我国水-能源-粮食耦合关系及影响因素

为缓解我国水、能源和粮食资源紧张问题，促进资源可持续利用，构建水-能源-粮食系统，利用耦合协调度模型对我国的30个省（自治区、直辖市）进行测算,并利用空间杜宾模型分析主要影响因素。结果表明：2003—2017年，我国能源、粮食评价[JP]指数高于水资源评价指数，系统综合评价指数逐年递增；大部分省份耦合协调度处于初级协调水平且呈现逐年上升的态势，个别省份耦合协调度濒临失调；耦合协调度空间自相关性较强，虽有明显波动，但是呈现逐年加强的态势；影响耦合协调度的主要因素有从业人口数、固定资产投资额、人均生产总值、人口总数、[JP]文盲人口占比、工业污染排放、城镇化。     

Construction and analysis of photovoltaic directly coupled conditions in PEM electrolyzer

The Markov model and the PEM electrolyzer system model for directly coupled photovoltaic are combined to construct an efficient and reliable working condition that fits the fluctuation characteristics of solar energy. The working condition is designed through genetic algorithm so that the average coupling efficiency of the system can reach 98.8%. Then, the durability and recovery test are conducted on the basis of the constructed conditions. It is found that the attenuation rate at the current density of 1A/cm² under the photovoltaic fluctuating condition reached 7.8mV/h, which is twice that under the constant current condition. The charge transfer impedance (R_ct) is the main factor leading to the degradation. It is proved by the recovery experiment that the increase of R_ct is related to the pollution of metal ions. After pickling to remove some metal ions, R_ct can be significantly reduced by 46.8% and 65.2%, respectively. After the durability test, the voltammetric charges under the photovoltaic fluctuating condition and the constant current condition are reduced by 48.3% and 19.1% It indicates that the photovoltaic fluctuation condition will accelerate the attenuation of the effective reaction area of MEA, which is irreversible even after pickling. It can be observed from the SEM images that the catalyst layer of MEA has more obvious peeling under the photovoltaic fluctuation condition, which is not conducive to material transmission and destroys the transmission channel of ions and electrons. This result can provide a reliable reference for the coupling design of PEM electrolyzer and renewable energy in the future.     

地表径流速度对城市内涝影响规律

为分析地表径流速度对城市内涝的影响,采用一维地下排水管网与二维城区地形的动态耦合模型,选取大连市某排水区块作为研究区域,设置4种地表径流速度10种设计降雨场景,模拟分析在不同重现期设计降雨及不同地表径流速度下研究区的内涝积水特性。结果表明:随着地表径流速度降低,管道排水压力变小,管道排水达标率最高可提升48.05%,且降雨重现期越短,地表径流流速对管道排水压力的削减效果越明显;地表径流流速对检查井溢流量影响显著,随着地表径流速度降低,检查井溢流量峰值最高可减小2 750 m~3,峰现时间最长可滞后56 min,同时随着降雨重现期增长,地表径流流速对检查井溢流量的削减效果减弱;研究区低、高风险区淹没面积随地表径流速度降低,最高可分别减小1.64万、8.37万m~2,但中风险区淹没面积变化反复。     

Microwave bandpass filter by feedback interference topology

This paper proposes a signal feedback interference topology to control the characteristics of a coupled line bandpass filter. Control is carried out by varying the ratio of the transmission line parameters of the forward and the feedback couplers. The topology produces a compact filter that does not require a complicated design or fabrication. The results of the insertion and return losses show that the feedback‐controlled design has desirable features in terms of the design frequency, fractional bandwidth, stopband rejection level, roll‐off rate and insertion loss. The test results of the fabricated prototype achieved good agreement with the simulation results of the ideal transmission line design model. Several microwave, modern wireless and mobile/satellite communication systems may benefit from such a filter design due to its compactness and flexibility.     

检测仪器及消解方式对罗布麻微量元素检测效果的影响

目的 探索罗布麻微量元素适宜的检测条件。方法 以新疆产罗布麻和白麻叶及其制品罗布麻茶为实验材料, 比较了电感耦合等离子体质谱法(inductively coupled plasma mass spectrometry, ICP-MS)和电感耦合等离子体原子发射光谱法(inductively coupled plasma atomic emission spectrometry, ICP-AES)2种仪器对其Li、B、Cr、Fe、Mn、Cu、Zn、Se和Sr 9种微量元素的检测效果, 同时对比了3种不同的湿法消解方式对检测结果的影响。结果 采用不同酸解液的3种湿法消解方法, 硝酸/过氧化氢消解液处理条件较温和, 元素损失量较少, 检测结果稍高于浓硝酸/高氯酸消解液处理的结果, 但所耗消解时间更长。对于易挥发元素Se, 选用酸性和氧化性较弱的硝酸/过氧化氢消解液更适宜。在本试验条件下, 罗布麻体内的Li和Cr 2种微量元素不宜采用ICP-AES仪器检测, 可选用ICP-MS, 而对于难电离元素Se则正好相反。结论 检测罗布麻微量元素含量时, 应根据待检测元素类型特征, 选择适宜的检测仪器。     

