三塘湖盆地上古生界烃源岩镜质组反射率异常研究

镜质组反射率是评价有机质成熟度的重要指标 ,然而由于地质因素和测试技术的原因 ,镜质组反射率测量值常与预计值有一定的偏差。在三塘湖盆地上古生界烃源岩中 ,可以观察到镜质组反射率的局部增强和镜质组反射率的抑制。局部增强多分布在上二叠统的烃源岩中 ,主要与火山活动有关。这种反射率的增强在平面上分布广泛 ,但纵向上影响范围较小。反射率的抑制是在上古生界烃源岩含有较高含量的腐泥组分背景下产生的。用氢指数模板方法对抑制进行了校正 ,抑制的幅度最大可达 0 .3%     

亚波长设计中的可制造性验证方法

描述了一种采用分辨率提高技术后用于可制造性设计的验证方法.该方法的目的是验证设计功能与设计目的是否一致,更精确地说,使刻印出来的图像与设计一致.还描述了这种基于模型的验证方法的过程建模,实例说明这种方法的性能.     

某军用直流电源的RET方法研究

可靠性强化试验(RET)是一种新兴的试验技术,它使用在产品的设计阶段,用于快速暴露产品的缺陷和薄弱环节。以某军用直流电源为例介绍了可靠性试验方法,并对可靠性强化试验方法的优越性进行了讨论。     

Dough mixing and breadmaking properties of quinoa-wheat flour blends

Flour blends of quinoa-wheat containing 0, 5, 10, 15, and 20% of manually dehulled quinoa meal or flour were evaluated for dough mixing and breadmaking properties and liking of the bread by a small panel. Increasing amounts of quinoa meal or flour increased farinograph absorption and dislike of bread for most of the panel. Dough development time increased with increase in meal but decreased with increase in quinoa flour. At 10% inclusion levels differences in liking from control 100% wheat flour bread were smaller for flour or water extracted meal to most of the panel, than with 10% non-extracted meal. This suggests that 10% inclusion of flour or water extracted meal may have potential for further investigation.     

基于二维直方图分析的二元子图微光图像增强处理

提出了基于二维直方图分析的二元子图微光图像增强处理算法，根据原始图像的二维直方图分布特征，依据相邻像素的相关性数据，将图像分割成二元子图像，对每个子图像分别进行直方图均衡增强处理，最后合成得到完整的处理图像，通过用信息容量等图像评价参数对实验结果进行分析，表明此算法克服了对整幅图像进行直方图均衡时难以把握局部细节的缺点，得到了具有较好视觉质量的处理后微光图像。     

二元复合驱阶段见效特征

针对孤东油田油藏条件，通过室内试验研究，确定了以胜利石油磺酸盐为活性剂主剂和聚合物的二元复合驱油体系，通过两者之间的协同效应，增加水驱波及体积和洗油效率。该体系在孤东油田七区西馆上54—61层进行试验，取得了较好的阶段性降水增油效果。本文分析了复合驱见效特征和影响见效因素，为下步跟踪分析调整具有指导意义。     

Anion Sensing Porphyrin Functionalized Nanoparticles

Disulfide and dithiocarbamate functionalized porphyrins have been synthesized and used as protecting ligands for gold nanoparticle formation either via ligand substitution reactions or by direct synthesis. These nanoparticles have been shown to recognize anions via changes in the absorbance spectrum of the surface adsorbed porphyrin moieties. Association constants, derived from quantitative titrations, indicate a remarkable surface enhancement effect where the surface bound porphyrins bind anions much more strongly than the free receptor in solution.     

Pulsating Jet Impingement Heat Transfer Enhancement

This article presents results from a numerical study of pulsating jet impingement heat transfer. The motivation is to seek conditions offering a significant enhancement compared to steady flow impingement drying. The CFD software package FLUENT was used for simulating slot-type pulsating jet impingement flows with confinement. The parameter study included velocity amplitude ratio, mean jet velocity, and pulsation frequency. The distance from nozzle exit to surface was three times the hydraulic diameter of the nozzle. The Reynolds number based on the nozzle hydraulic diameter and jet temperature was 2,460 with a mean jet velocity of 30 m/s, which is the base case of the numerical experiments. Results showed that time-averaged surface heat transfer increased with increasing velocity amplitude for the same mean jet velocity. Large velocity amplitudes helped enhance heat transfer by two mechanisms: high jet velocity during the positive cycle and strong recirculating flows during the negative cycle. For the cases with different mean jet velocities but the same maximum velocity, time-averaged surface heat flux decreased with decreasing mean jet velocity. As for the effects of pulsation frequency, with high-velocity amplitude ratio, time-averaged surface heat fluxes were at the same level regardless of frequency. However, at low-velocity amplitude ratio, high frequency caused stronger recirculating flows resulting in greater heat transfer compared to the cases with a lower frequency.     

提高润滑油基础油氧化安定性的组合工艺

以生产润滑油基础油的老三套工艺为基础，开发了改善油品氧化安定性的组合工艺。该工艺的主要特点是包括一步络合脱氮过程。实验证明，该组合工艺既可以有效地提高基础油的氧化安定性，又能降低溶剂精制深度，提高基础油收率。     

Photocatalytic degradation of gaseous perchloroethylene in continuous flow reactors: Rate enhancement by chlorine radicals

The degradation of perchloroethylene (PCE) by UV/TiO₂ photocatalysis in gas phase was studied. The degradation efficiency has been compared in different continuous flow reactors: a photocatalytic tangential reactor (PTR) where the air flows tangentially over the catalytic medium and two photocatalytic filtering reactors (PFR) where the air flows through the porous catalytic medium. The degradation rate shows a linear dependence with the concentration of pollutants (up to 350 mg PCE/N m³) for the PTR, but the degradation was negligible for the PFR. The degradation rate was enhanced by accelerating the chlorine radicals’ formation (by adding HCl in catalytic quantity in the air flow or by PCE over-heating). In these conditions, the oxidation rate constant of PCE in the PFR was about five times higher than that in the PTR, although the mass of catalyst involved in the PFR was about 10 times lower and the contact time was about a 1000 times shorter than that of the PTR. Thus, the catalyst is globally more efficiently used in the PFR, as the mass transfer is not limiting. As a result, a degradation mechanism of PCE, involving the generation of free chlorine radicals, as the first limiting step, has been confirmed.