FCC装置主风分布管喷嘴磨损的气相流场分析

用FLUENT流体计算软件对FCC装置再生器树枝状分布管喷嘴流场进行了计算,分析了喷嘴发生磨损的机理.对喷嘴流场的计算表明喷嘴磨损是催化剂颗粒造成的,属于气固两相流冲蚀磨损.由于某些喷嘴的压力降偏低和流场存在偏流,造成催化剂颗粒倒流至喷嘴内部或分布支管内部.催化剂颗粒流经喷嘴时,斜向冲击内壁产生冲蚀磨损.磨损首先发生在喷嘴内壁局部区域,形成圆弧状磨损痕迹,再将喷嘴磨穿,逐渐扩大为整个喷嘴,磨掉喷嘴.这些分析结果可为主风分布管的设计提供帮助.     

番禺30-1砂岩强水驱气藏储层非均质性研究

针对垂向非均质性严重且边底水能量强的番禺30-1气田面临的潜在开发问题，通过岩心分析及测井二次解释，对其夹层特征及储层非均质性等进行了研究，划分出19个流动单元并定量描述了各流动单元的特征参数，建立了该气田的精细地质模型。综合评价表明，新建的地质模型具有较高的精度，为该气藏合理开发提供了坚实的地质基础。     

控制室格栅形屏蔽设计的计算

以抗雷击电磁脉冲干扰为例，按下列2种情况讨论控制室格栅形大空间屏蔽的设计计算：已知屏蔽网格，求磁场强度的衰减是否符合控制系统的脉冲磁场抗扰度；已知控制系统的脉冲磁场抗扰度，求屏蔽网格的宽度W等参数。     

反凝析现象对雅克拉凝析气处理工艺的影响

雅克拉凝析气田位于塔里木盆地北部，地处新疆维吾尔自治区阿克苏地区境内，它是中国石化集团公司西北分公司探明并投入开发的最大凝析气田，采用衰竭式开采。通过对井口物流的相态研究，认识了凝析气的反凝析规律，采取了提高凝析气中C^＋₃收率的方法，以确保外输干气的烃露点达到管输要求，并提高该气田开发的经济效益。在工艺方案设计过程中，通过多种工艺方案比选，确定选用膨胀机进口压力为6.0 MPa的膨胀机制冷工艺， C^＋₃收率达到92％以上，外输干气烃露点满足管输要求。     

含硫化氢气井钻井过程中的腐蚀因素与防护研究

在含硫气井的钻井过程中对于HRC大于22的钻具钢材除了腐蚀疲劳之外，在pH值小于9的环境中会发生硫化物应力腐蚀破裂，这种破坏比腐蚀疲劳更突然、更快，使钻杆大量损坏。含硫气井在钻井过程中，由于湿硫化氢的出现，常常会出现油管、套管、钻井设备、钻井仪器以及对支持保护管柱的水泥环柱等腐蚀和损坏问题，为此，阐述了湿硫化氢的腐蚀特点、机理，归纳总结了影响腐蚀的因素，综述了如何在这些方面防止其腐蚀，使损失减小，为指导油管、套管防腐工程实践提供了依据。建议在钻井过程中采用碱性钻井液，其pH值可到9或更高(至pH值12)，以减缓或防止钻井过程中电化学从硫化物应力腐蚀破裂；含硫气井用的钻杆应该间歇使用。钻杆停用堆置时间可使其放氢，使钻杆恢复韧性，防止硫化物应力腐蚀断裂。     

结构形式对椭圆扁管管内传热与流阻性能影响

利用数值模拟方法结合场协同理论,对直椭圆扁管、单向螺旋椭圆扁管和变向螺旋椭圆扁管管内传热与流动情况进行了数值模拟计算和理论分析,比较研究了不同的Re、Pr下,3种椭圆扁管的管内传热与流阻特性。结果表明,单向螺旋椭圆扁管和变向螺旋椭圆扁管与直椭圆扁管相比有很好的强化传热性能,而变向螺旋椭圆扁管要比单向螺旋椭圆扁管的强化传热性能更好。在管内流体具有高Pr及低Re的条件下,2种螺旋椭圆扁管的强化传热效果显著,可作为很好的强化传热元件应用于工程实际中。     

一种估算单桩经济直径的方法

在滩海油田开发过程中,经常需要设立立管桩,在环境荷载的作用下,立管桩顶部会发生位移,较大的位移对立管及栈桥的安全很不利,因此需要合理确定单桩的直径。埕岛油田在确定单桩直径时引入了经济直径的概念,文章对经济直径的原理进行了分析,给出了桩顶位移和桩径经济指数计算公式,并举例进行了计算,得出了桩径与桩顶位移及桩径经济指数的关系曲线, 进而求得经济桩径的取值范围。文章还对该方法的优缺点进行了分析。     

Studies on high density polyethylene (HDPE) functionalized by ultraviolet irradiation and its application

The structure and properties of high density polyethylene (HDPE) functionalized by ultraviolet irradiation at different light intensities in air were studied by electron analysis, FTIR spectroscopy, contact angle with water, differential scanning calorimetry and mechanical properties measurement. The results show that oxygen‐containing groups such as C?O, C—O and C(?O)O were introduced onto the molecular chain of HDPE following irradiation, and the rate and efficiency of HDPE functionalization increased with enhancement of irradiation intensity. After irradiation, the melting temperature, contact angle with water and notched impact strength of HDPE decreased, the degree of crystallinity increased, and their variation amplitude increased with irradiation intensity. Compared with HDPE, the yield strength of HDPE irradiated at lower light intensity (32 W m^?2 and 45 W m^?2) increases monotonically with irradiation time, and the yield strength of HDPE irradiated at higher light intensity (78 W m^?2) increases up to 48 h and then decreased with further increase in irradiation time. The irradiated HDPE behaved as a compatibilizer in HDPE/polycarbonate (PC) blends, and the interface bonding between HDPE and PC was ameliorated. After adding 20 wt% HDPE irradiated at 78 W m^?2 irradiation intensity for 24 h to HDPE/PC blends, the tensile yield strength and notched Izod impact strength of the blend were increased from 26.3 MPa and 51 J m^?1 to 30.2 MPa and 158 J m^?1, respectively. Copyright © 2003 Society of Chemical Industry     

Poly(vinyl pyrrolidone)—C70 complexes in aqueous solutions

Aqueous solutions of poly(vinyl pyrrolidone)-fullerene complexes (PVP-C₇₀) have been studied using static and dynamic light scattering methods. Two diffusive processes were detected. The slow diffusion was interpreted as dynamics of large intermolecular PVP-C₇₀ complexes while the fast diffusion was associated with the presence of individual PVP molecules in solution. It was also shown that the molecular weights and dimensions of PVP-C₇₀ complexes are smaller than for PVP-C₆₀ by a factor of 2.5-3. In aqueous solutions of PVP-C₇₀ complex the depolarization and dissymmetry of scattered light were observed in contrast to PVP-C₆₀ solutions. It reveals the existence of anisotropic structures in PVP-C₇₀ solutions. Intermolecular interactions within PVP-C₇₀ complexes are weak and a hydrodynamic field can destroy complexes.