天铁炼铁技术进步

近十年来，天铁集团炼铁厂通过改善原燃料条件；优化炉料结构，提高入炉品位；采用提高炉顶压力、富氧喷煤、低硅冶炼、炉顶气象系统等多项先进技术，使高炉各项经济技术指标逐年提高。     

W-Ni-Cu高比重合金注射成形烧结收缩及性能的研究

研究了W-Ni-Cu高比重合金注射成形工艺过程收缩率和性能。比较了模具尺寸、注射坯尺寸、烧结坯尺寸，及烧结阶段各方向收缩率的关系，发现实际收缩与理论预测收缩率较为一致，但在厚度方向存在与其他方向收缩不一致的情形，这与由重力作用产生的塑料流动有关；还探讨了烧结坯密度与烧结条件的关系，测定了烧结坯的力学性能及断口形貌、金相组织，烧结坯在1400℃，90min烧结达到了99％的相对密度，断裂强度600MPa以上。     

主电机轴瓦异常情况分析解决办法

介绍南钢中板厂四辊轧机主电机轴瓦一种非典型故障现象，原因分析及解决办法，提出了对类似问题个人见解。     

注入剖面双相态放射性测井方法研究

文章结合注入剖面同位素示踪和放射性相关流量两种测井方法的特点,提出了固态微球同位素和液态同位素同时使用的综合测井方法.应用放射性相关流量测井的直观性,量化同位素示踪测井中的不确定因素,达到提高测井成功率和资料解释精度的目的.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.     

大庆油田三类油层聚合物驱注入速度研究

注入速度是影响聚合物驱开发效果的重要指标,而由于假设条件的局限性,数值模拟方法无法体现聚合物溶液弹性对注入速度的影响。为了确定大庆油田三类油层合理注入速度,通过不同注入速度条件下的天然岩心驱油试验,对水驱和聚合物驱驱油效率进行了研究,结果表明,聚合物驱驱油效率提高值随驱替速度的变化可由二次多项式来表示。依据此关系式,由势的叠加理论得到的流体在油层中的渗流速度的基础上,建立了该类油层合理注入速度模型,并给出大庆油田三类油层在100 m注采井距下的合理注入速度为0.288 PV年/,该方法对现场开发方案编制有重要指导意义。     

万用表电压测量法查找直流接地故障

直流电源是发电站的主要设备，一旦直流系统发生接地故障，将会严重地危及到发电站的安全和经济运行。因此，本文介绍一种简单易行，能快速找出直流接地点的方法一万用表电压测量法。     

Analysis and Optimization of Noise in Bipolar RF Harmonic Mixers

A noise analysis of bipolar harmonic mixers (BHM) used for direct-conversion receivers is presented in this paper. Analytical and simulated results for the transfer function of the mixer are presented. Simple analytical expressions describing noise contribution from all sources are derived. Estimation of flicker noise quite agrees with harmonic-balance simulation results. Based on the derived expressions, total time average noise power spectral density (PSD) at the output is compared with simulation results. For the recommended regions of operation, error is less than 20%. The overall BHM noise figure (NF) is calculated and optimized based on a simple extracted formula. Errors introduced by analysis remain within a 1.5-dB margin with respect to simulation results. The validity of analysis for high frequencies is justified. The effect of flicker noise coefficient on the overall mixer NF is compared for different available processes.     

无磷洗涤剂的现状及存在问题

含磷洗涤剂中含的“磷”主要是STPP，作用很大但对环境的危害也很大，它是造成地表水体出现富营养化的重要原因之一，所以许多地方政府都在实行“禁磷”——禁止销售、使用含磷洗涤剂。现在我国使用的无磷洗涤剂中代磷助剂主要有3种，其中4A沸石用量最大，但它会对环境带来新的问题。主要介绍了含磷洗涤剂的危害及无磷洗涤剂的应用现状，指出了我国禁磷后将面临的问题。     

光电双基区晶体管(PDUBAT)的器件模型

本文在考虑了晶体管的小注入效应和大注入效应以及基区宽变效应等因素后,首次用近似和简化的数学表示式和相应的等效电路,描述了光电双基区晶体管(PDUBAT)负阻形成的机理并使负阻区和谷值区的理论计算和实验结果一致性很好.