新型阳离子聚合物NCP的合成及应用

介绍了用高分子反应法在固态条件下合成高阳离子度阳离子聚合物NCP的方法,确定了其最佳反应条件,测定了聚合物阳离子度和反应效率.采用L9（34）正交试验法得出合成NCP的最佳反应条件为：聚合物与阳离子化试剂质量比为11：3;催化剂用量为1.072%,反应时间为2.5 h;反应温度为80℃.实验结果表明,在反应体系中加入催化剂和少量有机或无机溶剂可显著提高反应速率和效率;使用少量润湿剂,可最大限度地限制副反应,造成反应部位的局部浓度高,提高反应效率.阳离子聚合物NCP可作为增粘降滤失剂用于配制正电性钻井液,效果优良,且耐温性能良好,同时基于阳离子与阴离子聚合物在溶液中生成凝胶状沉淀物的特性,NCP还可用于解决注聚区块生产井产出水中含高浓度聚合物的问题.     

膨胀水泥浆体系在苏丹1/2/4区块水平井固井中的应用

随着苏丹1／2／4区块的深入开发，为了加快开发主力油层，提高原油产量，降低钻井成本，GNPOC在此区块布置水平井开发任务。所开发的区域主要分布于Heglig，Munga，Simbir，Bamboo区块，油层所在是Zaqar和Bentiue地层。此层位具有高渗透，地层温度高，易塌、气窜等复杂问题，尤其是Heglig和Munga地区井壁坍塌严重。为此，根据地质资料、井身结构和对水平井注水泥的技术要求，科学合理设计施工工艺，优选出适合此地区固井施工的冲洗液和隔离液，特别是经过努力实践，开发出了新型膨胀水泥浆体系，此体系具有高强度、低失水、无析水、防气窜之功效。结合使用哈里伯顿CPT—Y4大功率固井车，精确计量和自动密度控制，该体系水泥浆目前已在7口水平井施工中得以应用，均为优质井。现正在被大量使用，此体系的开发，解决了该固井技术难题，创造了中国固井在海外首次水平井作业一次成功的历史记录，具有较高的经济和社会效益。     

Phase equilibria of quasi-binary systems consisting of multicomponent polymers 1 and 2. IV: Poly(ethylene oxide)/poly(propylene oxide) systems

To confirm the reliability of the theory of phase equibria of multicomponent polymer 1/multicomponent polymer 2 systems (i.e. quasi-binary systems) and the method of computer experiment based on this theory (Brit. Polym. J., 23 (1990)285; 23 (1990)299; Polym. Int., 29 (1992)219), could point curves (CPC), two-phase volume ratios ( R ) and critical solution points (CSP) have been determined experimentally for the quasi-binary mixtures of poly(ethylene oxide) (M¯_w = 647, M¯_w/M¯_n = 1.15; M¯_w and M¯_n, the weight-average and numberaverage molecular weights, respectively) and poly(propylene oxide) (M¯_w = 2028, M¯_w/M¯_n = 1.08; and M_w = 2987, M_w/M_n = 1.13). The hydroxyl end groups of both polymers were methoxylated in advance by the Cooper & Booth method (Polymer, 18 (1977)164). The thermodynamic interaction parameter between both polymers, χ₁₂, and the concentration dependence parameters for the above quasi-binary systems were determined by the method proposed in a previous paper (Brit. Polym. J., 23 (1990)299). CPC, R and CSP values calculated on the basis of the theory are in good agreement with the values determined experimentally.     

放射性核素迁移的实验室研究——Ⅱ.用混合裂变产物溶液研究核素在地质材料上的吸附

应用裂变产物混合物做为示踪剂研究了~(137)Cs,~(141,144)Ce,~(103,106)Ru,~(103,106)Ru,~(95)Zr,~(95)Nb,~(89,90)Sr在花岗岩、凝灰岩、页岩上的吸附行为。应用批式技术测定了吸附比。核素的γ放射性是用连有SCORPIO-3000多道计算机系统的Ce(Li)探测器测量的。β放射性~(89,90)Sr是放化分离后在G-M计数器上测量的。结果表明:凝灰岩、页岩能强烈吸附Ce,Nb,Zr;吸附Cs居中;吸附Sr,Ru较差;花岗岩的吸附性能都差。     

Synthesis of diamond crystals and films using an oxygen-acetylene flame under atmosheric pressure

Diamond growth with rates up to 100 to 140 μm/hr was achieved using an oxygen-acetylene combustion spraying technique in an atmospheric environment. Investigations on the processing indicated that the gas flow ratio, substrate position, substrate temperature, temperature distribution, and substrate pretreatment were the most important factors affecting the growth of diamond crystals. Evaluation by means of X-ray diffraction, Raman spectroscopy, scanning electron microscopy, and electron probe microanalysis showed that the synthesized diamond was nearly perfect in morphology, structure, and purity.     

Solubility of amaranth seed proteins in sodium sulphate and sodium chloride: the main factor in quantitative extraction for analysis

Nitrogen was extracted more efficiently from amaranth seed with 0.04 M Na₂SO₄ (5% w/v) than with either 0.09 M or 0.17 M NaCl (5% or 10% w/v), despite both solutions having the same ionic strength (μ= 1). Solubility of saline soluble proteins (albumin ± globulin) was very poor in either water or 1M NaCl, but increased in 0.4M NaCl at alkaline pH between 7 and 10. Globulins were very soluble in 0.4M NaCl at a pH 9. Albumin was the main storage protein. Saline soluble proteins formed very weak gels.     

RE／S值对控轧低碳Mn－Nb－RE钢硫化物成分和形貌的影响

用扫描电镜测定了含０．０４１％～０．０７６％ＲＥ的低碳Ｍｎ－Ｎｂ－ＲＥ钢中硫化物的成分、大小和形貌。ＲＥ／Ｓ值为２．８～３．０时，钢中的硫化物充分变质。     

氨合成塔出口氨含量偏低原因分析及对策

阐述UHDE合成塔运行现状 ,分析氨净值达不到设计值的原因 ,提出相应的解决措施     

AUTOCONER-338型自动络筒机的接头工艺与切疵有效性分析

介绍了AUTOCONER-338型自动络筒机空气捻接器的接头要求与影响接头质量的因素,并且就不同品种的纱线选用不同接头工艺进行了简单分析;介绍了如何评价络筒切疵有效性与影响切疵率的因素.通过以上2方面的分析介绍,及时调整设计与工艺,提高了生产效率,改善了布面质量.     

平面药包抛掷爆破的漏斗特征解析

根据惠州港通用码头陆域平面药包抛掷爆破的实爆堆积测量分析成果 ,结合药包设计的主要参数 ,对平面药包产生的爆破漏斗的范围与形态、不同药包部位的残方比与抛掷率、药包的长抗比与圆柱体药包的应力波形演变关系予以解析 ,供硐室爆破的理论研究、模拟试验和总结条形药包特性时参考