Characterization of alternative plasticizers in poly(vinyl chloride) sheets for blood containers

This study aimed to optimize the ratio of dioctyl 4‐cyclohexene‐1,2‐dicarboxylate (DOTH) and di‐isononyl‐cyclohexane‐1,2‐dicarboxylate (DINCH^®) for use as plasticizers in poly(vinyl chloride) (PVC) sheets. We also evaluated the biological safety of DOTH for its potential to be part of a safe PVC‐based blood container. The suppression of hemolysis in mannitol‐adenine‐phosphate / red cell concentrates (MAP/RCC) with DOTH/(DINCH^®‐PVC) sheets and the elution of plasticizers from the sheets increased with higher DOTH compositions. The properties of the PVC sheet containing DOTH and DINCH^® in the ratio of 25:33 parts against PVC 100 parts as a weight were almost identical to the PVC sheet made of di(2‐ethylhexyl) phthalate. From a subchronic toxicity test, DOTH did not show any adverse effects on all organs, including the testes, epididymis, liver, and kidneys. The no‐observed‐adverse‐effect level was 300 mg/kg body weight/day in a rat. These results suggest that DOTH/DINCH^® (25:33) is a promising candidate for the replacement of di(2‐ethylhexyl) phthalate in blood containers. J. VINYL ADDIT. TECHNOL., 22:520–528, 2016. © 2015 Society of Plastics Engineers     

Oil film behavior under minute vibrating conditions in EHL point contacts

The oil film thickness was measured under conditions of minute vibrations using an elastohydrodynamic lubrication (EHL) ball-on-disk test rig. Poly-alpha-olefin (PAO) oil was used as the lubricant under conditions of pure sliding where only the ball specimen was minutely vibrated. It was found that an oil film formed when the amplitude ratio was greater than 1.6. Moreover, when conditions were changed to the maximum vibrating speed, oil viscosity, and maximum contact pressure, the critical amplitude ratio at which the oil film began to form remained at 1.6. Consequently, calculated results showed that the oil film was formed when the amplitude ratio was π/2 (nearly equal to 1.6), which closely agreed with our test results.     

Effect of axial reflector on radial uniformity in neutron transmutation doping of silicon

Significant axial variation of radial uniformity is observed in Si-ingot neutron transmutation doping in the flux screening method, and leads to non-uniform resistivity distribution for a certain part of Si-ingot. This axial variation of radial uniformity is caused by the installation of a partial neutron screen which decreases the reaction rates differently in the center and surface at the region not surrounded by the partial neutron screen. For the improvement of the specific distribution of radial uniformity in the axial direction, a new concept of axial reflector is introduced to partly change the reaction rate at a certain region of Si-ingot, and neutron irradiation experiments are carried out at the heavy water neutron irradiation facility in the Kyoto University Research Reactor. Based on the experimental and numerical results, the new axial reflector is proved to be effective for improving the axial variation of radial uniformity.     

Cloning and characterization of a β-N-acetylglucosaminidase (BmFDL) from silkworm Bombyx mori

In insects, β-N-acetylglucosaminidase (GlcNAcase) participates in critical physiological processes such as fertilization, metamorphosis, and glycoconjugate degradation. Insects produce glycoproteins carrying paucimannosidic-type N-glycans, the terminal GlcNAc residue of which is cleaved by a GlcNAc-linkage specific GlcNAcase, also known as the fused lobes (FDL) protein. To obtain information on the structure of GlcNAcases and insight into their contribution to physiological processes, we cloned Bombyx mori FDL (BmFDL) from silkworm larvae. The full-length cDNA (1.9 kb) encoded a protein of 633 amino acids with 42% amino acid sequence identity to Drosophila melanogaster FDL (DmFDL). Recombinant BmFDL cleaved only β-1,2-linked GlcNAc residues from the α-1,3 branch of biantennary N-glycan. This substrate specificity was similar to that of DmFDL. Microsomal FDL activity was inhibited by anti-BmFDL antibodies. Taken together, our results suggest that BmFDL is a N-glycan-processing GlcNAcase in B. mori.     

A Novel Approach to the Polaronic Metallic State of Cuprate Superconductors and the d-Wave Pairing Mechanism

The present novel approach consists of two stages: in the first stage the many-electron states of a CuO₆ octahedron or a CuO₅ pyramid are calculated by the first-principles variational method, by taking into account the local distortions of a CuO₆ octahedron or a CuO₅ pyramid. In the second stage a metallic state is constructed in the presence of the local AF ordering constructed by the localized spins. In this metallic state the local distortions are treated in the mean field approximation, so that a pseudopolaronic effect is taken into account. Based on this approach, the hole-concentration dependence of T _c and the isotope effect are calculated for LSCO, and compared with experimental results. This approach leads to d-wave pairing mechanism.     

