近地面湍流大气中激光传输的光强闪烁分析

光学湍流对激光的大气传榆有着重要的影响,其中光强闪烁是湍流效应中最基本也是最重要的一个效应,一直是一个十分令人关注的问题.在处理激光在湍流大气中传输的光强闪烁效应时,认为光强闪烁是由大尺度光强起伏对小尺度光强起伏的调制,并对其调制过程进行了讨论.基于光强闪烁的调制理论,对近地面典型条件下激光大气传输的光强闪烁指数及其影响因素进行了分析.     

水工钢闸门焊缝的分类与检测

本文对闸门产品的设计和制造标准中关于对焊缝分类与内部质量无损检测的要求进行分析，提出了如果能将焊缝类别和焊缝形式二者结合起来提出焊缝内部缺陷的探伤要求，会减少设计要求与质量检验的矛盾，降低产品制作成本与施工难度。建议尽快制订重要的T型组合焊缝内部缺陷探伤方法和等级评定标准。     

水工监测传感器指标使用误区的探讨

本文旨在讨论目前岩土工程中使用的传感器技术指标及其含义，希望通过探讨以弄清楚这些指标的含义及指标对评价传感器的意义。由于传感器是用于测量工程物理量的，因此，引人目前在国际上通用的测量与误差的概念，以国家现有的测量术语的定义为准来描述传感器的指标。     

宣钢烧结生产配加钢渣的工业试验

总结了宣钢烧结配配加钢渣生产不同碱度烧结矿的工业生产试验，提出了配加钢渣可强化全精粉烧结。     

MX345芯片及单片机控制

MX345芯片用于产生模拟信令—CTCSS单音.本文在介绍MX345编码/解码器工作原理的基础上,设计出MX345芯片与单片机的接口电路.最后给出控制软件.     

油田热采注汽管道在线检测技术现状

稠油热采注汽管道由于长期在高温、高压下运行,极易发生各种损伤,如腐蚀、裂纹、材料退化等,极易造成管道承压能力降低,发生失效事故。如何检测出潜在危险性缺陷,判断注汽管道能否继续使用,是保证注汽管道安全运行的关键问题。探讨了高温压力管道在线检测技术发展现状及其应用范围。     

汽车排放控制系统中的氧传感器现状及展望

介绍了浓差型(Nernst型)、极限电流型和半导体电阻型等汽车排放控制系统中的氧传感器原理及结构。在综合该领域国内外研究现状的基础上,对氧传感器的发展进行了展望。     

Comparative study of the elimination of toluene vapours in twin biotrickling filters using two microorganisms Bacillus cereus S1 and S2

BACKGROUND: To investigate the microbial degradation performance of organic pollutants in the atmosphere using a biotrickling filter, two microorganism strains, Bacillus cereus S1 and Bacillus cereus S2, were selected, identified and inoculated into a twin biotrickling filter for comparison. RESULTS: Both strains showed good performance towards the degradation of model organic pollutants when gas flow rates ranged from 100 to 600 L h⁻¹. For S1, the total maximum removal efficiency (RE) of toluene was maintained nearly 100% not only at gas flow rates of 100 L h⁻¹ corresponding to empty bed residence time (EBRT) 199.44 s, but also at gas flow rates of 200 L h⁻¹ (EBRT = 99.72 s) and 300 L h⁻¹ (EBRT = 66.48 s). However, S2 had a much lower degradation capability; near 100% removal efficiency was obtained only at the gas flow rate of 100 L h⁻¹ although both bacteria belong to the same Bacillus cereus. With further increase in gas flow rate, the total REs for both S1 and S2 decreased slightly at first and then dropped sharply to 46% and 35%, respectively, at an EBRT of 33.24 s, corresponding to a gas flow rate of 600 L h⁻¹. Starvation for between 2 and 10 days resulted in the re‐acclimation times of both strains ranging between 1.0 and 15.5 h. CONCLUSION: Strain S1 would be a better choice for inoculation into a biotrickling filter than strain S2, because of its much higher toluene removal capacity and rapid recovery to full performance. Copyright © 2008 Society of Chemical Industry     

Synthesis,characterization, and redox and electrochromic behaviors of poly(3-n-octyloxythiophene)

Poly(3-n-octyloxythiophene), a conjugated polymer, which possessed solubility in common organic solvents, was synthesized by electrochemical polymerization in the presence of lithium perchlorate as the supporting electrolyte and sodium dodecyl sulfate as the surfactant in an aqueous medium. Characterizations of the intermediate, monomer, and polymer were performed by NMR spectroscopy, Fourier transform infrared spectroscopy, ultraviolet–visible spectroscopy, and gel permeation chromatography. The process of electrochemical polymerization and the electrochemical redox behaviors were investigated by cyclic voltammetry and the potentiostatic method. A poly(3-n-octyloxythiophene) film that was deposited on a platinum electrode was found to exhibit electrochromic behaviors, and it switched electrochemically between blue–green oxidized and dark red reduced states. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

CO毒化AB5型合金分形特征研究

研究了三种贮氢合金 L a Ni5、L a Ni4 .7Al0 .3、Ml Ni4 .5Al0 .5被 10 0× 10 - 6 CO毒化后的分形特征 ,求出这三种合金在含 10 0× 10 - 6 CO的氢中循环 ,分维分别为 0 .2 5 4 7、0 .170 9、0 .0 72 5。可以较好的解释合金被毒化的宏观现象。