Status and initial experiments of DRAGON-V facility for lithium-lead blanket technologies of hydrogen fusion reactors

A dual-coolant integrated experimental facility named DRAGON-V has been developed at the Institute of Nuclear Energy Safety Technology, Hefei Institute of Physical Science, Chinese Academy of Sciences, for the key technology research and performance evaluation of candidate liquid lithium-lead (PbLi) blanket of hydrogen fusion reactors. The loop is composed of a material test sub-loop and thermal-hydraulic test sub-loop, the design parameters are PbLi inventory 20 tons, PbLi temperature up to 550 °C, the maximum PbLi flow rate up to 40 kg/s. A novel cold trap system is designed to remove the suspended and crystalized impurities in PbLi fluid with three cooling zones and cross row arrangement of rod bundle filter elements. The paper describes the loop itself and its major components, initial loop testing, flow and measurement diagnostics and current experiments. The obtained test results of the loop and its components have demonstrated that the new facility is fully functioning and ready for experimental studies of material corrosion with/without a magnetic field, magnetohydrodynamic (MHD) effect, purification, heat and mass transfer phenomena in PbLi flows and can also be used in mock-up testing in conditions relevant to fusion applications.     

基于单片机C8051F500的无刷直流电机控制研究

永磁无刷直流电机是近些年发展起来的一种新型电机,具有效率高、调速性能好、启动转矩大等诸多优点,在运动控制领域中的应用日趋广泛。基于电机专用控制芯片MC33035,采用单片机C8051F500为主控芯片,设计一款无刷直流电机智能控制器,实现对无刷直流电机启动停止、正反转、调速、转速显示等控制。通过简要介绍无刷直流电机工作原理,使用MATLAB/Simulink对控制系统进行建模仿真,对无刷直流电机控制系统进行软、硬件设计。实验结果表明,该控制系统运行稳定,抗干扰性强,具有良好的市场应用价值。     

Multicolour tunable luminescence of thermal-stable Ce3+/Tb3+/Eu3+-triactivated Ca3Gd(GaO)3(BO3)4 phosphors via Ce3+ → Tb3+ → Eu3+ energy transfer for near-UV WLEDs applications

A series of single-component blue, green and red phosphors have been fabricated based on the Ca₃Gd(GaO)₃(BO₃)₄ host through doping of the Ce³⁺/Tb³⁺/Eu³⁺ ions, and their crystal structure and photoluminescence properties have been discussed in detail. A terbium bridge model via Ce³⁺ → Tb³⁺ → Eu³⁺ energy transfer has been studied. The emission colours of the phosphors can be tuned from blue (0.1661, 0.0686) to green (0.3263, 0.4791) and eventually to red (0.5284, 0.4040) under a single 344 nm UV excitation as the result of the Ce³⁺ → Tb³⁺ → Eu³⁺ energy transfer. The energy transfer mechanisms of Ce³⁺ → Tb³⁺ and Tb³⁺ → Eu³⁺ were found to be dipole-dipole interactions. Importantly, Ca₃Gd(GaO)₃(BO₃)_4:Ce³⁺,Tb³⁺,Eu³⁺ phosphors had high internal quantum efficiency. Moreover, the study on the temperature-dependent emission spectra revealed that the Ca₃Gd(GaO)₃(BO₃)_4:Ce³⁺,Tb³⁺,Eu³⁺ phosphors possessed good thermal stability. The above results indicate that the phosphors can be applied into white light-emitting diodes as single-component multi-colour phosphors.     

Nature inspired supply chain solutions: definitions,analogies, and future research directions

ABSTRACT

Supply chains are becoming increasingly complex, and many companies and researchers are looking to nature for finding solutions. In this paper, we provide a narrative synthesis and systematic review to explore state-of-the-art, and identify key areas for exploration of nature inspired solutions in the supply chain area. We consider strategic, tactical, and operational decisions within supply chains and identify analogies between biological systems and supply chains to create a new research agenda. Our findings show that the majority of the research in nature inspired supply chains from the systemic perspective focuses on closed loop supply chains. In contrast, similar systemic solutions such as industrial symbiosis, circular economy, and industrial ecology have not been explored as frequently. Reducing production waste (industrial symbiosis) in addition to end-of-life product waste (closed loop supply chains), optimising raw material use and extending the life of used resources (circular economy), investigating the interactions between biosphere and technosphere (industrial ecology), and seeking solutions to industrial problems from nature (biomimicry) are all possible paths for reaching a zero-waste economy. These systemic solutions have a considerable impact on the supply chains at the strategic, tactical, and operational levels, which need to be explored to identify efficient and effective solutions.     

A low power and low phase-noise 91~96 GHz VCO in 90 nm CMOS

This paper reports a 94 GHz CMOS voltage-controlled oscillator (VCO) using both the negative capacitance (NC) technique and series-peaking output power and phase noise (PN) enhancement technique. NC is achieved by adding two variable LC networks to the source nodes of the active circuit of the VCO. NMOSFET varicaps are adopted as the required capacitors of the LC networks. In comparison with the conventional one, the proposed active circuit substantially decreases the input capacitance (C_in) to zero or even a negative value. This leads to operation (or oscillation) frequency (OF) increase and tuning range (TR) enhancement of the VCO. The VCO dissipates 8.3 mW at 1 V supply. The measured TR of the VCO is 91~96 GHz, close to the simulated (92.1~96.7 GHz) and the calculated one (92.2~98.2 GHz). In addition, at 1 MHz offset from 95.16 GHz, the VCO attains an excellent PN of – 98.3 dBc/Hz. This leads to a figure-of-merit (FOM) of ?188.5 dBc/Hz, a remarkable result for a V- or W-band CMOS VCO. The chip size of the VCO is 0.75 × 0.42 mm², i.e. 0.315 mm².     

