Inhibitory effects of curcumin and piperine on fluorescent advanced glycation end products formation in a bovine serum albumin–fructose model

This study investigated the inhibitory effects of curcumin and piperine on fluorescent advanced glycation end products (fAGEs) formation in a bovine serum albumin (BSA)–fructose model. Model systems of BSA and fructose were prepared, and curcumin or piperine was added. fAGEs and BSA oxidation product (dityrosine, kynurenine and N'-formylkynurenine) contents were determined. The results showed that fAGEs content decreased with increasing concentration of curcumin and piperine (P < 0.05). Addition of curcumin and piperine at 160 µg mL⁻¹ could inhibit fluorescent AGEs by 100% and 93% respectively. Dityrosine and N'-formylkynurenine contents decreased as curcumin and piperine concentration increased (P < 0.05). Furthermore, the result of principal component analysis indicated that curcumin and piperine markedly impeded BSA oxidation, resulting in a lower level of fAGEs in model systems. Therefore, adding curcumin and piperine may facilitate reduced fAGEs levels in BSA–fructose model.     

A dotted nanowire arrayed by 5 nm sized palladium and nickel composite nanopaticles showing significant electrocatalytic activity towards ethanol oxidation reaction (EOR)

To the best of our knowledge, this is the first time to report the preparation of a dotted nanowire arrayed by 5 nm sized palladium and nickel composite nanoparticles (denoted as Pd_xNi_y NPs) via a hydrothermal method using NU and PdO·H₂O as the starting materials. The samples prepared at the mass ratio of NU to PdO·H₂O 1:1, 1:2 and 2:1 were, respectively, nominated as catalyst c₁, c₂ and c₃. The chemical compositions of all synthesized catalysts were mainly studied by using X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS), revealing that metallic Ni was one main component of all prepared catalysts. Surprisingly, the main diffraction peaks appearing in the XRD patterns of all prepared catalysts were assigned to the metallic Ni rather than the metallic Pd. Very interestingly, as indicated by the TEM images, a large number of dotted nanowires arrayed by numerous equidistant 5 nm sized nanoparticles were distinctly exhibited in catalyst c₁. More importantly, when being used as electrocatalysts for EOR, all prepared catalysts exhibited an evident electrocatalytic activity towards EOR. In the cyclic voltammetry (CV) test, the peak current density of the forward peak of EOR on catalyst c₁ measured at 50 mV s^?1 was as high as 56.1 mA cm^?2, being almost 9 times higher than that of EOR on catalyst c₃ (6.3 mA cm^?2). Particularly, the polarized current density of EOR on catalyst c₁ at 3600 s, as indicated by the chronoamperometry (CA) experiment, was still maintained to be around 1.47 mA cm^?2, a value higher than the latest reported data of 1.3 mA cm^?2 (measured on the pure Pd/C electrode). Presenting a novel method to prepare dotted nanowires arranged by 5 nm sized nanoparticles and showing the significant eletrocatalytic activities of the newly prepared dotted nanowires towards EOR were the major contributions of this preliminary work.     

Crowding as an Agronomic Factor Determining the Development of Plants and the Productivity of Linseed (Linum usitatissimum L.)

ABSTRACT

Nine sowing densities of linseed were compared in a two-year experiment. Self-regulation of the density of a linseed stand resulted in a differentiated branching of the plants. The number of capsules on a linseed shoot, as well as seeds in the capsule, and the number of seeds from the shoot were highly varied from year to year, and there is even a stronger differentiation in the weight of 1000 seeds. Linear relationships were noted between the mass of seeds from the linseed plant and the number of capsules. The yield of linseed was affected by both factors. An increasing sowing rate reduced the seed yield from the shoot and the plant. At lower seeding rates, the lateral shoots contributed in the seeds yield of the plant to a higher degree compared to the main ones.     

