Effect of deposition conditions on the properties and annealing behavior of cold-sprayed copper

The deposition of copper by cold gas dynamic spraying has attracted much interest in recent years due to the capability to deposit low-porosity oxide-free coatings. However, it is generally found that as-deposited copper has a signicantly greater hardness, and potentially lower ductility, than bulk material. In this article, copper was deposited by cold spraying using helium as the driving gas at both 298 and 523 K. Evidence is presented indicating that the material sprayed at the lower temperature exhibits a lower dislocation density throughout the grain structure than the material sprayed at the higher temperature. The low stacking fault energy of copper restricts recovery during annealing, and thus microstructural changes during annealing only proceed once recrystallization begins. The material sprayed at low temperature (with the low dislocation density) exhibited recrystallization at annealing temperatures as low as 373 K with a corresponding reduction in hardness. However, the copper sprayed with helium at 523 K was resistant to annealing at temperatures up to 473 K where the dislocations in the structure prevented recrystallization. However, at higher temperatures, recrystallization did proceed (with corresponding reductions in hardness). The fracture behavior of the copper that was cold sprayed with helium at 523 K, both in the as-sprayed condition and following annealing, was measured and explained in terms of the annealing mechanisms proposed. The original version of this paper was published in the CD ROM Thermal Spray Connects: Explore Its Surfacing Potential, International Thermal Spray Conference, sponsored by DVS, ASM International, and HW International Institute of Welding, Basel, Switzerland, May 2–4, 2005, DVS-Verlag GmbH, Düsseldorf, Germany.     

利用ADCP回波强度估算河流悬移质含沙量的应用研究

通过简要介绍利用声学多普勒水流剖面仪(ADCP)回波强度估算悬移质含沙量的基本原理,结合梧州水文站的应用实例,利用ADCP的回波强度数据和现场采集的水样含沙量建立相关关系,根据相关关系由回波强度反演估算的水体悬移质含沙量验证了利用ADCP的回波强度估算悬移质含沙量的可行性。应用于梧州水文站的实践表明,左河道推算的系统误差为-0.1%,右河道推算的系统误差为1.5%。这种方法具有不扰动流场、测量剖面同步性较好、数据空间分辨率较高的优点,与传统的取样过滤称量法相比,计算效率显著提高。     

汽轮发电机组负荷波动的原因分析及解决措施

详细分析了汽轮发电机组在运行过程中出现电负荷波动和瞬间突降的原因，重点介绍了如何调节、维持汽轮发电机组的经济运行以及解决电负荷波动的措施，从而保证汽轮发电机组的稳定运行。     

活性污泥法处理污水两个重要参数的理论探讨

负荷、泥龄是活性污泥法处理城市污水设计、运行中的重要参数.给出了有机负荷的动力学表达形式(称之为动力学负荷),并对有机负荷和泥龄的关系,有机负荷和泥龄对水质、污泥沉降性能影响进行了理论探讨.     

机动车制动液的研制

介绍了合成型机动车制动液的生产和配方，讨论了物料组成对产品的影响。     

Dynamic equivalent method of interconnected power systems with consideration of motor loads

The existing equivalent methods usually only deal with static load models and neglect the dynamic characteristics of loads such as induction motors.This paper presents a dynamic equivalent method which considers motor dynamics.At first,the clustering criterion of motor loads is given.The motors with similar dynamic characteristics are classified into one group.Then,reduction of motors in the same group is carried out.Finally,parameters of the equivalent motor are calculated and the equivalent system is thus...     

预应力片材加固负载RC梁受弯承载力分析

分析有初始弯矩作用时,预张纤维片材粘贴加固混凝土梁中加固材料相对该处混凝土滞后应变或超前应变的计算方法和纤维片材中有效预应力的取值;对预应力FRP粘贴加固梁构成的复合截面,分析各种可能应变组合下的受弯极限状态,给出两大弯曲破坏类型(分别由片材拉断和混凝土压碎引发)的界限判别条件和极限承载力计算表达式.试验分析表明,极限承载力试验值与计算值比值的均值为0.99,变异系数为0.047.     

采用离散元法分析路面结构的疲劳特征

为了在考虑疲劳损伤和恢复性能的基础上,获取路面结构在重复荷载作用下的疲劳特征,采用离散元方法建立了路面结构模型,并分析了在正弦重复荷载作用下路面结构沥青层底部的受力特性.由于路面荷载的随机性,分别以荷载大小、荷载间歇时间、荷载作用次序为考察对象,分析其对路面结构沥青层底受力特征的影响.研究结果表明:随着周期荷载作用次数的增大,沥青层底部拉应力快速增大至某一基础值,并在此基础值附近呈周期性波动,拉应变则在以一定幅值波动的同时,呈现整体水平先急剧增大后缓慢增大的规律;延长荷载作用的间歇时间,虽然一定程度上增大了拉应力和拉应变的波动幅值,但却显著降低了沥青层底拉应力和拉应变的整体水平;不同的荷载作用次序在沥青层底引起的应力应变状态不同,从小至大序列的荷载对沥青层造成的损伤明显小于从大至小序列的荷载.     

双洞口配筋砌块砌体框支墙梁试验

为研究双洞口配筋砌块砌体框支墙梁地震前后的受力模式,在拟动力子试验前后进行了底层框架配筋砌块短肢砌体剪力墙结构三层足尺模型的竖向力静载试验.试验结果表明:托梁与上部墙体表现出良好的协同工作能力,其工作模式为拉杆拱.通过对其在拟动力试验前后的受力模式进行了比较,可知带洞口配筋砌块砌体框支墙梁结构体系在墙体受到一定损伤时,并不会使墙梁的受力机理发生明显改变.