Practical method for generation expansion planning based on dynamic programming

This paper presents an efficient method which provides the optimal generation mix and the optimal generation construction process. The approximation method in which the dynamic programming technique and gradient method are combined is applied to determine the optimal generation mix with hydropower generation technologies. The successive approximations dynamic programming (SADP) technique, which is very suitable for high-dimensional multistage decision process problems, is used for obtaining the optimal generation construction process. The effectiveness and feasibility of the developed technique are demonstrated on a practical power system model which has five types of generation technologies including a hydropower generation technology.     

Passive least-squares-type estimation algorithm for direct adaptive control

The standard least squares (LS) estimation algorithm is modified in such a way that it becomes passive. Therefore the scope of application of the LS algorithm is extended to those adaptive schemes whose convergence proof is based on passivity. The passive version of LS is presented in both continuous and discrete time.     

A sensorless brushless dc motor system

This paper describes a brushless dc motor system without position or speed sensor. The brushless motor consists of a permanent magnet synchronous motor and a voltage-source inverter capable of controlling the amplitude and frequency of voltage. The rectangular-shaped stator current with a conducting interval of 120° (electrical) is controlled to be in phase with the trapezoidal back electromotive force. This results in producing maximum torque. Variable speed is achieved by adjusting the average motor voltage similarly to chopper control of dc motors. In this paper, two sensorless position detecting methods, i.e., an “indirect method” suited for the lower-speed range and a “direct method” suited for the higher-speed range are proposed. The combination of the two makes it possible to detect the rotor position over a wide-speed range. Furthermore, a speed-sen-sorless PLL control is proposed in applying the principle of the direct method. Experimental results obtained from a prototype brushless dc motor are shown to confirm the validity of the sensorless drive. The starting procedure of the motor also is discussed because it is impossible to detect the rotor position at a standstill.     

Synthesis and characterisation of carboxylic acid and diphenylphosphine derivatives in the 1,3-diyne series: Spectral properties of polydiacetylene carboxylates

Symmetrically substituted 1,3-diynes containing hydroxyalkyl ( 1a-d ), bromoalkyl ( 1e-h ) (diphenylphosphinyl) ( 1i-k ) and carboxyalkyl ( 2a-d ) substituents have been prepared and characterised; the phosphine derivative ( 1k ) has been converted with alkyl iodides ( RI ; R = Me, Et) into bis(phosphonium) salts ( 1l and m ). During preparation of the diynedioic acid. ( 2a ), the non-centrosymmetrical diyne, HO₂CCH₂C?C—C?C(CH₂)₂OH ( 3 ), was also isolated. ⁶⁰Co γ-Irradiation of diacetylene monomers ( 2a – d ) and 10,12-tricosadiyn-1-oic acid gave the corresponding polydiacetylene derivatives ( 4a – d and 5 ), respectively. Rubidium salts of ( 4c ) and ( 4d ), a barium salt of ( 4c ), and a potassium salt of ( 5 ) were prepared and isolated; soluble potassium salts of the carboxylic acid polymers ( 4 ) were generated in aqueous solution. The effects of changes in pH on the UV/visible absorption spectra of aqueous solutions of selected carboxylic acid polydiacetylenes have been recorded, and are discussed.     

媒体网关控制技术及其在Alcatel 5020 MGC中的应用

分析了目前公用交换电话网(PSTN)中存在的问题和下一代网络(NGN)的优越性,分析了NGN中的关键技术媒体网关控制技术,探讨了媒体网关控制技术在Alcatel5020MGC中的实际应用,讨论了Alcatel5020MGC的软硬件系统架构。最后强调了在PSTN向NGN发展过程中基于演进产品的方法的重要性。     

引黄五座泵站火灾自动报警及联动控制系统

介绍了引黄工程五座泵站的火灾自动报警系统的组成及功能，对泵站的火灾探测系统、报警系统、联动控制系统、灭火系统、控制台等原理进行了详细说明，供同行参考借鉴。     

暖通空调工程设计常见问题

通过对施工图审查工作进行总结，指出了暖通空调和防火防排烟设计中存在的问题及防火规范本身的一些不足。     

成品油汽运发货系统的研究与开发

介绍成品油传统汽运发货流程.指出其中的弊端,提出采用计算机网络化管理的思路,并对计算机成品油汽运发货系统的优点和功能进行了介绍,然后详细讨论了该系统的开发过程和功能实现,最后提出改进和发展方向。     

利用网络技术实施财务集中控制

针对企业集团分权化管理的缺点，设计出一套利用互联网络技术实现企业集团财务集中控制的模式，给出了模式的图示及说明。     

Improvement of levitation characteristics in a magnetic bearing system using HTSC‐permanent magnet hybrid structure

Magnetic bearing using pinning force of a permanent magnet and a high‐temperature superconductor has been developed. Additional permanent magnet is introduced to increase the levitation force of the magnetic bearing. In this hybrid magnetic bearing system, levitation force is mainly given by the repulsive force of the permanent magnets, and stability for the lateral direction is given by pinning force of the superconductor. The experimental device is developed. A ring‐type superconductor and a bulk one are examined. Levitation characteristics of the hybrid magnetic bearing are measured. The bulk superconductor shows better characteristics of both levitation and lateral stability than the ring one. Levitation force of the hybrid system becomes about twice as large as that of the nonhybrid one. Although, the repulsive force of the permanent magnet decreases the lateral stability of the system, its influence becomes small by choosing an adequate position of the permanent magnets and the superconductor. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 71–77, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10350