低压静电场辅助冷冻对竹笋品质的影响

为研究低压静电场辅助冷冻对竹笋冻结特性的影响，以冻结曲线、硬度、水分损失率、水分迁移、冰晶形态和组织微观结构为指标，探究低压静电场辅助冷冻（－35 ℃）和普通冷冻（－35 ℃）条件下竹笋品质的变化规律。结果表明：低压静电场辅助冷冻提高了冻结效率，改变了冰晶形态及分布，减轻了组织微观结构破损程度，改善了解冻汁液流失情况。与静电板间距10、20、30、40 cm处的冷冻竹笋解冻后水分损失率分别为14.16%、12.58%、9.73%、10.44%，显著低于对照组（21.01%）（P＜0.05），硬度分别为461.19、507.48、496.65 g和455.31 g，显著高于对照组（350.70 g）（P＜0.05）。低场核磁共振分析结果表明，在低压静电场辅助冷冻下竹笋解冻后汁液流失减少，扫描电子显微镜观察结果显示，竹笋纤维排列整齐，组织微观结构保持较好。低压静电场辅助冷冻可有效改善竹笋品质，可为利用低压静电场进行果蔬的冷冻贮藏和冷链运输提供参考。     

A Voltage Control Method for a Distributed Line Feeder by means of Multiagent Approach

This paper proposes a method for the coordinated control of power factor by means of a multiagent approach. The proposed multiagent system consists of two types of agent: single feeder agent (F_AG) and bus agent (B_AG). In the proposed system, an F_AG plays as an important role, which decides the power factors of all distributed generators by executing the load flow calculations repeatedly. The voltage control strategies are implemented as the class definition of Java into the system. In order to verify the performance of the proposed method, it has been applied to a typical distribution model system. The simulation results show that the system is able to control very violent fluctuation of the demands and the photovoltaic (PV) generations.     

Transverse magnetoresistance peculiarities of thermoelectric Lu-doped Bi2Te3 compound due to strong electrical disorder

The n-type thermoelectric Bi_1.9Lu_0.1Te₃ was prepared by microwave-solvothermal method and spark plasma sintering. The magnetic field and temperature dependences of transverse magnetoresistance measured within temperature 2–200 K interval allow finding the peculiarities characteristic for strongly disordered and inhomogeneous semiconductors. The first peculiarity is due to appearance of linear-in-magnetic field contribution to the total magnetoresistance reflected in a crossover from quadratic magnetoresistance at low magnetic fields to linear magnetoresistance at high magnetic fields. The linear magnetoresistance can result from the Hall resistance picked up from macroscopically distorted current paths due to local variations in stoichiometry of the compound studied. The second peculiarity is that both linear magnetoresistance magnitude and crossover field are functions of carrier mobility which is in agreement with the Parish and Littlewood model developed for disordered and inhomogeneous semiconductors. An increase in the mobility due to a decrease in temperature is accompanied by an increase in the magnetoresistance magnitude and a decrease in the crossover field. Finally, the third peculiarity is related to the remarkable deviation of the total magnetoresistance measured at various temperatures from the Kohler's rule. Presence of strong inhomogeneity and disorder in the Bi_1.9Lu_0.1Te₃ structure concluded from the magnetoresistance peculiarities can be responsible for the remarkable reduction in the total thermal conductivity of this compound.     

Simple Sequence Repeat Markers in Genetic Divergence and Marker-Assisted Selection of Rice Cultivars: A Review

Sequencing of rice genome has facilitated the understanding of rice evolution and has been utilized extensively for mining of DNA markers to facilitate marker-assisted breeding. Simple sequence repeat (SSR) markers that are tandemly repeated nucleotide sequence motifs flanked by unique sequences are presently the maker of choice in rice improvement due to their abundance, co-dominant inheritance, high levels of allelic diversity, and simple reproducible assay. The current level of genome coverage by SSR markers in rice is sufficient to employ them for genotype identification and marker-assisted selection in breeding for mapping of genes and quantitative trait loci analysis. This review provides comprehensive information on the mapping and applications of SSR markers in investigation of rice cultivars to study their genetic divergence and marker-assisted selection of important agronomic traits.     

电压对电刷镀三价铬镀层性能的影响

在45钢表面电刷镀得到三价铬镀层,镀液组成和工艺条件为:Cr2(SO4)36H2O 0.4 mol/L,甲酸铵0.5 mol/L,氨基乙酸0.5 mol/L,H3BO30.6 mol/L,NaH2PO2 H2O 0.3 mol/L,pH=1.5,温度50°C,镀笔移动速率15 cm/s。研究了电压对镀铬层显微结构、表面粗糙度、厚度、显微硬度和耐磨性的影响。随电压增大,镀层厚度增大,显微硬度和耐磨性均先提高后降低。电压为14 V时,镀层的表面平整,粗糙度为2.387μm,显微硬度为602 HV,耐磨性最好。     

巨型水电站孤岛试验期间AVC电压波动的解决

本文首先分析国内典型的AVC的一般配置、控制策略和控制原理,针对巨型水电站孤岛试验期间的AVC控制的复杂工况进行阐述,对出现的AVC电压波动的情况进行分析,并对采用的解决方案进行介绍,为今后类似电站的孤岛运行期间的AVC电压控制提供一些参考建议。     

仪器仪表产品脉冲耐压试验要求和保护器件的选择

仪器仪表产品的脉冲耐压试验是产品型式试验、例行试验中的基本内容。通过对GB4793.1标准的整理,归纳了仪器仪表产品的脉冲耐压试验要求。通过对试验方法和设备特性的梳理,总结了特性参数,并介绍了应对脉冲耐压试验可采取的保护器件的类别及选用方法。     

Facial expression recognition of intercepted video sequences based on feature point movement trend and feature block texture variation

Facial Expression Recognition (FER) is an important subject of human–computer interaction and has long been a research area of great interest. Accurate Facial Expression Sequence Interception (FESI) and discriminative expression feature extraction are two enormous challenges for the video-based FER. This paper proposes a framework of FER for the intercepted video sequences by using feature point movement trend and feature block texture variation. Firstly, the feature points are marked by Active Appearance Model (AAM) and the most representative 24 of them are selected. Secondly, facial expression sequence is intercepted from the face video by determining two key frames whose emotional intensities are minimum and maximum, respectively. Thirdly, the trend curve which represents the Euclidean distance variations between any two selected feature points is fitted, and the slopes of specific points on the trend curve are calculated. Finally, combining Slope Set which is composed by the calculated slopes with the proposed Feature Block Texture Difference (FBTD) which refers to the texture variation of facial patch, the final expressional feature are formed and inputted to One-dimensional Convolution Neural Network (1DCNN) for FER. Five experiments are conducted in this research, and three average FER rates 95.2%, 96.5%, and 97% for Beihang University (BHU) facial expression database, MMI facial expression database, and the combination of two databases, respectively, have shown the significant advantages of the proposed method over the existing ones.