Leading edge erosion of wind turbines: Effect of solid airborne particles and rain on operational wind farms

Leading edge erosion (LEE) affects almost all wind turbines, reducing their annual energy production and lifetime profitability. This study presents results of an investigation into 18 operational wind farms to assess the validity of the current literature consensus surrounding LEE. Much of the historical research focuses on rain erosion, implying that this is the predominant causal factor. However, this study showed that the impact of excessive airborne particles from seawater aerosols or from adverse local environments such as nearby quarries greatly increases the levels of LEE. Current testing of leading edge protection coatings or tapes is based on a rain erosion resistivity test, which does little to prove its ability to withstand solid particle erosion and may drive coating design in the wrong direction. Furthermore, it was shown that there is little correlation between test results and actual field performance. A method of monitoring the expected level of erosion on an operational wind turbine due to rain erosion is also presented. Finally, the energy losses associated with LEE on an operational wind farm are examined, with the average annual energy production dropping by 1.8% due to medium levels of erosion, with the worst affected turbine experiencing losses of 4.9%.     

An up to date review of continuously variable speed wind turbines with mechatronic variable transmissions

As a promising and potential alternative to conventional fixed or variable speed wind turbines, continuously variable speed wind turbines (CVSWTs) with variable transmissions offer improved power efficiency and enhanced power control capabilities. The CVSWTs can be generally achieved by adapting mechatronic variable transmissions in the turbine drive train for continuously variable speed operations for wind turbines. Therefore, this paper serves to provide an up to date and exhaustive review of the CVSWTs with mechatronic variable transmissions such as mechanical variable transmission, electrical variable transmission, and power splitting transmission. In this paper, the analysis of CVSWTs with different mechatronic transmission topologies is performed regarding basic configurations, dynamic characteristics, control principles, and experimental or simulation results. Review results indicate the feasibility of applying CVSWTs with such mechatronic transmissions and highlight superiorities of the CVSWTs with power splitting transmission. The CVSWT with power splitting transmission will be particularly suitable for megawatt‐scale turbine systems and will hence increase the economic competitiveness of these turbines due to its large power capacity and high reliability. The directions or challenges for future investigations of CVSWTs with such mechatronic transmissions are also presented to foster in‐depth understanding of such CVSWTs and their control strategies.     

Turbulent times: tourists’ attitudes towards wind turbines in the Southern Highlands in Iceland

As a response to the threat of climate change, many nations are increasing their use of renewable energy, including wind energy. Large wind farms often conflict with other land uses, particularly tourism, which is a growing industry worldwide. In Iceland, tourism has recently become the largest export sector, with majority of tourists travelling to the country to experience its nature. This paper examines tourists’ opinions and perceptions of wind power development in the Southern Highlands of Iceland and compares how number, size and proximity of wind turbines, and the landscape in which they are situated, influence tourists’ perceptions. The study is based on an on-site questionnaire survey conducted in 2015. The results indicate that one-third of the travellers would be less likely to visit the Southern Highlands if a proposed wind farm were built, and two-thirds think that wind turbines would decrease the area’s attractiveness.     

风速时间序列混沌判定方法比较研究

混沌识别是对非线性时间序列进行混沌预测的前提。针对时间序列风速确定性与随机性相结合的复杂非线性特征,研究了不同的混沌识别方法,并对风速时间序列进行混沌特征识别。应用随机噪声、周期运动及经典混沌系统的时间序列对所选方法进行可靠性验证。对美国国家风能研究中心M2测风塔实测时间序列风速数据进行非线性混沌特征识别。结果表明:风速时间序列具有明显的混沌特征;各风速时间序列表现出不同程度的混沌特征;各混沌识别方法对风速时间序列混沌特征的表达形式不同,互为补充,相互验证。     

煤矿局部通风机风筒保护装置设计应用

为了提高掘进巷道通风稳定性,降低局部通风机风筒损坏率及漏风系数,提高风筒使用寿命,潞安集团司马煤业公司通风队通过技术分析设计了一套风筒保护装置,该装置提高了风筒使用寿命,降低了风筒漏风量,避免了掘进巷道风量不足现象,取得了显著应用成效。     