电感耦合等离子体质谱法测定辣椒镉含量中不确定度的评估

摘要：目的 采用电感耦合等离子体质谱法(ICP-MS)测定辣椒中镉（Cd）含量，及评估测定过程产生的不确定度，以提高定量分析结果的可靠性。方法 建立数学模型，分析识别试样称量、试样定容、标准物质、标准溶液的配制、标准曲线的拟合、重复测量、回收试验等不确定度来源，量化各不确定度分量，计算合成标准不确定度。结果 辣椒中镉含量不确定度测定结果为：。结论 测定过程不确定度主要来源于标准溶液配制和标准曲线拟合。电感耦合等离子体质谱法测定辣椒中镉含量准确度高，重复性好，建立的不确定度评估能保证分析结果的质量。     

某船用柴油机排气管路流-固耦合计算与保温效果研究

对某船用柴油机排气管路的流动与传热过程开展流-固耦合仿真分析。结果表明:受排气管路结构影响，管内流动方向和流速发生变化，局部区域产生明显的回流现象；排气管路外表面温度分布差异较大，平均温度高达534 ℃。为达到柴油机安全设计要求，在排气管路外壁敷设保温材料。分析结果表明:气凝胶纳米材料的保温效果优于硅酸铝纤维材料，在相同的运行条件和使用要求下，气凝胶纳米材料的敷设厚度更薄。     

Frequency dependence of plasma characteristics at different pressures in cylindrical inductively coupled plasma source

The effects of driving frequency on plasma parameters and electron heating efficiency are studied in cylindrical inductively coupled plasma (ICP) source. Measurements are made in an Ar discharge for driving frequency at 13.56/2 MHz, and pressures of 0.4–1.2 Pa. In 13.56 MHz discharge, higher electron density (n_e) and higher electron temperature (T_e) are observed in comparison with 2 MHz discharge at 0.6–1.2 Pa. However, slightly highern_e andT_e are observed in 2 MHz discharge at 0.4 Pa. This observation is explained by enhanced electron heating efficiency due to the resonance between the oscillation of 2 MHz electromagnetic field and electron-neutral collision process at 0.4 Pa. It is also found that the variation ofT_e distribution is different in 13.56 and 2 MHz discharge. For ICP at 13.56 MHz, T_e shows an edge-high profile at 0.4–1.2 Pa. For 2 MHz discharge,T_e remains an edge-high distribution at 0.4–0.8 Pa. However, the distribution pattern involves into a center-high profile at 0.9–1.2 Pa. The spatial profiles ofn_e remain a center-high shape in both 13.56 and 2 MHz discharges, which indicates the nonlocal kinetics at low pressures. Better uniformity could be achieved by using 2 MHz discharge. The effects of gas pressure on plasma parameters are also examined. An increase in gas pressure necessitates the rise ofn_e in both 13.56 and 2 MHz discharges. Meanwhile, T_e drops when gas pressure increases and shows a flatter distribution at higher pressure.     

Surface modification of TiO2 particles with 12-hydroxy stearic acid and the effect of particle size on the mechanical and thermal properties of thermoplastic polyurethane urea elastomers

The efficient surface modification of titanium dioxide (TiO₂) particles with different sizes was first carried out with “water only method” (Appl. Surf. Sci. 2018, 447, 664–672) developed in our group using 12-hydroxy stearic acid (12-HSA) as the modifier. The 12-HSA-modified TiO₂ particles with different sizes were then used to explore their effect on the mechanical and thermal properties of a thermoplastic polyurethane urea (TPUU) elastomer with superior mechanical and thermal properties produced newly in our lab using nonsymmetric alicyclic diisocyanate and diamine. Orthogonal experimental results showed that the order of impact of each factor on the modification efficiency of TiO₂ particles was: Temperature > time > modifier content. It was found that, in the nanometer (≤100 nm) range, smaller particles were more helpful to enhance the tensile strength of the TPUU elastomer, while larger ones to increase more significantly the elongation at break. Besides, the TiO₂/polyurethane urea nanocomposites exhibited much better thermomechanical performance than the pristine TPUU elastomer, and the thermomechanical performance of the nanocomposites increased with decreasing particle size.