FEM analyses for influences of stress corrosion and pressure solution on THM coupling in dual-porosity rock mass

With the models of stress corrosion and pressure solution, by Yasuhara et al., two computation conditions were designed for a hypothetical nuclear waste repository in an unsaturated dual-porosity rock mass: (i) the fracture apertures are changed with the stress corrosion and pressure solution (the porosity of rock matrix is also a function of stress); (ii) the fracture apertures and the porosity of rock matrix are constants. Then the corresponding two-dimensional FEM analyses for the coupled thermohydro-mec...     

世界溶液丁苯橡胶的主要技术进展

评述了溶液丁苯橡胶的技术现状和主要技术进展。介绍了新型锡锂引发剂和用其制备的溶液丁苯橡胶的性能特点，特别是其突出的滚动阻力特性和在不损失湿牵引性下的优异耐磨性。分析了世界，特别是美国、欧洲和日本的溶液丁苯橡胶的需求现状及发展趋势。     

化学铣切槽液中Na2S的分析

本文采用“碘量法”测定化铣液中的硫化钠，分析结果的准确度和精密度完全能够满足生产要求。     

光化学反应中的磁场效应 Ⅱ.电子转移光敏化1,2-二苯乙烯的顺反异构化反应

前文报道了外加磁场对吸附在硅胶表面上的芳砜光解反应的影响,本文报道外加磁场影响光化学反应的另一个例子——电子转移光敏化1,2-二苯乙烯的异构化。 近年来电子转移光敏化反应引起了有机光化学家们的极大注意。一些异构化、重排、裂解、氧化反应都可以通过电子转移机理敏化。电子转移光敏化的机理可以用(1)描述。图中A和D分别代表电子的受体和给体。     

基于解析解的四阶PDE曲面裁剪方法

该文提出了一种可以广泛应用于四阶PDE曲面的裁剪方法。利用PDE的参数域内的曲线在曲面上投影,得到所求裁剪曲面的边界曲线,然后通过边界曲线的导矢与曲面在边界曲线处的法向量得到边界曲线处的跨界导矢,最后以求得的裁剪曲面的边界曲线以及裁剪曲面在边界曲线处的跨界导矢为PDE曲面的边界条件,用四阶的PDE曲面方程求得PDE裁剪曲面。     

马钢2号高炉中修后开炉达产操作实践

对马钢2号高炉中修后开炉达产操作实践进行了总结。通过制定科学的开炉方案,快速提高煤比、降低焦比,实现了顺利开炉、快速达产达效的目标。     

Electrochemical and microstructural characterization of cyclic redox behaviour of SOFC anodes

The oxidation of Ni to NiO in solid oxide fuel cell (SOFC) anode will result in large bulk volume change, which may change the interfaces of the two phases in the anode cermet and thus may cause significant performance degradation. The reduction and oxidation (redox) of the Ni/YSZ cermet were studied at 800 ℃. Anodic polarization measurements were performed before and after redox cycles. The anode current density at an overpotential of 100 mV kept decreasing during the whole redox treatment. It decreased from 19.11 to 7.95 mA·cm-2 after two redox cycles. Anode supported unit cell was assembled for cell's discharge measurements. Cell performance declined after each redox cycle. The maximum power density decreased from 126.28 to 40.32 mW·cm-2 . The microstructural changes after redox cycling were recorded using scanning electron microscopy (SEM). The results reveal that after re-oxidation, the Ni gets coarse and has a higher porosity; the nickel network structure turns to be desultory.     

高温预析出对Al-Zn-Mg-Cu铝合金显微组织、强度和应力腐蚀抗力的影响

通过改变固溶条件 ,对Al Zn Mg Cu高强铝合金采用先高温后低温的两步固溶处理 (高温预析出 )来改善晶内和晶界的析出状态 ,研究了高温预析出对Al Zn Mg Cu铝合金的金相组织、强度和应力腐蚀性能的影响。结果表明 ,4 6 5℃高温预析出在保持较高强度和塑性的同时 ,可以改善合金的抗应力腐蚀性能     

(Short communication) Degradation of corrosion resistance of Zircaloy-4 in LiOH aqueous solution

To investigate the degradation of corrosion resistance of Zircaloy-4 in LiOH aqueous solution, SIMS (secondary ion mass spectrometry) analysis was performed to examine the profiles of Li~ , K~ , and OH~- in oxide layers formed in the same concentration (0.1 mol/L) LiOH and KOH solutions. Even though the oxide layers have an equal thickness, the penetration depth of K~ is shallower than that of Li~ , and the penetration depth of OH~- corroded in KOH solution is also shallower than that corroded in LiOH solution. It shows that the diffusion of OH~- into oxide layer is accompanied by the corresponding cation. The difference of degradation effect of LiOH and KOH solutions on the corrosion resistance of Zircaloy-4 was discussed.     

Abnormal Austenite-Ferrite Transformation Behaviors of Fe-ISi: Dilatometric Measurements

WITH THE APPEASING of competition of the totaloutput of iron and steels, the new generation of ultrahigh strength steel, based on the lessen the burden ofenvironment, double improvement of mechanicalproperties and elongation of the serving life, has beenfully outspreaded in the world. More and more researchwork shows that the solid-state microstructureevolution becomes the most effective route in thedevelopment of ultra-high strength steels. A process ofgreat interest in the steel produc…