Computer‐aided design methodology for linearity enhancement of multiwatt GaN HEMT amplifiers using multiple parallel devices

This article presents a design methodology for linearizing GaN HEMT amplifiers based on splitting a large FET into multiple parallel FETs with same total gate periphery and by biasing them individually. By varying the biases, the magnitude and the phase of the IMD3 components at the output of FET changes. A detailed simulation methodology using commercial microwave CAD software is presented. Simulation results show that by biasing one device in Class AB and other(s) in deep Class AB mode, IMD3 components of parallel FETs can be made out of phase to each other leading to cancellation and improvement in linearity. Three prototype circuits were simulated using (a) a single 5 mm FET (1 × 5 mm), (b) two parallel 2.5 mm FETs (2 × 2.5 mm), and (c) four parallel 1.25 mm FETs (4 × 1.25 mm), for a total gate periphery of 5 mm, over the frequency range of 0.8 to 1.0 GHz. IMD3 improvement up to 20 dBc was achieved with the 4 × 1.25 mm circuit when the FET biases were optimized. Measurement results show improvement in linearity up to 20 dBc for 4 × 1.25 mm circuit. The proposed method improves linearity without a substantial penalty on the power consumption and is straightforward to implement.     

Benchmark value determination of energy efficiency indexes for coal-fired power units based on data mining methods

The operational optimisation of coal-fired power units is important for saving energy and reducing losses in the electric power industry. One of the key issues is how to determine the benchmark values of the energy efficiency indexes of the units. Therefore, a new framework for determining these benchmark values is proposed, based on data mining methods. First, the energy efficiency key performance indicators (KPIs) associated with the net coal consumption rate (NCCR) were selected based on the domain knowledge. Second, the decision-making samples with minimal NCCR were acquired with the fuzzy C-means (FCM) clustering algorithm, and the corresponding clustering centres were employed as the benchmark values. Finally, based on the support vector regression (SVR) algorithm, the target values of the NCCR were obtained with the KPIs as input, and the energy saving potential was evaluated by comparing the target values with the historical values of the NCCR. An actual on-duty 1000 MW unit was taken as study unit, and the results show that the energy saving potential is remarkable when the operators adjust the KPIs based on the calculated benchmark values.     

Jaya Learning-Based Optimization for Optimal Sizing of Stand-Alone Photovoltaic,Wind Turbine,and Battery Systems

Renewable energy sources (RESs) are considered to be reliable and green electric power generation sources. Photovoltaics (PVs) and wind turbines (WTs) are used to provide electricity in remote areas. Optimal sizing of hybrid RESs is a vital challenge in a stand-alone environment. The meta-heuristic algorithms proposed in the past are dependent on algorithm-specific parameters for achieving an optimal solution. This paper proposes a hybrid algorithm of Jaya and a teaching–learning-based optimization (TLBO) named the JLBO algorithm for the optimal unit sizing of a PV–WT–battery hybrid system to satisfy the consumer’s load at minimal total annual cost (TAC). The reliability of the system is considered by a maximum allowable loss of power supply probability (LPSP_max) concept. The results obtained from the JLBO algorithm are compared with the original Jaya, TLBO, and genetic algorithms. The JLBO results show superior performance in terms of TAC, and the PV–WT–battery hybrid system is found to be the most economical scenario. This system provides a cost-effective solution for all proposed LPSP_max values as compared with PV–battery and WT–battery systems.     

Modeling and design of 3-D MPPT for ultra low power RF energy harvesters

Radio-Frequency (RF) energy harvesting must cope with the limited availability and high variability of the energy source. In this paper, the modeling of an RF harvester for ultra low power environments is presented. A mathematical model based on theoretical analysis is developed. The model demonstrates that the maximum transferred power point is located in a three-dimensional space defined by the input capacitance, the output voltage, and the load resistance of the rectifier circuit. Moreover, the mathematical model returns results in substantial agreement with the SPICE simulation results, while guaranteeing a remarkable reduction of the required computation time. Furthermore, the paper reports the implementation of a mixed signal system for the 3-D MPPT, to be embedded in an RF harvester, in a 65 nm CMOS technology. The circuit exhibits a simulated power consumption lower than 100 nW, making this solution suitable for ultra low power harvesting.     

超精密气体静压系统节流器法向随机微振动研究

以无气腔平面节流器为研究对象,对节流器流固耦合法向随机微振动进行了理论仿真和实验研究。受限于节流器厚度与气膜厚度尺寸的差异和输入初始边界条件,建立了节流器的COMSOL仿真简化模型,对节流器-气膜微流场进行双向流固耦合数值模拟。仿真结果表明,节流器的法向随机微振动幅值关于节流器中心对称,且由中心向边缘逐渐增大;微振动幅值随气体入口流速的增大而增大。实验采用纳米级激光测振仪,依次测量供气压力为0.1,0.2,…,0.5 MPa时尺寸为75 mm×50 mm×14 mm的HEXAGON双环联结型节流器多个不同位置的法向振动,实验结果表明,法向随机微振动幅值分布特性与仿真结果一致,关于节流器中心对称,且由中心向边缘逐渐增大,验证了节流器法向微振动的"跷跷板"振动形式;在0.5 MPa供气压力下,边缘振动幅值超过1 nm。对实验数据进行功率谱密度分析,结果表明不同供气压力下法向随机微振动均在9.4 kHz和10.6 kHz处产生较大功率,可认为与节流器-气膜流固耦合系统的固有频率有关。研究结果有效地揭示了节流器法向随机微振动的特性,为气体静压系统避开随机共振区、优化气体静压系统的设计提供了理论指导。     