Design of an adaptive super-twisting decoupled terminal sliding mode control scheme for a class of fourth-order systems

This paper proposes an adaptive super-twisting decoupled terminal sliding mode control technique for a class of fourth-order systems. The adaptive-tuning law eliminates the requirement of the knowledge about the upper bounds of external perturbations. Using the proposed control procedure, the state variables of cart-pole system are converged to decoupled terminal sliding surfaces and their equilibrium points in the finite time. Moreover, via the super-twisting algorithm, the chattering phenomenon is avoided without affecting the control performance. The numerical results demonstrate the high stabilization accuracy and lower performance indices values of the suggested method over the other ones. The simulation results on the cart-pole system as well as experimental validations demonstrate that the proposed control technique exhibits a reasonable performance in comparison with the other methods.     

双层毛细芯对环路热管传热性能的实验分析

环路热管作为一种高效的相变传热装置,其性能与位于蒸发器和储液槽之间的毛细芯结构密切相关。为了更深入研究双层毛细芯对环路热管传热性能的影响,利用不同颗粒直径铜粉制备双层毛细芯,在毛细芯总厚度为5 mm的条件下,通过调整大粒径和小粒径层的相对厚度来改变毛细芯厚度比,对平板型蒸发器环路热管启动和变工况运行进行实验测试。实验结果表明:在同一工况下,不同厚度比的双层毛细芯启动特性存在显著差异,启动过程中出现小粒径层蒸发效率低引起的温度过冲和环路热管中气液两相流变化导致的温度振荡;同时存在一个较优的双铜层毛细芯厚度比,大粒径(180～280μm)铜层厚度为3 mm可提高蒸发效率,小粒径(56～71μm)铜层厚度为2 mm可提供足够毛细抽吸力保证环路热管稳定运行。搭载该厚度毛细芯的环路热管不仅启动速度快(125 s),而且总热阻和蒸发器壁面温度均最低,最大加热功率达到120 W(21.10 W/cm~2),对应热阻为0.17 K/W。     

Two-stage optimization for machine learning workflow

Machine learning techniques play a preponderant role in dealing with massive amount of data and are employed in almost every possible domain. Building a high quality machine learning model to be deployed in production is a challenging task, from both, the subject matter experts and the machine learning practitioners.For a broader adoption and scalability of machine learning systems, the construction and configuration of machine learning workflow need to gain in automation. In the last few years, several techniques have been developed in this direction, known as AutoML.In this paper, we present a two-stage optimization process to build data pipelines and configure machine learning algorithms. First, we study the impact of data pipelines compared to algorithm configuration in order to show the importance of data preprocessing over hyperparameter tuning. The second part presents policies to efficiently allocate search time between data pipeline construction and algorithm configuration. Those policies are agnostic from the metaoptimizer. Last, we present a metric to determine if a data pipeline is specific or independent from the algorithm, enabling fine-grain pipeline pruning and meta-learning for the coldstart problem.     

盖子环替换及定点突变提高菜豆环氧化物水解酶对邻甲基苯基缩水甘油醚的催化性能

菜豆环氧化物水解酶1和2（PvEH1、PvEH2）能够动力学拆分外消旋邻甲基苯基缩水甘油醚（rac-oMGE），从而保留(R)-oMGE。基于对PvEH1和PvEH2结构的同源模拟和分析，发现二者分子中的盖子环差异较大，故本文选择盖子环作为研究目标。经融合聚合酶链式反应（FPCR），获得了PvEH2的盖子环区域被PvEH1对应区域替换的杂合酶Pv2Pv1。用全细胞酶E. coli/pv2pv1催化rac-oMGE，当(S)-oMGE刚好水解完全时，产物(S)-3-邻甲苯基-1,2-丙二醇（(S)-oTPD）的ee_p由PvEH2的58.3%提高至75.5%。为进一步提高酶的性质，在Pv2Pv1中选取11个氨基酸位点进行丙氨酸(A)突变，获得最优突变子E. coli/pv2pv1^K176A，活性为E. coli/pv2pv1（4.2U/g）的2.1倍，且当S构型的底物刚好完全水解时，(S)-oTPD的ee_p进一步提高为80.3%。分子对接分析发现，盖子环替换和K176位点突变为A，均使(R)-oMGE环氧环中的C_α更易受到酶中D101位点的攻击。利用E. coli/pv2pv1^K176A催化150mmol/L rac-oMGE水解制备(R)-oMGE（ee_s＞99%）和(S)-oTPD（ee_p=80.4%），二者的产率Y_S和Y_P分别为32.7%和60.1%，时空产率STY_S和STY_P为1.6g/(L·h)和3.3g/(L·h)。本实验为改善EH的催化性质提供了一种有效策略。