Modulation of electrical transport in calcium cobaltite ceramics and thick films through microstructure control and doping

Ca₃Co₄O₉ is a promising p-type thermoelectric oxide material having intrinsically low thermal conductivity. With low cost and opportunities for automatic large scale production, thick film technologies offer considerable potential for a new generation of micro-sized thermoelectric coolers or generators. Here, based on the chemical composition optimized by traditional solid state reaction for bulk samples, we present a viable approach to modulating the electrical transport properties of screen-printed calcium cobaltite thick films through control of the microstructural evolution by optimized heat-treatment. XRD and TEM analysis confirmed the formation of high-quality calcium cobaltite grains. By creating 2.0 at% cobalt deficiency in Ca_2.7Bi_0.3Co₄O_9+δ, the pressureless sintered ceramics reached the highest power factor of 98.0 μWm^?1 K^-2 at 823 K, through enhancement of electrical conductivity by reduction of poorly conducting secondary phases. Subsequently, textured thick films of Ca_2.7Bi_0.3Co_3.92O_9+δ were efficiently tailored by controlling the sintering temperature and holding time. Optimized Ca_2.7Bi_0.3Co_3.92O_9+δ thick films sintered at 1203 K for 8 h exhibited the maximum power factor of 55.5 μWm^?1 K^-2 at 673 K through microstructure control.     

Optimized PI+ load–frequency controller using BWNN approach for an interconnected reheat power system with RFB and hydrogen electrolyser units

This paper investigates a renewable energy resource’s application to the Load–Frequency Control of interconnected power system. The Proportional-Integral (PI) controllers are replaced with Proportional-Integral Plus (PI+) controllers in a two area interconnected thermal power system without/with the fast acting energy storage devices and are designed based on Control Performance Standards (CPS) using conventional/Beta Wavelet Neural Network (BWNN) approaches. The energy storing devices Hydrogen generative Aqua Electroliser (HAE) with Fuel cell and Redox Flow Battery (RFB) are incorporated to the two area interconnected thermal power system to efficiently damp out the electromechanical oscillations in the power system because of their inherent efficient storage capacity in addition to the kinetic energy of the generator rotor, which can share the sudden changes in power requirements. The system was simulated and the frequency deviations in area 1 and area 2 and tie-line power deviations for 5% step- load disturbance in area 1 are obtained. The comparison of frequency deviations and tie-line power deviations of the two area interconnected thermal power system with HAE and RFB designed with BWNN controller reveals that the PI+ controller designed using BWNN approach is found to be superior than that of output response obtained using PI+ controller. Moreover the BWNN based PI+ controller exhibits a better transient and steady state response for the interconnected power system with Hydrogen generative Aqua Electroliser (AE) unit than that of the system with Redox Flow Battery (RFB) unit.     

某矿快速掘进最优炮孔间距的选择

山西某矿5308底抽巷在掘进过程中速度慢、效率低，直接影响工作面的瓦斯抽采，为了改善上述情形，对炮孔间距进行研究。通过使用ANSYS软件对不同炮孔间距下快速掘进效果的模拟分析，并经现场验证，得出了适应该矿的最佳炮孔间距。结果表明：炮孔间距为500 mm时，爆破产生裂隙发育范围和岩石损伤区域都最大，快速掘进的效果最好。     

简化形式的系统EMC预测分析技术概述

本文探讨了系统级简化形式的电磁兼容性预测分析方法，该方法对于只有几对发-收干扰对的系统EMI的预测分析简洁有效，它避免了大系统间繁复的建模与大量的数据采集及其计算工作，从而对于只考虑其结果的系统间的EMC预测分析提高了效率。     

DS90C363/DS90CF364 LVDS发送/接收器在数字RGB液晶屏上的应用

通过在FPD铁路上使用LVDS技术可使具有数字RGB接口的液晶显示屏的工作距离大大增加。文章通过一个具体应用环境介绍了21位LVDS发送器/接收器DS90C363/DS90CF364传输套片的主要特性、引脚功能、工作原理，同时指出了在具体设计使用时的注意事项。     

我国建筑石油沥青标准的沿革及现状

论述了我国建筑沥青标准的变化历程及现状,对我国建筑沥青的生产、产品质量情况及现行国家标准GB/T 494-1998《建筑石油沥青》的不足之处进行了分析。提出了今后应生产的建筑沥青品种及应参照美国材料与试验协会标准ASTM D312《屋顶用沥青的标准规格》、我国石化行业标准SH/T0002-1990(1998)《防水防潮石油沥青》,修订GB/T494- 1998的建议。以进一步达到增加建筑沥青牌号,提高建筑沥青质量和使用性能的目的,满足建筑工业的发展对沥青多牌号、高质量、使用性能好的要求。     

大型弧形闸门静力特性有限元分析

以某水电站溢洪道弧形闸门为例,建立了大型弧形闸门的有限元分析模型,应用ANSYS软件对其在各种工况下的支铰反力、闸门应力、位移挠度以及屈曲失稳等静力特性进行了计算分析,为完善闸门结构的设计提供了依据,对同类闸门结构的设计计算有参考意义。     

H.264/AVC技术进展及其务实发展策略思考

结合NGN及3G演进的固定、移动视频业务实际需求状况，论述H．264／AVC的重要技术进展及其务实发展策略。     

PLC的大型牵伸卷绕机的应用研究

本文介绍了大型牵伸卷绕机的计算机控制系统，以西门子MMV型变频器为驱动装置，西门子PLC300为控制核心，根据西门子USS协议和MPI协议，实现PLC与变频器、TP27触摸显示屏的通信，取得了较高的控制精度和稳定性，充分满足生产过程的需要，具有广阔的应用前景。