二维地震过障碍观测系统模式及其参数设计

在二维地震勘探中,为了避免因地表障碍物使地震反射剖面出现间断现象,需要改变观测系统设计,跨越障碍物(江河、城镇等),以保证反射同相轴能连续追踪对比。在以往地震勘探中,有时因过障碍观测系统设计不合理,不但增加勘探费用,而且影响采集质量。因此只有科学合理地设计过障碍观测系统模式和参数,才能保证地震测线顺利通过障碍物,得到较好的障碍物下方的地震资料并降低勘探成本。为此本文在调查和研究大量野外实际的过障碍观测系统的基础上,总结归纳成三大类过障碍观测系统模式,并分析其特点和应用范围。采用图解法,推导出主要模式的跨越宽度、最小炮检距及最大炮检距等参数公式。采用这套过障碍观测模式不仅可以得到和障碍区两侧等质量的地震资料,而且可以有效地降低勘探成本。     

乙苯/苯乙烯塔分离效率问题的技术分析及整改措施

分析了齐鲁分公司200kt/a乙苯/苯乙烯装置乙苯/苯乙烯塔(T-401)分离效率低的原因,即降液管设计偏小,液体在降液管内流速过快,引起液体飞溅;安装分布器使用的石棉垫片溶胀而粉碎后堵塞了分布槽;分布器上使用的垫片脱落形成缝隙而漏液;填料装得不密实,留有缝隙;二级分布槽变形等.针对存在问题提出了相应的整改措施,并考察了整改措施实施效果.结果表明,整改后该塔的分离能力满足了工艺要求,并有一定的操作弹性.     

Phase equilibria of quasi-binary systems consisting of multicomponent polymers 1 and 2. IV: Poly(ethylene oxide)/poly(propylene oxide) systems

To confirm the reliability of the theory of phase equibria of multicomponent polymer 1/multicomponent polymer 2 systems (i.e. quasi-binary systems) and the method of computer experiment based on this theory (Brit. Polym. J., 23 (1990)285; 23 (1990)299; Polym. Int., 29 (1992)219), could point curves (CPC), two-phase volume ratios ( R ) and critical solution points (CSP) have been determined experimentally for the quasi-binary mixtures of poly(ethylene oxide) (M¯_w = 647, M¯_w/M¯_n = 1.15; M¯_w and M¯_n, the weight-average and numberaverage molecular weights, respectively) and poly(propylene oxide) (M¯_w = 2028, M¯_w/M¯_n = 1.08; and M_w = 2987, M_w/M_n = 1.13). The hydroxyl end groups of both polymers were methoxylated in advance by the Cooper & Booth method (Polymer, 18 (1977)164). The thermodynamic interaction parameter between both polymers, χ₁₂, and the concentration dependence parameters for the above quasi-binary systems were determined by the method proposed in a previous paper (Brit. Polym. J., 23 (1990)299). CPC, R and CSP values calculated on the basis of the theory are in good agreement with the values determined experimentally.     

剂量率对聚四氟乙烯辐射裂解的影响

本文研究了在以电子加速器的电子射线为辐射源时,剂量率对PTFE辐射裂解的影响。在剂量相同的条件下,剂量率从1.44×10~4 rad/s增至5.75×10~4 rad/s,裂解效率提高3.3倍。剂量率和各断裂参数(单位剂量裂解度a_0,G(s)值等)均成线性关系。当裂解度一定时,剂量率与剂量成反变关系。     

机械制造技术实践教学的探索

为提高高职学生的技术应用能力，机械制造技术作为机械制造专业的主干课，应配合不同阶段，形式多样的实践教学。本对机械制造技术实践课程的实施作了一定程度的探索，提出了一些可行性建议。     

Fiber-Optic Sensors: Technical and Market Trends

Progress in the area of fiber-optic sensors throughout the world since 1990 is analyzed. Current technical and market trends as well as the use of sensors in industry and health care are considered. Market forecasts for the use of fiber-optic sensors are given.     

广西某矿区托帕石的宝石学特征

广西某矿区的脉石矿物——黄玉分三个世代,其中第三世代的黄玉晶体无色透明,重量大于0.9克拉,瑕疵不明显,密度(3.50)、硬度(7.8430)和折射率(1.6330)等特征均达宝石级,经系统研究测试,可以命名为托帕石(Topaz)。     

STM tunneling spectroscopy on high Tc superconductors

STM tunneling spectroscopy has been performed on the bulk single crystals of BiSrCaCuO (BSCCO) and the epitaxial thin films of YBaCuO (YBCO) at cryogenic temperatures. The STM images and tunneling spectra observed on the (001) surfaces can be classified into three cases; 1) Atomic image is visible. However, the tunneling spectrum shows semiconducting or smeared superconducting gap structures, depending on the tip-sample distance. 2) Clear atomic image can not be obtained. But, the tunneling spectrum shows flat bottom region with quite low zero bias conductance. 3) Tunneling spectra demonstrate gapless behavior, independent of the tip-sample separation. These observations support the quasi-2D electronic picture in whichs-wave like 2D superconducting layers are coupled with each other through the Josephson effect.     

MTBE生产工艺的技术改进

通过对传统MTBE装置工艺流程进行分析 ,找出了各个操作单元存在的问题 ,并结合实际操作数据 ,逐一提出了具体的解决方案 ,进一步优化了传统醚化装置工艺流程。达到了生产装置规模不变 ,而投资大大减少的目的。给今后新上同类装置的工艺流程设计 ,提供了较好的技术借鉴。     

贵冶动力中心二期反渗透系统改造

本文阐述对贵冶动力车间二期反渗透进行改造的成功实践 ,主要从反渗透系统设计、反渗透系统中容易出现的问题及解决方法等进行介绍。