上榆泉煤矿煤泥水多参数在线检测系统应用研究

针对上榆泉煤矿煤泥水性质参数人工检测周期长、误差大、滞后性严重的问题,采用多参数传感器和PLC,开发了煤泥水多参数在线检测系统。经过8 h稳定运行,平均结果显示该厂煤泥水参数为pH值为7.71、浓度9.45%、中值直径(D50)39.56μm、流量2 440 m3/h、水质硬度428.94 mg/L,与人工检测结果相一致。应用结果表明,该检测系统能够实现煤泥水多参数在线监测和数据分析功能,使煤泥水的处理更高效。     

金属多孔材料喷墨制备法的研究与进展

喷墨三维打印作为金属增材制造技术的一种重要方法,已广泛应用于金属多孔材料的制备,具有成本低、操作简单、成型材料范围广、孔结构设计灵活性大,较好的制件精度和结构精细度等优点.系统地总结了钛及钛合金、不锈钢、镍基合金、铝合金等多孔材料喷墨三维打印技术制备工艺与组织结构的国内外最新研究进展、目前存在的问题,以及应用前景.     

基于UG的正交车铣加工回转体表面微观残留仿真

正交车铣加工的回转体表面由铣刀与工件的复合相对运动形成,其形成机理独特,多个参数影响其表面微观形貌。为研究切削参数对正交车铣回转体表面微观残留的影响,基于UG建立了正交车铣回转体表面的仿真加工方法,并通过Vericut构建了虚拟五轴车铣加工环境,由此仿真研究了周向每齿进给量对正交车铣回转体表面微观残留的影响,发现已加工表面微观残留高度随周向每齿进给量增加显著增大。     

某污水处理厂MBR膜系统改造与运行管理

某污水处理厂设计规模为10万t/d,采用AAO+MBR工艺,设计出水水质满足《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准。由于运行时间较长,MBR运行系统存在产能下降、膜丝断丝脱落、污堵和清洗频次以及强度增加等问题,严重影响正常生产运行。针对MBR系统运行中存在的问题,文中提出具体改造建议,并总结运行经验,进一步优化MBR膜系统的运行维护管理,为其他污水厂MBR膜系统运行问题提供解决思路和维护管理经验。     

硅渣和玻璃粉直接烧结制备多孔材料的气孔结构与力学性能

以硅渣和玻璃粉为原料,采用粉体直接烧结法制备多孔材料,研究了烧结温度(700~900℃)、烧结时间(15~120min)和升温速率(10~100℃·min^-1)对多孔材料表观密度、气孔率、物相组成、抗压强度的影响。结果表明:气孔结构均匀性随烧结温度的升高而降低;表观密度随烧结温度的升高先减小后增大,随保温时间的延长而增大,随升温速率的增大而减小,气孔率的变化趋势与表观密度的相反;多孔材料的主要物相为玻璃相和硅、SiC、SiO2、Ca2Al2SiO7等结晶相,且结晶度随烧结温度的升高而降低;抗压强度随烧结温度的升高呈先增大后减小的趋势;当烧结温度为750℃,升温速率为30℃·min^-1,烧结时间为30 min时,多孔材料的主晶相为硅和Ca2Al2SiO7,抗压强度最大(1.60MPa),表观密度为0.43g·cm^-3,气孔率为80%。     

防振条约束失效对蒸汽发生器传热管面内流弹失稳的影响研究

根据防振条布置以及面内支承连续失效个数，将防振条面内约束失效分析划分为多种工况，分析了不同工况下面内约束失效对传热管面内模态的影响，采用各位置阻尼在振型函数上进行加权平均的方法计算了各阶模态的阻尼比，进而研究了防振条面内不同约束对传热管面内流弹失稳的影响。分析结果表明，随着面内支承连续失效位置的增多，弯管段面内首阶模态频率不断降低，出现在弯管段的振型越加明显；弯管段面内首阶模态不一定是最大流弹失稳比值出现的模态，最大流弹失稳比值出现模态的振型几乎都出现在弯管段；随着面内支承连续失效位置的增多，面内流弹失稳比值不断增大，当连续3个及以上防振条面内约束失效时，将出现流弹失稳现象。     

Structural,magnetic and magnetostrictive properties of Co1-xLixFe2O4 synthesized by cathode materials of spent Li-ion batteries

In this study, we investigated the effects of substituting Li⁺ for Co²⁺ at the B sites of the spinel lattice on the structural, magnetic and magnetostrictive properties of cobalt ferrites. The Li⁺ substituted cobalt ferrites, Co_1-xLi_xFe₂O₄, with x varying from 0 to 0.7 in 0.1 increments, were synthesized with a sol-gel auto-combustion method using the cathode materials of spent Li-ion batteries. X-ray diffraction analysis revealed that all the Co_1-xLi_xFe₂O₄ nanopowders had a single-phase spinel structure and the lattice parameters decreased with increasing Li⁺ content, which can be proved by slight shifts towards higher diffraction angle values of the (311) peak. Field emission scanning electron microscopy was used to observe the fractured inner surface of the sintered cylindrical rods and the increased porosity resulted in a decreased magnetostriction. The oxidation states of Co and Fe in the cobalt ferrite samples were examined by X-ray photoelectron spectroscopy. High resolution transmission electron microscopy micrographs showed that most particles were roughly spherical and with sizes of 25–35?nm. Li⁺ substitution had a strong effect on the saturation magnetization and coercivity, which were characterized with a vibrating sample magnetometer. The Curie temperature was reduced due to the decrease in magnetic cations and the weakening of the exchange interactions. The magnetostrictive properties were influenced by the incorporation of Li⁺ at the B sites of the spinel structure and correlated with the changes in porosity, magnetocrystalline anisotropy and the cation distribution.     

Computational Analysis of the Solid-State and Solvation Properties of Carbamazepine in Relation to its Polymorphism

The solvent-dependent polymorphism of the active pharmaceutical ingredient (API) carbamazepine is interpreted from calculations of the solid-state and API-solvent intermolecular interactions. These simulations suggested that apolar solute-solute interactions could be disrupted by apolar solvents. In contrast, the polar solute-solute interactions were found to be easily disrupted by polar and protic solvents. This is consistent with experimental observations that the crystallization of the metastable form II is more dominant in apolar solvents. The Mercury program remains the gold standard in terms of usability; however, further expansion into more complex simulation techniques could make this package of even greater use in pharmaceutical manufacturing workflows.     

氢化物原子荧光光谱法测定酱油中微量铅的方法研究

建立了一种快速、高效的QuEChERS-高效液相色谱-质谱联用法（QuEChERS-HPLC-MS/MS）测定谷类杂粮制品中脱氧雪腐镰刀菌烯醇（DON）、3-乙酰脱氧雪腐镰刀菌烯醇（3-ADON）、15-乙酰脱氧雪腐镰刀菌烯醇（15-ADON）和玉米赤霉烯酮（ZON）共4种真菌毒素。样品前处理采用乙腈-水溶剂提取，经Florisil+C18+无水硫酸镁净化后检测。以0.10%甲酸-乙腈作为流动相，在质谱检测器的多反应监测模式下进行分析。结果表明，4种真菌毒素在各自的线性范围内线性关系良好，相关系数R2均大于0.999，回收率在85.1%～102.0%，相对标准偏差（RSD）为2.11%～6.22%。该方法具有前处理简单、净化效果好、灵敏度高和检测速度快的优点，适用于谷类杂粮制品中DON、3-ADON、15-ADON 和ZON的分析和定量检测。