Uniform carbon‐nanotube emitter for field‐emission displays

Abstract— The synthesis of carbon‐nanotube (CNT) field emitters for FEDs by thermal chemical vapor deposition (CVD) and their structural and emission characterization are described. Multi‐walled nanotubes (MWNTs) were grown on patterned metal‐base electrodes by thermal CVD, and the grown CNTs formed a network structured layer covering the surfaces of the metal electrode uniformly, which realized uniform distribution of electron emission. A technique for growing narrow MWNTs was also developed in order to reduce the driving voltage. The diameter of MWNT depends on the growth temperature, and it has changed from 40 nm at the low temperature (675°C) to 10–15 nm at the high temperature (900–1000°C). Moreover, narrower MWNTs were grown by using the metal‐base electrode covered with a thin alumina layer and a metal catalyst layer. Double‐walled nanotubes (DWNTs) were also observed among narrow MWNTs. The emission from the narrow CNTs showed a low turn‐on electric field of 1.5 V/μm at the as‐grown layer.     

Application of a novel polypropylene to the insulation of an electric power cable

Cross‐linked polyethylene (XLPE) has been widely adopted as insulating material for high‐voltage power cables up to 500 kV. Further improvement of electrical and thermal properties on insulating material is required in order to increase cable operation efficiency. Therefore, the development of novel insulating material possessing high thermal properties will be necessary. Recent progress of catalysis technology contributes to obtain new polymeric materials which may be applied to electrical insulation. The authors investigated the basic properties of newly developed stereoregular syndiotactic polypropylene (s‐PP) which is synthesized with homogeneous metallocene catalyst. Though recycling of cross‐linked polymers such as conventionally used XLPE may be difficult because of their poor heat deformation, the s‐PP which is not cross‐linked must be suitable for recycling. A series of experiments on its physical and electrical properties gave the following results.

• (1) s‐PP has sufficient flexibility compared with isotactic polypropylene (i‐PP ).
• (2) Both AC and lightning impulse breakdown strength of s‐PP in spite of no cross‐linking are superior to those of XLPE in the temperature range from 25 to 90 °C.
• (3) Degradation by copper of s‐PP is less than that of i‐PP.
• (4) s‐PP/VLDPE blend shows sufficient brittleness temperature for use.

These results suggested that s‐PP should serve as insulating material for power cables at higher‐temperature operation. © 2003 Wiley Periodicals, Inc. Electr Eng Jpn, 146(1): 18–26, 2004; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002//eej.10210     

Noncompetitive inhibition by L-cysteine and activation by L-glutamate of the iron-oxidizing activity of a mixotrophic iron-oxidizing bacterium strain OKM-9

A mesophilic, mixotrophic iron-oxidizing bacterium strain OKM-9 uses ferrous iron as a sole source of energy and L-glutamate as a sole source of cellular carbon. Uptake of L-glutamate into OKM-9 cells is absolutely dependent on ferrous iron oxidation. Thus, the Fe(2+)-dependent L-glutamate uptake system of strain OKM-9 is crucial for the bacterium to grow mixotrophically in iron medium with L-glutamate. The relationship between iron oxidation and L-glutamate transport activities was studied. Iron oxidase containing cytochrome a was purified 9-fold from the plasma membrane of OKM-9. A purified iron oxidase showed one rust-colored band following disc gel electrophoresis after incubation with Fe(2+). The Fe(2+)-dependent L-glutamate transport system was also purified 14.5-fold from the plasma membrane using the same purification steps as for iron oxidase. Fe(2+)-dependent L-glutamate and L-cysteine uptake activities of OKM-9 were 0.36 and 0.24 nmol/mg/min, respectively, when a concentration of 18 mM of these amino acids was used as a substrate. Both uptake activities were completely inhibited by potassium cyanide (KCN), suggesting that cytochrome a in the iron oxidase is involved in the transport process. The iron-oxidizing activity of strain OKM-9 was activated 1.7-fold by 80 mM L-glutamate. In contrast, the activity was noncompetitively inhibited by L-cysteine. The Michaelis constant of iron oxidase for Fe(2+) was 12.6 mM and the inhibition constant for L-cysteine was 41.6 mM. A marked inhibition of iron oxidase by 50 mM L-cysteine was completely reversed by the addition of 60 mM L-glutamate. The results suggest the possibility that iron oxidase has a binding site for L-cysteine and the cysteine first bound to the iron oxidase was replaced by the added L-glutamate.     

Modification of physicochemical properties of actin filaments suppresses cell fragmentation in the execution phase of staurosporine-induced apoptotic processes

Effects of jasplakinolide (JSP), a stabilizer of F-actin, and latrunculin A (LTA), a destabilizer of F-actin, on a series of events occurring in the execution phase of staurosporine (STS)-induced apoptotic processes were studied using human osteosarcoma 143B cells. Time-dependent apparent increases of the population of cells with collapsed membrane potential of mitochondria (Delta Psi(m)) caused by STS treatment were not due to actual decreases in the Delta Psi(m) per cell, but due to the fragmentation of cells resulting in decreases in the number of active mitochondria per cell. Decreases in the Delta Psi(m) in fragmented cells occurred late in the execution phase. Both JSP and LAT failed to prevent STS-induced release of cytochrome c from mitochondria followed by the activation of caspases 3 and 9, the cleavage of poly (ADP-ribose) polymerase (PARP) and apoptotic nuclear fragmentation. However, both drugs prevented STS-induced apoptotic cell fragmentation and decreases in the Delta Psi(m). These results indicate that physicochemical states of actin filaments play a certain role in the execution phase of STS-induced apoptotic processes.