大功率UPS的并联控制技术

提出了一种新的N 1三相大功率UPS的并联控制方案，并且在4台40KVA三相在线式UPS上进行了实验研究，实际运行结果证明采用此方法可以获得良好的静态与动态特性。     

逆变电源并联技术

逆变器并联是提高电源系统可靠性 ,扩充系统容量的有效方式。本文介绍了逆变电源并联的原理、技术要求和特点。对当前采用的逆变电源并联方案进行了总结和分类。在此基础上详细分析了各种并联方案的特点和内在关系 ,指出了逆变电源并联技术的发展趋势。     

集群计算机上基于BSP模型的并行算法及其程序设计

文章分析了BSP模型和集群计算机的特点，给出了在集群计算机根据BSP模型设计并行算法及其软件的原则，举例说明了利用BSP模型代价公式定性分析并行算法性能的方法，并利用实验结果验证了得出的结论。结果表明模型的成功地抽象出了集群计算中影响算法性能的诸种因素，并通过代价公式反映出来，利用代价公式可以基本准确地估计并行算法代价，这对集群计算机上的并行算法及其软件及设计和优化具有重要的指导意义。     

Parallel path consistency

Filtering algorithms are well accepted as a means of speeding up the solution of the consistent labeling problem (CLP). Despite the fact that path consistency does a better job of filtering than arc consistency, AC is still the preferred technique because it has a much lower time complexity. We are implementing parallel path consistency algorithms on multiprocessors and comparing their performance to the best sequential and parallel arc consistency algorithms.^(1,2) (See also work by Kerethoet al. ⁽³⁾ and Kasif⁽⁴⁾) Preliminary work has shown linear performance increases for parallelized path consistency and also shown that in many cases performance is significantly better than the theoretical worst case. These two results lead us to believe that parallel path consistency may be a superior filtering technique. Finally, we have implemented path consistency as an outer product computation and have obtained good results (e.g., linear speedup on a 64K-node Connection Machine 2).     

A VLSI architecture for a half-edge-based corner detector

Corner detection is a low-level feature detection operator that is of great use in image processing applications, for example, optical flow and structure from motion by image correspondence. The detection of corners is a computationally intensive operation. Past implementations of corner detection techniques have been restricted to software. In this paper we propose an efficient very large-scale integration (VLSI) architecture for detection of corners in images. The corner detection technique is based on the half-edge concept and the first directional derivative of Gaussian. Apart from the location of the corner points, the algorithm also computes the corner orientation and the corner angle and outputs the edge map of the image. The symmetrical properties of the masks are utilized to reduce the number of convolutions effectively, from eight to two. Therefore, the number of multiplications required per pixel is reduced from 1800 to 392. Thus, the proposed architecture yields a speed-up factor of 4.6 over conventional convolution architectures. The architecture uses the principles of pipelining and parallelism and can be implemented in VLSI.     

Elimination of organic matter present in wastewaters from the cork industry by membrane filtration

BACKGROUND: The first stage of the cork industrial process generates great volumes of wastewater with moderate to high organic pollutant content that must be purified using different procedures, such as filtration by membranes. RESULTS: The tangential filtration of these wastewaters was studied using two different laboratory equipments. In the first one, three ultrafiltration (UF) membranes were tested, with molecular weight cut‐off (MWCO) 100 kDa and 30 kDa, and two operating modes were used: total recycling of permeate and retentate streams, and in continuous mode, without recycling both streams. In the total recycling UF experiments, the influence of the operating variables on the permeate flux was first established. The effectiveness of the different membranes was determined by evaluating the rejection coefficients for several parameters that measure the global pollutant content of the effluent. The values found for these rejection coefficients were in the following order: ellagic acid and color > absorbance at 254 nm > tannic content > COD (chemical oxygen demand). In the continuous mode experiments, the fouling mechanism for each membrane was established by fitting the experimental data to various filtration fouling models given in the literature. The operating mode in the second equipment was batch concentration, and additional experiments were carried out with an UF membrane (2 kDa), and with a NF membrane (with MWCO in the range 150–300 Da). CONCLUSIONS: The three operating modes tested provided different rejection levels of organic matter; among them, the most effective procedure tested was batch concentration mode using a NF membrane. Copyright © 2007 Society of Chemical Industry     

计算机高速并行通信的实现方案

利用CPLD芯片实现单片机与ISA总线接口之间的高速并行通信，给出系统的总体设计方法及程序框图。采用这种通信方式，在12MHz晶振的MCS51单片机控制的数据采集系统中，可以满足与PCI04 ISA总线接口实时通信的要求，通信速率达200khit／s。在开发工具MAX plusⅡ下，完成了整个设计的输入、编译和仿真，达到了预期效果。本设计方案能够推广应用到计算机的高速并行通信中。     

多码CDMA系统中联合并行干扰抵消与迭代信道估计方法

本文针对多码CDMA系统提出了一种联合并行干扰抵消与迭代信道估计方法。该方法首先通过导频符号对信道进行估计，然后使用RAKE接收机后的软信息对信道参数进行修正，最后通过并行干扰抵消(PIC)去除多码干扰(MCI)。仿真结果表明，经过多次迭代后，该方法可显著地降低多码CDMA系统的误比特率平台。本文同时还给出了信道估计质量、码道数和PIC次数对多码CDMA系统性能的影响。     

Mesh结构P/G布线网络层次化快速分析方法

本文提出了一个基于网络划分的P／G布线网络层次化快速分析方法。其中，对于子网运算，通过对Cholesky分解法三角化对称正定阵的图模型分析，并基于Mesh结构网络的自身特点，提出了一个基于图顶点排序的加速子网分析运算策略；并用基于MPI的并行结构实现了P／G布线网络分析的并行运算。