全文获取类型
收费全文 | 39466篇 |
免费 | 4190篇 |
国内免费 | 2586篇 |
专业分类
电工技术 | 2986篇 |
综合类 | 4473篇 |
化学工业 | 3056篇 |
金属工艺 | 1721篇 |
机械仪表 | 1893篇 |
建筑科学 | 4796篇 |
矿业工程 | 2276篇 |
能源动力 | 1309篇 |
轻工业 | 1543篇 |
水利工程 | 3071篇 |
石油天然气 | 2025篇 |
武器工业 | 296篇 |
无线电 | 6820篇 |
一般工业技术 | 2321篇 |
冶金工业 | 1803篇 |
原子能技术 | 511篇 |
自动化技术 | 5342篇 |
出版年
2024年 | 167篇 |
2023年 | 475篇 |
2022年 | 921篇 |
2021年 | 1079篇 |
2020年 | 1111篇 |
2019年 | 955篇 |
2018年 | 905篇 |
2017年 | 1195篇 |
2016年 | 1264篇 |
2015年 | 1494篇 |
2014年 | 2380篇 |
2013年 | 2139篇 |
2012年 | 2882篇 |
2011年 | 3124篇 |
2010年 | 2431篇 |
2009年 | 2499篇 |
2008年 | 2342篇 |
2007年 | 2830篇 |
2006年 | 2592篇 |
2005年 | 2302篇 |
2004年 | 1926篇 |
2003年 | 1679篇 |
2002年 | 1384篇 |
2001年 | 1181篇 |
2000年 | 924篇 |
1999年 | 772篇 |
1998年 | 573篇 |
1997年 | 528篇 |
1996年 | 432篇 |
1995年 | 394篇 |
1994年 | 326篇 |
1993年 | 217篇 |
1992年 | 198篇 |
1991年 | 128篇 |
1990年 | 105篇 |
1989年 | 88篇 |
1988年 | 58篇 |
1987年 | 63篇 |
1986年 | 26篇 |
1985年 | 20篇 |
1984年 | 33篇 |
1983年 | 18篇 |
1982年 | 7篇 |
1981年 | 11篇 |
1980年 | 16篇 |
1979年 | 11篇 |
1977年 | 3篇 |
1975年 | 3篇 |
1959年 | 9篇 |
1951年 | 4篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
1.
《International Journal of Hydrogen Energy》2022,47(20):11007-11027
Cathode channel of a PEM fuel cell is the critical domain for the transport of water and heat. In this study, a mathematical model of water and heat transport in the cathode channel is established by considering two-phase flow of water and air as well as the phase change between water and vapor. The transport process of the species of air is governed by the convection-diffusion equation. The VOSET (coupled volume-of-fluid and level set method) method is used to track the interface between air and water, and the phase equilibrium method of water and vapor is employed to calculate the mass transfer rate on the two-phase interface. The present model is validated against the results in the literature, then applied to investigate the characteristics of two-phase flow and heat transfer in the cathode channel. The results indicate that in the inlet section, water droplets experience three evolution stages: the growing stage, the coalescence stage and the generation stage of dispersed water drops. However, in the middle and outlet sections of the channel, there are only two stages: the growth of water droplets, and the formation of a water film. The mass transfer rate of phase change in the inlet section of the channel varies over time, exhibiting an initial increase, a decrease followed, and a stabilization finally, with the maximum and stable values of 1.78 × 10?4 kg/s and 1.52 × 10?4 kg/s for Part 1, respectively. In the middle and outlet sections, the mass transfer rate increase firstly and then keeps stable gradually. Furthermore, regarding the distribution of the temperature and vapor mass fraction in the channel, near the upper surface of the channel, the temperature and vapor mass fraction first change slightly (x < 0.03 m) and then rapidly decrease with fluctuations (x > 0.03 m). In the middle of the channel, the temperature and vapor mass fraction slowly decrease with fluctuation. 相似文献
2.
3.
4.
