高频脉冲电铸Ni-Co纳米复合块体微观结构分析

采用高频脉冲电铸工艺制备出了镍钴纳米复合块体材料，利用场发射扫描电镜、能谱和X射线衍射的方法，重点研究了复合块体沉积层的表面形貌、相结构和结晶取向。结果表明．高频率和润湿剂的添加对沉积层的细化有重要影响，高频脉冲电铸能够获得微观组织致密、均匀的复合块体材料。     

煤气压缩机存在问题及改造措施

对煤气压缩机运行以来所存在的问题进行了分析，相继采取的改造措施及取得的效果作了探讨。重点阐述了油冷却器的改造。     

p,V, T and derived thermodynamic data for toluene,trichloromethane, dichloromethane,acetonitrile, aniline,and n-dodecane

Experimentally determined p,V,T data are reported for toluene, trichloromethane, dichloromethane, acetonitrile, aniline, and n-dodecane at 278, 288, 298, 313, and 323 K, except for dichloromethane, for which the highest temperature was 298 K. At each temperature, measurements were done at pressures up to about 280 MPa or (for aniline and n-dodecane) at a lower pressure slightly below the freezing pressure at the temperature of measurement. Values of the isobaric expansivity isothermal compressibility and (for toluene, trichloromethane, dichloromethane, and acetonitrile) internal pressure, derived from the p,V,T data, are presented.     

Centrifugal Casting of High Speed Steel/Nodular Cast Iron Compound Roll Collar

Ｈｉｇｈ ｓｐｅｅｄｓｔｅｅｌ (ＨＳＳ) ,ｉｓｃｈａｒａｃｔｅｒｉｚｅｄｂｙｅｘ ｃｅｌｌｅｎｔｈａｒｄｎｅｓｓ ,ｗｅａｒｒｅｓｉｓｔａｎｃｅ ,ａｎｄ ｇｏｏｄｒｅｄｈａｒｄｎｅｓｓ .Ｒｅｃｅｎｔｌｙ ,ＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｈｏｔｒｏｌｌｉｎｇｒｏｌｌｓｔｏｐｒｏｄｕｃｅｓｔｒｉｐｓｏｆｇｏｏｄｓｈａｐｅａｎｄｓｍａｌｌｃｒｏｗｎｗｉｔｈｅｘｔｅｎｄｅｄｒｏｌｌｓｅｒｖｉｃｅｌｉｆｅ[1,2 ] .ＴｈｅＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｒｏｌｌｃｏｌｌａｒｆｏｒ…     

热轧高强钢平整机辊径参数设计技术研究

基于高强钢平整机的生产工艺特点,结合板形与辊耗问题,将带材的出口前张力与辊间压力横向分布都均匀作为目标函数,把保证所有被平整高强钢产品的机械性能满足产品大纲要求作为约束条件,提出了一套针对热轧高强钢平整机的工作辊与支承辊辊径参数设计模型.其研究结果对指导宝钢分公司1880 mm热轧平整机的工艺参数的确定与技术谈判发挥了重要作用,并具有进一步的推广价值.     

高密度澄清池在邯钢第二污水处理厂的应用

高密度澄清池是一种新型高效的澄清池。介绍了高密度澄清池的工艺原理、运行条件和主要参数及在邯钢第二污水处理厂的应用情况。     

深孔预裂爆破在溢洪道高边坡开挖的应用

高边坡深孔预裂爆破是一项对施工质量、安全要求极高的爆破技术, 必须进行科学的爆破技术设计,确定合理的爆破参数;高度重视爆破钻孔工艺、装药工艺、网络工艺以及边坡稳定性地质分析.在洞巴水电站中不允许采用超欠平衡的开挖方法进行施工,利用设计台阶高度,采用深孔预裂爆破对溢洪道高边坡的稳定及开挖平整度进行有效控制,取得良好效果.     

Improvement of levitation characteristics in a magnetic bearing system using HTSC‐permanent magnet hybrid structure

Magnetic bearing using pinning force of a permanent magnet and a high‐temperature superconductor has been developed. Additional permanent magnet is introduced to increase the levitation force of the magnetic bearing. In this hybrid magnetic bearing system, levitation force is mainly given by the repulsive force of the permanent magnets, and stability for the lateral direction is given by pinning force of the superconductor. The experimental device is developed. A ring‐type superconductor and a bulk one are examined. Levitation characteristics of the hybrid magnetic bearing are measured. The bulk superconductor shows better characteristics of both levitation and lateral stability than the ring one. Levitation force of the hybrid system becomes about twice as large as that of the nonhybrid one. Although, the repulsive force of the permanent magnet decreases the lateral stability of the system, its influence becomes small by choosing an adequate position of the permanent magnets and the superconductor. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 71–77, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10350     

雅克拉凝析气田高压脱水工艺的成功应用

雅克拉凝析气田位于新疆阿克苏境内，2005年11月29日建成投运的260×10⁴m³/d雅克拉集气处理站是目前中石化最大的高压凝析气处理装置。该站的高压分子筛脱水工艺为两塔流程，采用差压再生（吸附压力5.9 MPa、再生压力2.8 MPa）、再生气自动回收工艺技术，并采用时序控制程序自动切换，具有工艺简单可靠、自动化程度高、热能利用率高、脱水露点深度高、操作维护简单、投资较少、运行成本低等优点，自建成投产以来运行稳定，效果十分显著。该工艺装置的成功应用，对类似脱水装置设计、操作具有一定参考价值。     

陈垃圾土的压缩性试验研究

首先介绍了重庆市主城区填埋场的现状，论述了深入研究陈垃圾土压缩特性的重要性。作者在简要总结了采样场内陈垃圾土的基本物理性质后。通过室内侧限压缩试验(亦称固结试验)，得出了描述陈垃圾土压缩性质的基本参数，如αv、Es、mv和Cc等，试验表明陈垃圾土是一种不同于常见土类的高压缩性欠固结土，试验结果可为填埋场再利用和已封闭填埋场的沉降计算提供依据。