing water. The amount of free water increased with increasing PMAA content in the IPN hydrogels. Copyright © 2004 Society of Chemical Industry     

关于Smarandache可乘函数的均值研究

本文的主要目的是利用初等方法研究Smarandache可乘函数在简单数集中的均值性质,并给出一个有趣的渐近公式。     

Interval based MINLP superstructure synthesis of mass exchange networks

A new simultaneous synthesis approach for mass exchange networks (MENs) is presented. The technique is adapted from the interval based mixed integer non-linear program (MINLP) superstructure (IBMS) synthesis of heat exchanger networks (HENs). The superstructure interval boundary compositions are defined by the supply and target compositions of either the rich or lean set of streams. Each rich and lean stream in the superstructure has the potential of exchanging mass with streams of opposite kind in each interval based on mass transfer feasibility. The model harnesses the strengths of the stagewise superstructure and the pinch technology methods for mass exchange network synthesis (MENS). The IBMS approach simultaneously trades-off the capital and operating costs for MENs. The superstructure composition interval defining approach introduced in this paper enforces the mixing of split streams at equal compositions, hence there is no need to include mixing equations in the model. Fixing the interval boundaries helps to eliminate the complexities involved in initialisations, thus the region of search for the optimum solution is reduced. The IBMS model is applied to MENS problems involving continuous contact and staged columns. It is also extended to problems involving multiple mass separating agents (MSAs) and regeneration. The results obtained compare well with those in the literature.     

Stochastic molecular descriptors for polymers. 4. Study of complex mixtures with topological indices of mass spectra spiral and star networks: The blood proteome case

The Quantitative Structure-Property Relationships (QSPRs) based on Graph or Network Theory are important for predicting the properties of polymeric systems. In the three previous papers of this series (Polymer 45 (2004) 3845-3853; Polymer 46 (2005) 2791-2798; and Polymer 46 (2005) 6461-6473) we focused on the uses of molecular graph parameters called topological indices (TIs) to link the structure of polymers with their biological properties. However, there has been little effort to extend these TIs to the study of complex mixtures of artificial polymers or biopolymers such as nucleic acids and proteins. In this sense, Blood Proteome (BP) is one of the most important and complex mixtures containing protein polymers. For instance, outcomes obtained by Mass Spectrometry (MS) analysis of BP are very useful for the early detection of diseases and drug-induced toxicities. Here, we use two Spiral and Star Network representations of the MS outcomes and defined a new type of TIs. The new TIs introduced here are the spectral moments (π_k) of the stochastic matrix associated to the Spiral graph and describe non-linear relationships between the different regions of the MS characteristic of BP. We used the MARCH-INSIDE approach to calculate the π_k(SN) of different BP samples and S2SNet to determine several Star graph TIs. In the second step, we develop the corresponding Quantitative Proteome-Property Relationship (QPPR) models using the Linear Discriminant Analysis (LDA). QPPRs are the analogues of QSPRs in the case of complex biopolymer mixtures. Specifically, the new QPPRs derived here may be used to detect drug-induced cardiac toxicities from BP samples. Different Machine Learning classification algorithms were used to fit the QPPRs based on π_k(SN), showing J48 decision tree classifier to have the best performance. These results suggest that the present approach captures important features of the complex biopolymers mixtures and opens new opportunities to the application of the idea supporting classic QSPRs in polymer sciences.     

3D velocity from 3D Doppler radial velocity

We present local least squares and regularization frameworks for computing 3D velocity (3D optical flow) from 3D radial velocity measured by a Doppler radar. We demonstrate the performance of our algorithms quantitatively on synthetic radial velocity data and qualitatively on real radial velocity data, obtained from the Doppler radar at Kurnell Radar station, Botany Bay, New South Wales, Australia. Radial velocity can be used to predict the future positions of storms in sequences of Doppler radar datasets.© 2005 Wiley Periodicals, Inc. Int J Imaging Syst Technol, 15, 189–198, 2005     

A novel distributed approach to robust fault detection and identification

In this paper, we propose a novel distributed robust fault detection and identification (RFDI) scheme for a class of nonlinear systems. Firstly, a detection and identification estimator—robust fault tracking approximator (RFTA) is designed for online health monitoring. A novel feature of the RFTA is that it can simultaneously detect and accurately identify the shape and magnitude of the fault and disturbance. Moreover, it takes less online training time compared with the traditional neural network based fault diagnosis schemes. For some distributed systems, a network of distributed estimators is constructed where the RFTA is embedded into each estimator. Then we use consensus filter to filter the outputs of each estimator. One of the most important merits of the consensus filter is that its outputs can dramatically improve the accuracy of fault detection and identification. Next, the stability of the distributed RFDI scheme is rigorously investigated. Finally, two numerical examples are given to illustrate the feasibility and effectiveness of the proposed approach.     

