炭粒床高效工业除尘装置的设计与开发

The new dust removal technical route using the carbon-granular bed filter,packed of carbon particles with appropriate grade derive from an online-process vibration sieve,to replace the traditional baggy filter had been developed successfully for capturing the micro-carbon dusts produced from pulverization of petroleum coke,and the green close loop of carbon materials is thus completed in the combined pulverizing and classifying system and pulverized carbon dust removal process.The high dust removal efficiency greater than 99%,low outlet dust concentration less than 100 mg.m-3,low pressure drop through dust filtration chamber less than 980 Pa,simple and easy design,and flexible and stable operation were achieved also with the carbon-granular bed filter in both bench and industrial scale operations.     

利用ADCP回波强度估算河流悬移质含沙量的应用研究

通过简要介绍利用声学多普勒水流剖面仪(ADCP)回波强度估算悬移质含沙量的基本原理,结合梧州水文站的应用实例,利用ADCP的回波强度数据和现场采集的水样含沙量建立相关关系,根据相关关系由回波强度反演估算的水体悬移质含沙量验证了利用ADCP的回波强度估算悬移质含沙量的可行性。应用于梧州水文站的实践表明,左河道推算的系统误差为-0.1%,右河道推算的系统误差为1.5%。这种方法具有不扰动流场、测量剖面同步性较好、数据空间分辨率较高的优点,与传统的取样过滤称量法相比,计算效率显著提高。     

大面积水域浓度场测试方法及系统研究

针对大面积水域浓度场难以实现实时测量、测量精度不高等问题,采用了一种多通道荧光测试系统和方法。首先,基于单色光诱导荧光检测浓度(LIF)原理,使用探头获取离散点的浓度参数。然后,经总线或通信网络技术,将数百个测点连接起来。最后,通过数据总线或网络将采集的数据输送到中央测控计算机中,处理离散的数据后形成完整的浓度场。在恒定流浓度场中的试验结果表明,污染物测量相对误差均值不超过5%,单次测量相对误差最高值为8.33%,传感器线性度不超过5%,可检测的荧光素钠溶液浓度分辨率为0.001 ppm,系统测量稳定、精度较高。相较于其他浓度测量方法,该系统具有测量面积大、实时测量的优势,可为水污染防治等领域提供可靠的技术支撑。     

PARTICLE FLOW PATTERNS IN THE RISER AND DOWNER OF CIRCULATING FLUIDIZED BED

This paper presents an experimental study on the flow patterns of FCC particles in a 140 mm ID Circulating Fluidized Bed with concurrent upflow and downflow gas-solid suspension. Based on the distribution of local particle velocity and particle concentration measured by a Fiber-Optical Probe Laser Doppler Velocimeter and a Fiber Optical Probe System respectively, the different flow patterns of local particls concentration, local particle velocity, local particle fluctuating velocity and sectionally average particle velocity in concurrent upflow and downflow gas-solid system have been investigated. It is found that the particle flow in the concurrent downflow is much more uniform radially than that in the concurrent upflow riser. The investigation of flow patterns in different flow systems is of significance to the development of a new gas-solid reactor.     

臭氧氧化处理法对聚丙烯表面涂装性的改良 Ⅱ.臭氧浓度及臭氧发生气组成对聚丙烯表面氧化过程的影响

讨论了用臭氧氧化法对聚丙烯表面进行涂装性改良时,臭氧浓度和臭氧发生气组成对聚丙烯表面氧化过程的影响。我们发现,随臭氧浓度的增加,各种聚丙烯表面上COOH基的生成速率变大,而OH基的生成速率变小,且表面上COOH基和OH基的生成比变大。在相同的臭氧浓度下,COOH基的生成速率和聚丙烯种类无关,各种聚丙烯表面上COOH的生成速率大体相等。而OH基的生成速率及COOH基、OH基生成比和聚丙烯的种类有关,就COOH基和OH基生成比而言,其大小顺序为均聚物>嵌段共聚物>无规共聚物。臭氧发生气组成对聚丙烯表面氧化过程有很大的影响。和臭氧发生气为空气时的情况相比,当臭氧发生气为氧气时,即使其体系中臭氧浓度的变化很小,也会引起较大的表面氧吸收量或表面氧化分解量的变化。     

Surface activity of quaternary ammonium salts derived from jojoba oil

A number ofcis andtrans quatenary ammonium salts were synthesized from jojoba oil. All derivatives were found to be surface active agents, i.e., they reduced the surface tension to 35 dynes/cm⁻¹, at very low concentrations. The relationship between the surface activity and the molecular structure is discussed.     