《International Journal of Hydrogen Energy》2022,47(19):10747-10761
To obtain the mixing enhancement mechanism of H2–Water combined jets in supersonic crossflows in a combustor with expanded section for rotating detonation ramjet, the flow field shape and spray structure were studied by experimental and numerical methods. The Eulerian–Lagrangian method was used to investigate the diffusion mechanism and H2–Water interaction law of combined jets with different sequences. At the same time, high-speed photography and the schlieren technique were used to capture the flow field. The effects of jet pressure drop, orifice diameter, orifice spacing, incoming Mach number, and other parameters on the penetration depth of water jets were studied. The results of experiment and simulation show that using H2–Water combined jets, the penetration depth of the jet spray can be greatly increased and the jet mixing effect can be significantly improved, which will contribute to the engine's ignition and stable combustion. In the case of pre-water/post-H2, the penetration depth of the hydrogen jet is greater. In the case of pre-H2/post-water, the hydrogen jet raises the water spray mainly by protecting the integrity of the water column. 相似文献
5.
为研究钢管套筒灌浆连接轴向受拉破坏过程及破坏机理,试验中设计了16组48个钢管套筒灌浆连接试件,试件采用钢板代替圆钢管,并进行静载试验。分析了灌浆料裂缝扩展过程、荷载-相对位移曲线,并对抗剪键高距比、灌浆料厚度、侧向力等因素对破坏过程及承载力的影响进行分析。结果表明:对于不设置抗剪键的套筒灌浆连接试件,斜裂缝随机产生,裂缝分布不均匀;对于设置抗剪键的套筒灌浆连接试件,裂缝首先出现在底部抗剪键位置处,与水平方向夹角约为30°,随后在中部和上部抗剪键位置处分别出现斜裂缝。由于每个抗剪键上荷载分担并不均匀,与抗剪键接触的灌浆料逐渐达到极限压应力,达到极限状态时,承载力全部由抗剪键间的机械咬合力承担,在连接承载力中,可忽略摩擦力和胶结力作用。随着抗剪键高距比h/s增大,各试件初始剪切刚度相差不大,承载力增大,但增幅逐渐减小,建议抗剪键高距比0.06g/s>0.3,同时需要满足灌浆料灌注的施工要求。 相似文献
6.
7.
The existing analytical average bit error rate (ABER) expression of conventional generalised spatial modulation (CGSM) does not agree well with the Monte Carlo simulation results in the low signal‐to‐noise ratio (SNR) region. Hence, the first contribution of this paper is to derive a new and easy way to evaluate analytical ABER expression that improves the validation of the simulation results at low SNRs. Secondly, a novel system termed CGSM with enhanced spectral efficiency (CGSM‐ESE) is presented. This system is realised by applying a rotation angle to one of the two active transmit antennas. As a result, the overall spectral efficiency is increased by 1 bit/s/Hz when compared with the equivalent CGSM system. In order to validate the simulation results of CGSM‐ESE, the third contribution is to derive an analytical ABER expression. Finally, to improve the ABER performance of CGSM‐ESE, three link adaptation algorithms are developed. By assuming full knowledge of the channel at the receiver, the proposed algorithms select a subset of channel gain vector (CGV) pairs based on the Euclidean distance between all CGV pairs, CGV splitting, CGV amplitudes, or a combination of these. 相似文献
8.
本文结合HTH电路的复杂性等特征分析与实际应用现状,研究了HTH电路的具体检测技术方法并对当前热点技术进行对比分析,探讨了HTH电路检测方法的技术发展趋势。 相似文献
9.
The Vehicle Routing Problem with Simultaneous Pickup and Delivery (VRPSPD) is an extension to the classical Vehicle Routing Problem (VRP), where customers may both receive and send goods simultaneously. The Vehicle Routing Problem with Mixed Pickup and Delivery (VRPMPD) differs from the VRPSPD in that the customers may have either pickup or delivery demand. However, the solution approaches proposed for the VRPSPD can be directly applied to the VRPMPD. In this study, an adaptive local search solution approach is developed for both the VRPSPD and the VRPMPD, which hybridizes a Simulated Annealing inspired algorithm with Variable Neighborhood Descent. The algorithm uses an adaptive threshold function that makes the algorithm self-tuning. The proposed approach is tested on well-known VRPSPD and VRPMPD benchmark instances derived from the literature. The computational results indicate that the proposed algorithm is effective in solving the problems in reasonable computation time. 相似文献
10.