低压静电场辅助冷冻对竹笋品质的影响

为研究低压静电场辅助冷冻对竹笋冻结特性的影响，以冻结曲线、硬度、水分损失率、水分迁移、冰晶形态和组织微观结构为指标，探究低压静电场辅助冷冻（－35 ℃）和普通冷冻（－35 ℃）条件下竹笋品质的变化规律。结果表明：低压静电场辅助冷冻提高了冻结效率，改变了冰晶形态及分布，减轻了组织微观结构破损程度，改善了解冻汁液流失情况。与静电板间距10、20、30、40 cm处的冷冻竹笋解冻后水分损失率分别为14.16%、12.58%、9.73%、10.44%，显著低于对照组（21.01%）（P＜0.05），硬度分别为461.19、507.48、496.65 g和455.31 g，显著高于对照组（350.70 g）（P＜0.05）。低场核磁共振分析结果表明，在低压静电场辅助冷冻下竹笋解冻后汁液流失减少，扫描电子显微镜观察结果显示，竹笋纤维排列整齐，组织微观结构保持较好。低压静电场辅助冷冻可有效改善竹笋品质，可为利用低压静电场进行果蔬的冷冻贮藏和冷链运输提供参考。     

木片筛余物高得率半化学法清洁制浆技术研究

以太阳纸业备料车间木片筛选碎料（筛余物）为原料，对其烧碱法半化学制浆的实验室工艺和生产试验进行了研究。结果表明，筛余物采用半化学法制浆可获得较高得率和环压强度的纸浆，且用碱量对纸浆性能有显著影响。相对8%NaOH （相对于绝干原料）化学预处理，采用14%NaOH化学预处理结合两段浆浓22%的高浓磨浆工艺，所制半化学浆抄造浆张的裂断长和环压指数分别达2.89 km和9.76 N·m/g，是前者的1.9倍和1.2倍，而且优于现用国内OCC废纸浆抄造浆张；生产试验得到的浆张性能指标与实验室相吻合，其中紧度和环压强度分别达到GB/T 13023—2008瓦楞芯（原）纸AA级和A级优等品要求。     

Bamboo biochar-catalytic degradation of lignin under microwave heating

Abstract

Lignin biochar-catalytic depolymerization using biochar Fe-600, Fe-800, Ni-600, Ni-800 catalysts under microwave-heating (180?°C for 30?min) was explored in an ethanol/formic acid (1:1) media. Non-catalyst depolymerization was also studied and compared with the biochar-catalysts results. Characteristics of the bio-char catalysts were analyze by BET, XRD, and FT-IR. GPC, FT-IR, and MALDI-TOF MS spectrometry were also used to characterize the depolymerization products. The experimental results showed that the S_BET, V_t, and V_mec and average pore diameter of the biochars are considerably dependent on the preparation temperature and type of cation (Ni²⁺ or Fe³⁺). The maximum yield of bio-oil product was obtained as 85?wt% with the addition of biochar Ni-600 and the total amount of oligomers or monomers with a molecular weight of 164 to 446 reaches 80.4%.     

动态高压微射流处理对方竹笋膳食纤维理化及结构特性的影响

以方竹笋中提取的膳食纤维为研究对象，采用动态高压微射流（dynamic high-pressure micro-fluidization, DHPM）在不同压力条件（0，50，100，150，200 MPa）下进行处理，探究其对竹笋膳食纤维（bamboo shoots dietary fiber, BSDF）理化和结构特性的影响。结果表明，随着处理压力的增大，BSDF粒径先增大后减小，当处理压力为150 MPa时，粒径最小，为（370±11） nm，此条件下BSDF的持水力、持油力和膨胀力达到最大，较对照组分别提高了47.74%，50.54%，61.27%，且差异显著（P<0.05）。红外光谱分析表明DHPM处理不会改变BSDF的官能团，但会使BSDF内部的部分氢键断裂和半纤维素、木质素等发生降解；X射线衍射和热重分析表明DHPM处理不会引起BSDF的晶体结构改变，但晶体有序度会下降，进而导致其热稳定性降低；微观结构分析显示DHPM处理会使BSDF颗粒尺寸减小、表面粗糙、组织松散，且当处理压力为200 MPa时，颗粒发生团聚。综上，DHPM可以有效改善BSDF的理化性质，在膳食纤维改性方面具有一定的应用价值。     

