Preparation and antibacterial activity of novel fluoroalkyl end-capped oligomers/silica nanocomposites-encapsulated low molecular biocides

Fluoroalkyl end-capped N-(1,1-dimethyl-3-oxobutyl)acrylamide oligomer [R_F-(DOBAA) _n -R_F] reacted with tetraethoxysilane (TEOS) and silica nanoparticles in the presence of low-molecular weight biocides such as hibitane, hinokitiol, and hinokioil under alkaline conditions to afford R_F-(DOBAA) _n -R_F/silica nanocomposites-encapsulated these biocides in excellent to moderate isolated yields. Fluoroalkyl end-capped N,N-dimethylacrylamide oligomer [R_F-(DMAA) _n -R_F] and acrylic acid oligomer [R_F-(ACA) _n -R_F]/silica nanocomposites-encapsulated hibitane were obtained under similar conditions. Dynamic light scattering measurements showed that the size of these fluorinated nanocomposites-encapsulated biocides thus obtained is nanometer size-controlled. Additionally, these fluorinated nanocomposites were shown to have a good dispersibility and stability in methanol and water. Of particular interest, these fluorinated nanocomposites-encapsulated biocides were found to have a good antibacterial activity against Staphylococcus aureus, and these nanocomposites were applied to the surface modification of traditional organic polymers such as poly(methyl methacrylate).     

Transmittance and cathodoluminescence of AlN ceramics sintered with Ca3Al2O6 as sintering additive

Aluminum nitride ceramics were prepared by sintering with 0–4.8 mass% of Ca₃Al₂O₆ (C₃A) as a sintering additive. The transmittance in the range of 260–550 nm increased with increasing amount of C₃A. The cathodoluminescence intensity attributed to oxygen-induced defects decreased with increasing amount of C₃A. From the results, the increase of the transmittance in the range of 260–550 nm was considered to be related to the decrease of the oxygen-induced defect density.     

Formation of toxic aldehydes in cod liver oil after ultraviolet irradiation

Formaldehyde, acrolein, malonaldehyde (MA), acetaldehyde and propanal produced from cod liver oil upon ultraviolet irradiation (λ_max=300 nm) were derivatized into nitrogenor sulfur-containing compounds and then analyzed by capillary gas chromatography with a nitrogen-phosphorus detector or a flame photometric detector. Acrolein and MA were formed at levels of 10.9±3.06 and 190.2±38.4 nmol/mg of fish oil, respectively. Maximum levels of formaldehyde, acetaldehyde and propanal formed were 7.0±0.90, 49.1±4.5 and 35.8±4.0 nmol/mg of oil, respectively. Formation of propanal in large quantities corresponded to the high content of ɛ-3 fatty acids in cod liver oil.     

Intussusception caused by a carcinoma of the cecum during pregnancy: report of a case and review of the literature

Respiratory infections are the most common infection in children. They differ remarkably according to age, bacteria and viruses. Therefore a careful history of outbreak, age, former infections, involvement of surroundings, symptoms, etc are essential. The present study included 50 children, aged between 0.3 and 12 yrs, all treated ambulatorily. 21 received brodimoprim (B) and 29 erythromycin (E). Indications were: tonsillitis, bronchitis, otitis media, sinusitis and scarlet fever. Dosages were: B was given 10 mg/kg body weight (b.w.) initially followed by 5 mg/kg b.w., once-a-day. The duration of treatment varied between 4 and 14 days (mean 8.3 days). E was given 30.50 mg/kg b.w. 3 times per day; duration 4 to 14 days (mean 8.6 days). Overall results were: in group B:12 cures, 5 improvements, 3 failures; 1 not assessable. In group E: 20 cures, 8 improvements, 1 failure. Side effects: in group B: vomiting (1), skin reaction (2), discontinuation (2); in group E: skin reaction (1), diarrhea (5), diarrhea+vomiting (1); discontinuation (2). The differences in efficacy and tolerability in the two groups are not statistically significant. The improved compliance with a single versus t.i.d. dosages has to be taken into account.     

A new type of arc plasma reactor with 12-phase alternating current discharge for synthesis of carbon nanotubes

A new type of arc plasma reactor with 12-phase alternating current (AC) discharge for synthesis of carbon nanotubes (CNTs) is proposed. A couple of six discharge electrodes by which have mutually electrical connection between them to enlarge the high-temperature regions in the reactor are arranged to three-dimensional locations. A new method of CNTs fabrication by this reactor, which accomplishes to enlarge the suitable growth region in high purity and at high yield, was developed.     

Generation of adaptive gait patterns for quadruped robot with CPG network including motor dynamic model

This paper describes the generation of adaptive gait patterns using new Central Pattern Generators (CPGs) including motor dynamic models for a quadruped robot under various environments. The CPGs act as the flexible oscillators of the joints and adjust joint angles to required values. The CPGs are interconnected with each other and sets of their coupling parameters are adjusted by a genetic algorithm so that the quadruped robot can realize stable and adequate gait patterns. Generation of gait patterns results in the formation of the CPG networks suitable for the formation of not only a straight walking pattern but also of rotating gait patterns. Experimental results demonstrate that the proposed CPG networks are effective for the automatic adjustment of the adaptive gait patterns for the tested quadruped robot under various environments. Furthermore, the target tracking control based on image processing is achieved by combining the general gait patterns. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(1): 35–43, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20225     

Stress intensity factors of microstructurally small crack

The stress intensity factor (SIF) is widely used for evaluating integrity of cracked components. Averaging the anisotropy of each crystal, the macroscopic behavior of polycrystalline materials is isotropic and homogenous in terms of elastic deformation. However, the anisotropic and/or inhomogeneous property influences on the stress field around a crack if the crack size is small in comparison with the grain. Thus, the SIF of the microstructurally small crack may differ from that in the isotropic body. In present study, the effect of anisotropic/inhomogeneous elasticity on the SIF is investigated by using the finite element analysis (FEA). At first, the SIFs of semi-circular crack in a single crystal and a polycrystalline material are calculated. These reveal that the magnitude of SIF is dependent not only on the crystal orientation but also on the deformation constraint by the neighboring crystals. Then, the statistical scatter of SIF due to the random orientation of crystal orientation in a polycrystal is examined by a Monte Carlo simulation.     

The blocking barrier effect on aluminum electromigration due totitanium layers in multilayered interconnects of LSI's

Experimental evidence of an increase in the resistance of a cathode-side metal line without any void generation is presented for a multilayered metal structure terminated by via-holes during electromigration tests. This resistance increase is reversed to the initial value by high temperature storage after electromigration testing. The increase in the resistance of multilayered metal structures is attributed to the vacancy accumulation in the cathode side due to the blocking barrier effect of the refractory metal layer in the via-hole