Uncertainties in the determination of pyrrolizidine alkaloid levels in naturally contaminated honeys and comparison of results obtained by different analytical approaches

The contamination of honey with hepatotoxic pyrrolizidine alkaloids (PAs) is a well-known hazard for food safety. While management strategies and controls of the honey industry aim to reduce the PA levels, uncertainties remain with regard to the safety of regionally produced and marketed honey. In addition, a previous study showed large differences of results obtained after various periods of storage and apparent differences between the analytical results of different laboratories. Therefore, this study aimed at examining these uncertainties by monitoring the impact of storage on the PA and PA N-oxide (PANO) content of two freshly harvested honeys and on possible demixing effects caused by pollen settling. Additionally, three analytical approaches – target analysis with matrix-matched calibration or standard addition and a sum parameter method – were applied for a comparative analysis of 20 honeys harvested in summer 2016. All samples originated from Schleswig-Holstein in Northern Germany where the PA plant Jacobaea vulgaris is currently observed on a massive scale. The results of the time series analyses showed that PANO levels markedly decreased within a few weeks and practically reached the LOD 16 weeks after harvest. Tertiary PAs, by contrast, remained stable and did not increase as a consequence of PANO decrease. The experiments on a putative demixing, which may result in a heterogeneous distribution of PAs/PANOs, revealed that there was no such effect during storage of up to 12 weeks. A comparison of the PA/PANO levels obtained by different analytical approaches showed that in some cases the sum parameter method yielded much higher levels than the target approaches, whereas in other cases, the target analysis with standard addition found higher levels than the other two methods. In summary, the results of this study highlight uncertainties regarding the validity and comparability of analytical results and consequently regarding health risk assessment.     

A red code triggers an unintended approach motivation toward sweet ultra-processed foods: Possible implications for front-of-pack labels

Front-of-package labels (FOPL) are recommended to reduce consumer intake of ultra-processed food products (UPP). The multiple traffic-light label is one example of FOPL that indicates the content of target nutrients in products by displaying red (high), amber (medium), and/or green (low) color-coding. The red code may implicitly enhance sweetness perception and approach dispositions toward sweet UPP via cross-modal visual-taste interactions. We conducted two experiments to examine the possibility of contradictory influence of explicitly learned and implicit cross-modal associations on the emotional responses evoked by UPP pictures. In both experiments, we first explicitly associated the color codes with health-related meanings. In Experiment I (n = 78), a psychometric tool estimated the emotional responses (pleasantness and arousal ratings) evoked by UPP pictures when preceded by red, amber, or green color-codes. In Experiment II (n = 24), we recorded participants’ electrocortical brain activity to assess the early posterior negativity (EPN) component as an index of the emotional responses to UPP. The reported pleasantness (Experiment I) and the EPN amplitude (Experiment II) were greater for sweet UPP relative to salty UPP when primed with red codes but not when primed with green or amber. A red code increased positive emotions toward sweet UPP despite its explicit association with increased health-risks. Thus, the use of multiple traffic-lights might lead to an unintended implicit approach behavior toward sweet UPP. Designers, researchers, and policy makers may consider color-taste cross-modal associations when designing, testing, and applying FOPL.     

Ergonomics interventions to reduce musculoskeletal risk factors in a truck manufacturing plant

Ergonomic interventions may potentially reduce MSDs, but the context of industries (barriers, ever-changing situations, dialogue processes) might play a significant role in the success of interventions. This study evaluates the effectiveness of ergonomic interventions including engineering/technical and organizational interventions, and the involvement of the stakeholders in reducing musculoskeletal risk factors/symptoms. A pre-post-test experimental study in non-randomized groups was performed over three years in a sector of a truck assembly plant. The mean age of the operators in the sector for the initial and second assessment time was 42.0 (±7.6) years and 39.0 (±8.7), respectively. The mean length of work experience in the current job was 15.2 (±7.2) years and 13.9 (±7.3) for the initial and second assessment times, respectively. Five engineering ergonomic solutions and organizational interventions were implemented after a comprehensive ergonomic analysis. The organizational interventions consisted mostly of transferring and redistributing the tasks, i.e., ergonomically balancing and redesigning of the workstations. Before performing the interventions, the findings of the ergonomic study were presented at several meetings to encourage the involvement of the stakeholders (including managers, engineers, and operators) in the interventions. This study showed that a combination of ergonomic measures—engineering and organizational interventions—could reduce physical workloads. Musculoskeletal symptoms decreased after interventions although the difference was not significant.