Facile construction of composition-tuned ruthenium-nickel nanoparticles on g-C3N4 for enhanced hydrolysis of ammonia borane without base additives

Developing high-efficiency and low-cost catalysts for hydrogen evolution from hydrolysis of ammonia borane (AB) is significant and critical for the exploitation and utilization of hydrogen energy. Herein, the in-situ fabrication of well-dispersed and small bimetallic RuNi alloy nanoparticles (NPs) with tuned compositions and concomitant hydrolysis of AB are successfully achieved by using graphitic carbon nitride (g-C₃N₄) as a NP support without additional stabilizing ligands. The optimized Ru₁Ni_7.5/g-C₃N₄ catalyst exhibits an excellent catalytic activity with a high turnover frequency of 901 min^?1 and an activation energy of 28.46 kJ mol^?1 without any base additives, overtaking the activities of many previously reported catalysts for AB hydrolysis. The kinetic studies indicate that the AB hydrolysis over Ru₁Ni_7.5/g-C₃N₄ is first-order and zero-order reactions with respect to the catalyst and AB concentrations, respectively. Ru₁Ni_7.5/g-C₃N₄ has a good recyclability with 46% of the initial catalytic activity retained even after five runs. The high performance of Ru₁Ni_7.5/g-C₃N₄ should be assigned to the small-sized alloy NPs with abundant accessible active sites and the synergistic effect between the composition-tuned Ru–Ni bimetals. This work highlights a potentially powerful and simple strategy for preparing highly active bimetallic alloy catalysts for AB hydrolysis to generate hydrogen.     

炼油达标污水回用处理试验研究

采用曝气生物滤池、多介质过滤、超滤、反渗透工艺,对炼油达标外排污水进行回用处理中试试验。结果表明,曝气生物滤池对油、COD和浊度去除效果良好,超滤、反渗透膜化学清洗周期达到 2个月以上,脱盐率稳定在98％以上,产水品质达到回用要求。     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry     

9,10-二氰蒽合成方法的改进

以蒽为原料,经溴化和氰化两步合成了光敏剂9,10-二氰蒽(DCA)。从反应溶剂的选择及提纯方法等方面改进了DCA的合成方法,提高了溴化和氰化反应的收率。结果表明,溴化反应时,控制溴的滴加温度为30℃,收率可达95%;合成DCA时,采用连续抽提法提纯,以DMSO为溶剂,反应中生成的无机盐完全溶解,粗产物不经抽提DCA收率可达74%～75%;而选用N-甲基吡咯烷酮为溶剂,DCA可与溴化铜形成配合物CuBr_2·DCA·CuBr_2,此配合物加热易分解,DCA收率达到93%。     

16Mn（HIC）钢在D405设备环境下的腐蚀行为研究

中国石化集团齐鲁石油化工公司胜利炼油厂1.40 Mt／a加氢裂化装置高压分离器D405存在设备制造问题,现场调查和介质环境的跟踪分析表明,D405设备腐蚀环境为碱性湿H_2S环境。实验室内选择16Mn(HIC)基材和焊接接头作为实验材质,在湿H_2S环境中进行了腐蚀实验。结果表明,16Mn(HIC)SSCC敏感性随硫化氢浓度的增加和pH值的降低而增加。焊缝处SSCC敏感性最高,经过热处理的焊缝其SSCC敏感性明显降低。因此,16Mn(HIC)在D405碱性湿H_2S环境下的腐蚀开裂敏感性很低,设备可以维持长周期运行。     

几种酚类抗氧剂在润滑油中的应用

采用旋转氧弹法、高压差示扫描量热法等方法研究了5种酚类抗氧剂对6种润滑油基础油氧化安定性的改善效果。结果表明:向加氢基础油中加入0.25%(质量分数)抗氧剂2246-S和RHY510(含硫酚类抗氧剂),可使HVIWH125,HVIWH150,HVIWH500,KN4006,KN40105种润滑油基础油的诱导期由27～88min提高到226～397min;使HVIWH125,HVIWH150,HVIWH300,HVIWH500,KN4006,KN40106种润滑油基础油的起始氧化温度由193.34～198.90℃提高到205.48～230.27℃。     

聚乙烯催化剂表面分形和多重分形特征

应用分形和多重分形理论研究了负载型聚乙烯催化剂(简称催化剂)表面形态。提出一种图片处理和计算过程更加完备的基于扫描电子显微镜照片的分形维数和多重分形谱计算程序,对4种催化剂进行分析计算。探讨了分形维数、多重分形谱相关参数与催化剂表面形态及与聚合活性的对应关系。实验结果表明,催化剂表面形态的复杂程度可以用表面分形维数来表征,聚合活性高的催化剂表面形态更加复杂,有更大的比表面积,对应的分形维数值也越大。催化剂表面分形维数的变化程度可以用多重分形谱来表征,聚合活性高的催化剂表面分形维数的跨度和分散程度更高。提出的分形维数和多重分形谱计算程序为催化剂的评定与设计提供了一种实用的手段。     

Catalytic aminolysis of epoxide by alumina prepared from amine-protected Al precursor

The catalytic activities of alumina prepared from an Al alkoxide-amine adduct monomer for the reaction of cyclopentene oxide with piperidine was determined after various pretreatments, including calcination and exposure to moisture. They were compared with the activity of alumina prepared by the conventional hydrolysis method. It was found that the as-prepared sample from the alkoxide-amine monomer preparation was five times more active than a conventional preparation, suggesting that it has a higher density of surface Lewis acid sites. However, its activity was much more severely suppressed by exposure to moisture.     

复合固体超强酸SO42-/Fe2O3-γ-Al2O3催化合成丁酸丁酯

采用沉淀硫酸化法制备了复合固体超强酸催化剂SO2-4/Fe2O3-γ-Al2O3,确定了其最佳制备工艺条件:硫酸浸渍浓度为0.6 mol/L,浸渍时间4 h;焙烧温度550℃,焙烧时间3 h.并采用该催化剂合成丁酸丁酯,考察了物料配比、催化剂用量和反应时间对酯化反应的影响,确定了丁酸丁酯的最佳合成条件:丁醇与丁酸摩尔比为1.4:1,催化剂用量0.9%(以反应物质量计),回流条件下反应3.0 h,在此最佳合成条件下,酯化率可达95.6%.