搅拌式风力致热装置启动性能研究

搭建搅拌式风力致热试验台,以自制的2种致热器为研究对象,使其分别在3个不同平均角加速度24.92、14.66、8.04 rad/s2下启动。通过动态扭矩测试仪和数据采集仪测试记录致热器启动阶段的相关数据。结果表明:致热器启动时所需扭矩与角加速度的一次方、转速、叶片半径的二次方成正比,同时得出这些因素之间的关系式;满负荷时,启动扭矩会出现一个峰值,且角加速度越大峰值越大,自然风必须提供峰值以上的扭矩,否则装置无法启动。     

Wind turbine speed control of a contactless piezoelectric wind energy harvester

ABSTRACT

Wind turbine control is an important task to make the electricity generation secure in terms of energy demand and machine safety. It also yields to control the desired power level and optimized energy because of the assignment of turbine speed. The contactless piezoelectric wind energy harvester (CPWEH) used in this study has three piezoelectric layers located around the shaft with 120 degrees apart and they are buckled by the magnetic force without any physical contact. The superiority of this device is to generate energy for low wind speeds such as 1.5 m/s. However, for high speeds, high total harmonic distortions (THDs) govern the waveforms, thus controlling the turbine speed becomes necessary for optimizing the output power. Encouraged by this, a small low inertia dc generator is coupled with the wind turbine, and the generator terminals are connected to a resistor through a power switch to generate a braking torque that opposes to wind speed direction. By controlling the switch properly, turbine speed is ensured to remain within a certain band, which accordingly prevents the turbine from rotating very fast at damaging wind speeds. Several experiments are performed on the developed CPWEH with/without the presented control scheme which prove the existence of promising performance of our proposal.     

考虑流固耦合的Spar型浮式风力机涡激运动特性研究

对弹性支撑单圆柱在均匀流作用下的涡激运动特性进行数值模拟,捕捉到"锁定区"、"拍"、"频率变换"等现象。柱体周围流场采用Fluent求解,将4阶Runge-Kutta方法代码写入用户自定义函数(UDF)求解运动微分方程,运用动网格技术更新流场,实现圆柱与流场的非线性耦合作用。发现随着折合速度的增大,涡激运动响应可分为锁定前支、锁定区、锁定后支3个阶段,在进入锁定区前(折合速度Ur=3)横向运动响应发生拍现象,当跨过锁定区后(折合速度Ur=10)发生频率变换现象。结果表明,横向涡激运动有较大范围的频率锁定现象,频率解锁前后圆柱涡激运动轨迹由"右8字"形变换为"左8字"形。     

Optimal supplementary frequency controller design using the wind farm frequency model and controller parameters stability region

In most of the existing studies, the frequency response in the variable speed wind turbines (VSWTs) is simply realized by changing the torque set-point via appropriate inputs such as frequency deviations signal. However, effective dynamics and systematic process design have not been comprehensively discussed yet. Accordingly, this paper proposes a proportional-derivative frequency controller and investigates its performance in a wind farm consisting of several VSWTs. A band-pass filter is deployed before the proposed controller to avoid responding to either steady state frequency deviations or high rate of change of frequency. To design the controller, the frequency model of the wind farm is first characterized. The proposed controller is then designed based on the obtained open loop system. The stability region associated with the controller parameters is analytically determined by decomposing the closed-loop system's characteristic polynomial into the odd and even parts. The performance of the proposed controller is evaluated through extensive simulations in MATLAB/Simulink environment in a power system comprising a high penetration of VSWTs equipped with the proposed controller. Finally, based on the obtained feasible area and appropriate objective function, the optimal values associated with the controller parameters are determined using the genetic algorithm (GA).     

基于GA-BP的汽车风振噪声声品质预测模型

目前对于汽车风振噪声的优化研究主要以声压级（Sound pressure level，SPL）作为单一评价指标，既不能全面反映噪声的物理属性，也无法考虑人耳对噪声的主观认知过程。为准确评价风振噪声，引入声品质，运用大涡模拟（Large eddy simulation，LES）对风振噪声进行数值仿真，根据实车道路试验判断仿真的准确性；对仿真结果进行声品质客观评价与主观评价，综合声品质客观评价参数与声品质主观评价试验结果建立BP神经网络预测模型；利用遗传算法（Genetic algorithm，GA），进一步对BP神经网络的结构参数进行优化，建立GA-BP声品质预测模型。研究结果表明，GA-BP声品质预测模型在训练速度和预测精度上都优于BP神经网络预测模型。预测模型基于声品质主客观评价结果，其预测值可以代替传统的声压级评价指标，为风振噪声提供更为准确合理的评价。