Separation of weak and strong acids by electro-electrodialysis—Experiment and theory

The experimental results of the separation of acetic acid (HA) from the sulfuric acid by the electro-electrodialysis (EED) method and the modeling of process have been presented. The Neosepta membranes CMX and ACM have been used. It has been found that the efficiency of retention of HA is high (>0.9) when the process is conducted below the limiting current density with respect to HSO₄⁻ or SO₄²⁻ anions. The observed current efficiency of the H₂SO₄ removal was rather low (CE_S = ca. 0.7, when the initial concentration of H₂SO₄ in the mixture was 1 or 2 M) which was caused by the nonideal selectivity of the anion-exchange membrane. The experimental results have been described by the model based on the extended Nernst-Planck equation and the Donnan equilibrium. Since the efficiency of the process depended mainly on the selectivity of anion-exchange membrane (ACM), the concentration of fixed charges of that membrane, , and the ratio of volume fraction of pores to their squared tortuosity, V_p/θ², have been chosen as the main fitting parameters. It has been found that the fitting of the EED data depends mainly on , whereas in the modeling of diffusion experiment (or an EED experiment conducted at low current density) both parameters are important. The best fit has been obtained for , i.e. ca. one order smaller than that determined experimentally. The obtained optimal value of V_p/θ², equal to 0.013, is consistent with those previously obtained for other Neosepta anion-exchange membrane.     

固体超强酸S_2O_8~(2-)/SnO_2-SiO_2催化合成环己酮1,2-丙二醇缩酮

采用沉淀-浸渍法制备了固体超强酸S2O28-/SnO2-SiO2,以它为催化剂催化环己酮和1,2-丙二醇合成了环己酮1,2-丙二醇缩酮;考察了带水剂种类及用量、酮醇摩尔比、催化剂用量、反应时间对产品收率的影响,并用正交实验对反应条件进行了优化。实验结果表明,适宜的反应条件为:n(环己酮)∶n(1,2-丙二醇)=1∶1.6、催化剂用量为反应物料总质量的2.0%、带水剂环己烷用量5.0mL、反应时间50min。在此条件下,环己酮1,2-丙二醇缩酮收率达到91.47%;催化剂的稳定性良好,在重复使用5次后环己酮1,2-丙二醇缩酮收率为82.20%,活性下降的主要原因为催化剂表面积碳和吸附了有机物;经傅里叶变换红外光谱和气相色谱质谱分析表明,产物为环己酮1,2-丙二醇缩酮,纯度为100%。     

A disposable single-use electrochemical sensor for the detection of uric acid in human whole blood

We report here a non-enzymatic detecting electrode strip for fast monitoring of uric acid in human whole blood. A single-use amperometric uric acid sensor strip, incorporating a three-electrode configuration, has been fabricated on a polypropylene substrate using low cost screen-printing (thick-film) technology. Both the working and counter electrodes were prepared by screen-printing commercial carbon ink. The integration on the same support of pseudo-reference electrode was obtained by screen-printing a commercial silver ink and subsequent electrochemical pretreatment. Simply by placing a 20 μl human whole blood drop on the strip is enough for uric acid analysis by square-wave voltammetry. Real human whole blood samples were analyzed by this method and compared to the phosphotungstic acid clinical test procedure with satisfactory results.     

鸡脂肪热氧化与风味的关系

以鸡脂肪为原料,测定脂肪在烹调温度下氧化过程中的羰基值,过氧化值,酸值随加热时间的变化,并以这些测定值为监控指标对不同时间的氧化产物作感官评价。研究结果表明,鸡脂肪氧化能产生较好风味感,并且风味感产生的最佳时间为10 h,此时羰基值为22.5 meq/kg。     

Design of the ECRH/ECCD Launcher System for HL-2A Tokamak

An ECRH/ECCD system with two 68GHz/500kW/1S gyrotrons will be built up in HL-2A tokamak. The location of the Gaussian beam waist is 580 mm away from the center of the plasmas and the beam radius is 37 mm at the center of the plasmas. Compared to the minor plasma radius （420 mm）, it is small enough for localized control. The launcher system covers a wide toroidal and poloidal steering range by the two steering plane mirrors. Therefore it is possible to explore the on- and off-axis heating over half of the plasma minor cross section and the co-current drive.     