An up to date review of continuously variable speed wind turbines with mechatronic variable transmissions

As a promising and potential alternative to conventional fixed or variable speed wind turbines, continuously variable speed wind turbines (CVSWTs) with variable transmissions offer improved power efficiency and enhanced power control capabilities. The CVSWTs can be generally achieved by adapting mechatronic variable transmissions in the turbine drive train for continuously variable speed operations for wind turbines. Therefore, this paper serves to provide an up to date and exhaustive review of the CVSWTs with mechatronic variable transmissions such as mechanical variable transmission, electrical variable transmission, and power splitting transmission. In this paper, the analysis of CVSWTs with different mechatronic transmission topologies is performed regarding basic configurations, dynamic characteristics, control principles, and experimental or simulation results. Review results indicate the feasibility of applying CVSWTs with such mechatronic transmissions and highlight superiorities of the CVSWTs with power splitting transmission. The CVSWT with power splitting transmission will be particularly suitable for megawatt‐scale turbine systems and will hence increase the economic competitiveness of these turbines due to its large power capacity and high reliability. The directions or challenges for future investigations of CVSWTs with such mechatronic transmissions are also presented to foster in‐depth understanding of such CVSWTs and their control strategies.     

“电网一张图”时空信息管理系统

文章首先总结了电力企业信息管理系统的现状,提出了多源信息管理系统融合集成的邦联、子集和完全融合3种方式,分析了3种方式的优缺点,以建设企业"互联网搜索"型数字引擎为目标,提出了融合基于本体的图数据库建模,多维关联与路径因果分析,和人机共生互动可视化决策于一体的企业信息管理系统技术发展趋势;在系统分析目前正在快速发展的图数据库技术与传统关系数据库之间的本质区别基础上,总结原创的电力图计算平台技术的特点;在此基础上讨论"电网一张图"在建设能源互联网时空信息管理平台数据关联索引图中的核心作用,提出了支持能源互联网建设的"电网一张图"时空信息管理系统的技术架构与特点,最后总结"电网一张图"时空信息管理系统在提高电网安全运行水平、提升客户服务水平、增强清洁能源消纳水平、改善经营绩效水平、以及为综合能源服务和建设能源生态等提供数据服务方面的广阔应用场景。     

A low power and low phase-noise 91~96 GHz VCO in 90 nm CMOS

This paper reports a 94 GHz CMOS voltage-controlled oscillator (VCO) using both the negative capacitance (NC) technique and series-peaking output power and phase noise (PN) enhancement technique. NC is achieved by adding two variable LC networks to the source nodes of the active circuit of the VCO. NMOSFET varicaps are adopted as the required capacitors of the LC networks. In comparison with the conventional one, the proposed active circuit substantially decreases the input capacitance (C_in) to zero or even a negative value. This leads to operation (or oscillation) frequency (OF) increase and tuning range (TR) enhancement of the VCO. The VCO dissipates 8.3 mW at 1 V supply. The measured TR of the VCO is 91~96 GHz, close to the simulated (92.1~96.7 GHz) and the calculated one (92.2~98.2 GHz). In addition, at 1 MHz offset from 95.16 GHz, the VCO attains an excellent PN of – 98.3 dBc/Hz. This leads to a figure-of-merit (FOM) of ?188.5 dBc/Hz, a remarkable result for a V- or W-band CMOS VCO. The chip size of the VCO is 0.75 × 0.42 mm², i.e. 0.315 mm².     

基于大数据挖掘的用电行为分析

得益于智能电网的发展,电力大数据的价值与作用逐渐被挖掘。通过对电力大数据的深入挖掘与研究,可促进电网企业管理水平的进一步提升,为我国智能电网的发展提供助力。而依托于大数据挖掘的用户用电行为分析,可实现当前企业电网调控与需求侧的充分融合,为电力系统的稳定性运行提供保障。基于此,文章针对大数据挖掘的用电行为分析进行深入探析,以期为智能电网发展提供帮助。     

Parallel Multipopulation Differential Evolutionary Particle Swarm Optimization for Voltage and Reactive Power Control

This paper presents parallel multipopulation differential evolutionary particle swarm optimization (DEEPSO) for voltage and reactive power control (VQC). The problem can be formulated as a mixed integer nonlinear optimization problem and various evolutionary computation techniques have been applied to the problem including PSO, differential evolution (DE), and DEEPSO. Since VQC is one of the online controls, speed‐up of computation is required. Moreover, there is still room for improvement in solution quality. This paper applies parallel multipopulation DEEPSO in order to speed up the calculation and improve solution quality. The proposed method is applied to IEEE 30, 57, and 118 bus systems. The results indicate that the proposed method can realize fast computation and minimize more active power losses than the conventional evolutionary computation techniques.