Rheological studies on a slurry biofuel to aid in evaluating its suitability as a fuel

Biomass is an often abundant, renewable, low ash and low sulfur fuel. Due to these properties, biofuels are promising alternatives for traditional petroleum-based fuel applications; however, traditional biofuels for internal combustion engines are not cost competitive with gasoline, diesel or fuel oils. One method to reduce the cost of biofuels is to use slurry fuels which have a potential lower cost than liquid biofuels due to high conversion efficiencies. Slurry biofuels, such as a mixture of corn and water, could provide a biofuel alternative for diesel engines, pressurized gasifiers and heating oil applications such as burners or gas turbines. Use of these biomass slurries poses important questions about their stability and suitability for practical applications in internal combustion engines and combustors.This work reports rheology data for stable corn-starch water slurries (CSWS) which used a polyacrylic acid thickener to eliminate settling of the slurry and to provide desirable shear-thinning behavior for most of the compositions evaluated. The effect of shear rate on the viscosity of the CSWS was studied using a BOHLIN-controlled stress (CS) rheometer. The well-known Ostwald—de Waele power law and Sisko models for viscosity fit the data. The effect of corn starch content, thickener content and temperature on the viscosity of CSWS was also studied. The favorable shear thinning properties were observed for starch contents up to 45% starch and should aid pumping, injection and spraying. The lower heating values of the slurries, however, are undesirably low.     

Strong dependence on pressure of the performance of a Co/SiO2 catalyst in Fischer–Tropsch slurry reactor synthesis

A 10 wt% Co/SiO₂ catalyst was prepared by the incipient wet-impregnation method and tested in Fischer–Tropsch synthesis in a slurry reactor under conditions approaching industrial practice. The catalyst precursor was investigated by X-ray diffraction (XRD), temperature-programmed reduction (TPR), transmission electron microscopy (TEM) and photoelectron spectroscopy (XPS). The XPS and XRD techniques revealed the presence of a crystalline Co₃O₄ spinel-type phase, while-in addition-TEM and XPS analyses pointed to the formation of another amorphous Co₃O₄ spinel phase, both species interacting weakly with the silica substrate. The influence of total pressure on the conversion, selectivity and stability of the catalyst was studied. Upon increasing the overall pressure from 20 to 40 bar, not only activity increased but also the catalyst are not deactivating. These results are explained in terms of an increase of gases solubility in the solvent, this increment of CO concentration in the liquid phase favours carbonyl species formation and the cobalt particles segregation that implies an increase in the metal surface area.     

Analysis of pentasodium triphosphate hydration kinetics

The present work analyzes the effect of various factors on the hydration of pentasodium triphosphate. The experimental method is based on application of the hydration test. Technical-quality products with different proportions of phase I and phase II have been used. The variables studied are phase I/phase II ratio, initial temperature, particle size, stirring rate and composition of the slurry (presence of hexahydrate crystals and water hardness). The results have been discussed according to a kinetics model that includes a series of stages of a physical nature (dissolution of anhydrous salt and the crystallization of the hexahydrate), as well as of a chemical nature (solvation of the ions in solution). Crystallization of the hexahydrate may be the controlling stage in the process.     

不饱和聚酯树脂光固化工艺的研究-光引发剂浓度

本文选用TPO、651两种光引发剂，分别配制引发剂浓度为0．25、0．5、1、2wt％的不饱和聚酯体系。通过测定光固化试样的显微硬度分析光引发剂浓度对固化程度的影响。结果表明，提高引发剂浓度能抑制氧阻聚的作用，但对于较厚的试样，引发剂浓度过高会导致固化不完全。