静载荷和疲劳载荷作用下 C/Al 正交层压板的力学响应

本文讨论静载荷及疲劳载荷作用下 C/Al 正交层压板的力学响应,并考虑损伤过程中的临界现象,以此作为结构设计准则的基础。对静载荷作用的情况:(1)90°铺层的门槛应变ε_(FPF)随着约束程度增加而增加,而且开裂后的行为也受约束程度的影响。(2)经历加载-卸载再重新加载至断裂的过程后,初始试样存在一个剩余永久变形,其损伤状态可以用刚度的变化来表征;而疲劳试样在加载-卸载过程中刚度变化很小,反映其损伤达到一个稳定的状态。对疲劳载荷作用的情况:(1)对于给定的应力比 R,试样会趋于与它所承受的 S_(max)最大值相应的 SDS 状态。循环应力范围的不断增大,会引起基体损伤的增加,从而重新建立新的饱和损伤状态。(2)对于每一损伤状态均有一对应的循环应变范围 Δε。在 SDS 状态下,Δε保持不变。(3)以刚度下降为损伤参数对 C/Al 层压板进行了降级应力分析,并由此来预计在ΔS_(sh)以下,层压板不会发生疲劳损伤累积。     

用热分析法研究硝化棉的熔化过程

用ＭＤＳＣ，显微镜温台熔点测定仪和固体原位反应池／快速扫描傅立叶变换红外光谱联用装置考察了硝化棉的熔化过程。ＭＤＳＣ曲线表明吸热过程是可逆的，它系由ＮＣ和部分分解凝聚相产物的混合物的固液相变所引起。由ＮＣ的ＭＤＳＣ曲线得到的熔点，熔化含，熔化熵，分解含和分解反应热温熵分别为４７６．８４Ｋ，２０５．６Ｊ．ｇ＾－１，０．４３１２Ｊ．ｇ＾－１．Ｋ＾－１，－２４７５．０Ｊ．ｇ＾－１，－５．２４２Ｊ．ｇ＾－     

新型聚丙烯酸(934P、980)树脂的制备

详细研究了以乙酸乙酯和环己烷为溶剂，丙烯酸为单体，BPO，LPO，AIBN为引发剂，聚烯基多醚为交联剂，合成增稠能力强、透明度高的聚丙烯酸树脂。于混和溶剂存在下制得的聚合物，消除了以往由二氯甲烷为溶剂的反应介质中所得产品的毒性，可广泛应用于医药及日用化工等行业。     

用αβ谱仪测量人工αβ放射性气溶胶体积活度的试验研究

本文介绍了用αβ谱仪系统同时测量αβ谱、实现Ｒｎ／Ｔｈ子体补偿、确定超铀α核素气溶胶体积活度及人工放射性气溶胶总β体积活度的技术途径。利用ＲａＡ、ＲａＣ′ａ峰的二段时间计数可确定空气中ＲａＡ、ＲａＢ、ＲａＣ的气溶胶体积活度，相应的，也能给出ＲａＢ、ＲａＣ对总β计数的贡献。根据一般环境条件下的平衡比，用ＴｈＣ′的。计数修正Ｔｈ子体对αβ测量的影响。￣［２３９］ｐｕ或／和￣［２４１］Ａｍ人工核素的α计数，可通过两段时间分别扣除ＲａＡ、ＲａＣ′拖尾的方法确定；β计数分别扣除Ｒｎ／Ｔｈ子体β贡献即可确定。在本文规定的测量条件下，对室内天然Ｒｎ子体水平在１５Ｂｑ／ｍ￣３以下，超铀α核素气溶胶体积活度的测量下限可达到０．１Ｂｑ／ｍ￣３；即使在７５Ｂｑ／ｍ￣３环境下，人工核素总β的测量下限也可达ｌＢｑ／ｍ￣３以下。