Sequential batch reactor for eucalypt kraft pulp effluent treatment with Trametes versicolor

BACKGROUND: A sequential batch reactor (SBR) was used for eucalypt kraft pulp effluent treatment with Trametes versicolor. A 2³ full factorial design and response surface methodology were applied to optimise the batch fermentation conditions. Effluent concentration, culture medium and inoculum age were the factors selected for this study in order to optimise the reduction of chemical oxygen demand (COD). RESULTS: The presence of Trametes Defined Medium (TDM) in the fermentation was required to obtain a significant COD reduction. Experiments in the batch reactor confirmed, in general, the predicted results of optimisation developed from Erlenmeyer batch assays. The T. versicolor culture remained active during 42 days of study in the SBR, providing approximately 80% of COD reduction. CONCLUSION: Trametes versicolor may be considered as very promising for the biological treatment of effluents from kraft pulp mills in an SBR system instead of the activated sludge mixed cultures traditionally used. Copyright © 2008 Society of Chemical Industry     

钽铌水冶分解提取工艺及设备的进展

介绍了近些年来我国钽铌湿法冶炼中的资源结构，氢氟酸分解、矿浆萃取工艺以及工艺设备的进展情况。比较了主要工艺过程的技术经济指标，指出了当前生产中存在的一些问题，并提出了解决问题的一些意见。     

An investigation into the occurrence of sewage fungus in rivers containing papermill effluents—IV. Growth in experimental channels dosed with effluents and pure compounds

Wastewaters from the manufacture of pulp and paper have given rise to problems of excessive microbial growth in rivers over a number of years. This paper is the first in a series of four articles describing research undertaken by PIRA at four U.K. paper/board mills (one integrated with pulp production) over the period 1978–1980. This first paper briefly reviews the published literature on sewage fungus growth from pulp and paper mill discharges up to 1978, but mainly describes previously unpublished work undertaken by PIRA over the period 1965–1975. This introductory paper thus provides a state-of-the-art review of methods to control sewage fungus growth from pulp and paper mill effluents prior to commencement of the research described in the following three articles.     

浅谈利用互联网获取纸业信息和发展电子商务

对Internet网（互联网）的产生及发展历程做了简要介绍，并就我国造纸企业开发利用互联网，发展电子商务问题进行了探讨。     

Enzymatic Browning in Apple Pulps

Enzymatic browning in Golden Delicious apple pulp was studied as related to degree of ripeness and temperature (3.5–31°C). Green apple pulp showed the highest rate of browning. This was attributable to differences in ascorbic acid (AA) content and polyphenoloxidase activity in young fruits. The rate of browning determined by CIE L* measurements followed complex temperature dependent kinetics, represented by a multiple linear effects with log time. Equal changes in L* parameter yielded straight lines in a log temperature vs log time plot. Inhibition with AA caused an initial slow rate of browning and a well defined break point associated with exhaustion of antioxidant properties of the AA. The greater the AA concentration the longer the initial period.     

Energy System Consequences When Installing an Advanced Delignification Process

In the pulp and paper industry, during major modernization projects the overall energy system consequences are often not estimated in detail, usually only local energy consequences are taken into account when evaluating possible projects. In this paper, the effects on the overall energy system when installing an advanced delignification process (i.e., a “state‐of‐the‐art” pulp digester and oxygen delignification process) will be presented. Also, the effect such an installation has on the potential for further energy integration is discussed. Furthermore, the CO₂ consequences for both installing such a system and integrating the mill further energy‐wise are presented.