基于残差决策的自动飞行控制系统远程实时故障诊断

针对自动飞行控制系统结构复杂、关联部件众多,发生故障时诊断时间长,从而影响飞机运行效率的问题,提出一种基于飞机通信寻址报告系统(ACARS)的远程实时故障诊断方案。首先,分析自动飞行控制系统的故障特点,设计搭建检测滤波器;然后,利用ACARS数据链实时发送的自动飞行控制系统的关键信息进行相关部件的残差计算,并根据残差决策算法进行故障诊断及定位;最后,针对不同故障部件残差间的差异大、决策门限无法统一的缺点,提出基于二次差值的残差决策改进算法,减缓了检测对象的整体变化趋势,降低了随机噪声和干扰的影响,避免了将瞬态故障诊断为系统故障的情况。实验仿真结果表明,基于二次差值的改进残差决策算法避免了多决策门限的复杂性,在采样时间为0.1 s的情况下,故障检测所需时间大约为2 s,故障检测时间大幅降低,有效故障检测率大于90%。     

Cathode plasma electrolytic deposition of Al2O3 coatings doped with SiC particles

Semiconductor particles doped Al₂O₃ coatings were prepared by cathode plasma electrolytic deposition in Al(NO₃)₃ electrolyte dispersed with SiC micro- and nano-particles (average particle sizes of 0.5–1.7?µm and 40?nm respectively). The effects of the concentrations and particle sizes of the SiC on the microstructures and tribological performances of the composite coatings were studied. In comparison with the case of dispersing with SiC microparticles, the dispersion of SiC nanoparticles in the coatings was more uniform. When the concentration of SiC nanoparticles was 5?g/L, the surface roughness of the composite coating was reduced by 63%, compared with that of the unmodified coating. Friction results demonstrated that the addition of 5?g/L SiC nanoparticles reduced the friction coefficient from 0.60 to 0.38 and decreased the wear volume under dry friction. The current density and bath voltage were measured to analyze the effects of SiC particles on the deposition process. The results showed that the SiC particles could alter the electrical behavior of the coatings during the deposition process, weaken the bombardment of the plasma, and improve the structures of the coatings.     

吉林台混凝土面板砂砾-堆石坝砂砾排水料特性试验

吉林台一级水电站大坝为混凝土面板砂砾-堆石坝,大坝运用中能及时地排除坝体内的水是大坝安全运行的关键之一。该坝体内设置的排水通道是由料场开采的砂砾料经筛分填筑而成。为掌握该排水料的特性,对其进行了颗粒大小分析,密度、含水率、渗透系数等试验;同时也进行了不同含水情况下的碾压施工参数试验。为该砂砾料在坝工中的应用提供了重要资料,满足了工程要求。     

弹道靶道测量精度检测方法之探讨

该文分析了弹道靶道测量中的精度问题及通常使用的静态检测方法,并针对静态检测与靶道实测相差甚远的问题,提出了一种动态检测方法.该方法充分考虑到弹道靶道的测量对象是高速飞行体以及照片质量、气流附面层、发射时的恶劣环境和振动等因素对测量精度的影响,结合误差理论,给出了动态精度的计算公式,在已建成的IB-12中间弹道靶道中应用,效果良好.     

Coal liquefaction using a hydrogenated creosote oil solvent: H-atom transfer from hydrogen donor components in the solvent

The presence of hydroaromatic, hydrogen donor components in a coal-derived solvent is one of the more important factors in the successful operation of a non-catalytic coal liquefaction process. Various hydrogen donor species present in a hydrogenated creosote oil have been identified. Their rate of disappearance under conditions that are consistent with a short residence time coal liquefaction process has been used to rank the reactivities of the various hydrogen donors. 1,2,3,10b-Tetrahydrofluoranthene was found to be an exceptional donor while 4,5-dihydropyrene, the hexahydropyrenes and 9,10-dihydrophenanthrene were found to be quite active. Sym.-octahydrophenanthrene and 2a,3,4,5-tetrahydroacenaphthene exhibited moderate activity. Tetralin and the four methyltetralin isomers were found to be unreactive under the coal liquefaction conditions employed.     

二滩水电站油、水、风系统设备运行与改造

水电站辅助设备的运行直接影响水电站运行的安全性和可靠性。二滩水电站投运初期，油、水、风系统先后出现了许多问题，通过应用新产品和新技术对其进行了改造。为水电厂辅助设备的设计、选型、安装提供了宝贵的经验，并对水电厂辅助设备的检修、调试和运行维护有一定的指导作用。     

硫酸铈和磷酸处理对铌酸表面酸度及催化活性的影响

用硫酸铈和磷酸对固体铌酸进行了表面处理。表面酸度和TG DTA测定结果表明 ,与未处理的固体铌酸相比 ,处理后表面强酸量提高 3～ 5倍 ,耐受温度由 30 0℃提高到 5 0 0～ 6 0 0℃。用于催化酯化合成二甘醇二苯甲酸酯增塑剂 ,处理后固体铌酸的催化活性和重复使用寿命有明显提高。     

新型改性有机硅防水剂合成工艺研究

利用丙烯酸系单体对普通有机硅防水剂进行改性,合成一种新型的改性有机硅防水剂。丙烯酸系单体比例为5%～13%,A、B2种表面活性剂复合使用且m(A)∶m(B)=1∶1时,对有机硅的改性效果最好。     

浸入凝胶法聚合物膜形成机理的研究现状

从热力学、传质动力学、相分离机制和固化过程几方面综述了浸入凝胶过程中聚合物膜形成机理的研究现状 .指出浸入凝胶成膜过程是传质交换和由传质交换引发的相分离以及其后的固化过程之间相互竞争的复杂非平衡过程 ,膜结构是上述几个过程竞争的结果