Uncertainty,belief, and probability1

We introduce a new probabilistic approach to dealing with uncertainty, based on the observation that probability theory does not require that every event be assigned a probability. For a nonmeasurable event (one to which we do not assign a probability), we can talk about only the inner measure and outer measure of the event. In addition to removing the requirement that every event be assigned a probability, our approach circumvents other criticisms of probability-based approaches to uncertainty. For example, the measure of belief in an event turns out to be represented by an interval (defined by the inner and outer measures), rather than by a single number. Further, this approach allows us to assign a belief (inner measure) to an event E without committing to a belief about its negation -E (since the inner measure of an event plus the inner measure of its negation is not necessarily one). Interestingly enough, inner measures induced by probability measures turn out to correspond in a precise sense to Dempster-Shafer belief functions. Hence, in addition to providing promising new conceptual tools for dealing with uncertainty, our approach shows that a key part of the important Dempster-Shafer theory of evidence is firmly rooted in classical probability theory. Cet article présente une nouvelle approche probabiliste en ce qui concerne le traitement de l'incertitude; celle-ci est basée sur l'observation que la théorie des probabilityés n'exige pas qu'une probabilityé soit assignée à chaque événement. Dans le cas d'un événement non mesurable (un événement pour lequel on n'assigne aucune probabilityé), nous ne pouvons discuter que de la mesure intérieure et de la mesure extérieure de l'évenément. En plus d'éliminer la nécessité d'assigner une probabilityéà l'événement, cette nouvelle approche apporte une réponse aux autres critiques des approches à l'incertitude basées sur des probabilityés. Par exemple, la mesure de croyance dans un événement est représentée par un intervalle (défini par la mesure intérieure et extérieure) plutǒt que par un nombre unique. De plus, cette approche nous permet d'assigner une croyance (mesure intérieure) à un événement E sans se compromettre vers une croyance à propos de sa négation -E (puisque la mesure intérieure d'un événement et la mesure intérieure de sa négation ne sont pas nécessairement une seule et unique mesure). II est intéressant de noter que les mesures intérieures qui résultent des mesures de probabilityé correspondent d'une manière précise aux fonctions de croyance de Dempster-Shafer. En plus de constituer un nouvel outil conceptuel prometteur dans le traitement de l'incertitude, cette approche démontre qu'une partie importante de la théorie de l'évidence de Dempster-Shafer est fermement ancrée dans la theorie classique des probabilityés.     

Stabilization of inter-area and/or oscillatory modes in large-scale power system by voltage impedance power system (VIPS) apparatus based on decentralized control scheme

New technologies such as power electronics have made it possible to change continuously the impedance of a power system not only to control power flow but also to enhance stability. A power system incorporating a variable impedance apparatus such as a variable series capacitor (VSrC) and high-speed phase shifter (HSPS) is called VIPS (Variable Impedance Power System) by the authors. This paper proposes a novel control method of VIPS apparatus such as VSrC and HSPS installed at an interconnecting point for stabilizing inter-area unstable and/or oscillatory modes. The proposed design method of the control system is a kind of hierarchical decentralized control method of a large-scale power system based on a Lyapunov function. Under the proposed control scheme, each subsystem can be stabilized independently by local controllers such as AVR, speed governor and PSS, and then the whole interconnected system can be stabilized by VIPS apparatus taking into account interactions between subsystems. The effectiveness and robustness of the VIPS apparatus control are shown by numerical examples with model systems including a large-scale power system.     

Reliability and performance analysis of time – space – time switching networks with multiple separated space switches

Since electronic switching systems usually require very strict reliability requirements as well as good performance objectives, we need to jointly analyse the performance and reliability of switching systems. In this paper, we compare conventional time–space–time switches with single space switches with those with multiple separated space switches, from the viewpoints of reliability and performance. We consider time–space–time switching networks which consist of N incoming time switches, i.e. one NxN space switch, two (N/2)x(N/2) space switches, and four (N/4)x(N/4) space switches. We introduce a Markov reliability model to study the effect of failures and analyse the reliability and performance of three different types of switching networks in terms of average blocking probability and the mean time to unreliable operation, as we vary the offered traffic. As a result, T–S–T switching networks with multiple separated space switches exhibit better performance and reliability than those with single space switches.