A NEW OIL SEEPAGE IN THE OMAN MOUNTAINS AND ITS GEOLOGICAL,GEOCHEMICAL AND PETROLEUM SYSTEMS CONTEXT

A minor natural oil seepage is described from an unlikely setting in the Oman Mountains. The host rocks are fractured pelagic limestones of the lower member of the Triassic – Lower Jurassic Matbat Formation of the Hamrat Duru Group in the lower part of the allochthonous Hawasina Complex. This paper summarises Oman's established oil families and documents previously recorded oil seepages as context for describing the new seepage, its geochemistry, and possible source rock. The seep oil is different to those known from Oman's oil fields and probably derived from a poor quality, Mesozoic clastic source rock containing a mix of terrigenous and marine organic matter. The most likely source appears to be the Toarcian turbiditic upper member of the Matbat Formation, equivalent to the clastic Mafraq Formation of the Arabian Platform. The occurrence of source rocks in the allochthonous sediments of the NeoTethyan Hawasina Basin has been suspected previously, though their commercial significance remains to be established.     

水力空化改质对重质原油沥青质及性质的影响

利用水力空化过程产生局部的高温、高压、高射流以及强大的剪切力等极端化学物理条件改质处理沙特重质原油，试验结果表明：沙特重质原油经过水力空化改质后粘度由13.61降低至7.22mm2/s，残碳由7.16%降低至6.48%，实沸点蒸馏后减压渣油降低1个百分点。进一步采用APPI FT-IR MS、XRD、FT-IR、SEM和粒度分布等技术研究了水力空化改质对沙重原油分子组成，沥青质团聚体微晶结构、沥青质胶束粒径分布、沥青质官能团、沥青质形貌等方面的影响，从分子角度阐述空化改质重油的机理。研究结果表明：水力空化改质后沙重原油分子量分布、芳烃类化合物缔合作用变小；沥青质对低DBE化合物吸附性能降低；沥青质团聚体微晶结构更加松散；沥青质胶束粒度分布降低；沥青质分子相互团聚作用力减弱。进一步考察了水力空化改质前后减压渣油延迟焦化性能，改质处理后焦炭产率降低1.85个百分点，液体收率和气体产率分别增加1.52和0.33个百分点，水力空化改质对沥青质性质、结构特点的改善能够有效的提高其加工性能。     

Effects of structural parameters on water film properties of transpiring wall reactor

Corrosion and salt deposition problems severely restrict the industrialization of supercritical water oxidation. Transpiring wall reactor can effectively weaken these two problems by a protective water film. In this work, methanol was selected as organic matter, and the influences of vital structural parameters on water film properties and organic matter removal were studied via numerical simulation. The results indicate that higher than 99% of methanol conversion could be obtained and hardly affected by transpiration water layer, transpiring wall porosity and inner diameter. Increasing layer and porosity reduced reactor center temperature, but inner diameter's influence was lower relatively. Water film temperature reduced but coverage rate raised as layer, porosity, and inner diameter increased. Notably, the whole reactor was in supercritical state and coverage rate was only approximately 85% in the case of one layer. Increasing reactor length affected slightly the volume of the upper supercritical zone but enlarged the subcritical zone.     

毫米波三维异质异构集成技术的进展与应用

三维异质异构集成技术是实现电子信息系统向着微型化、高效能、高整合、低功耗及低成本方向发展的最重要方法,也是决定信息化平台中微电子和微纳系统领域未来发展的一项核心高技术。文章详细介绍了毫米波频段三维异质异构集成技术的优势、近年来的发展趋势以及面临的挑战。利用硅基MEMS 光敏复合薄膜多层布线工艺可实现异质芯片的低损耗互连,同时三维集成高性能封装滤波器、高辐射效率封装天线等无源元件,还能很好地处理布线间的电磁兼容和芯片间的屏蔽问题。最后介绍了一款新型毫米波三维异质异构集成雷达及其在远距离生命体征探测方面的应用。     

Coupling effects of water content,temperature, oxygen density,and polytetrafluoroethylene loading on oxygen transport through ionomer thin film on platinum surface in catalyst layer of proton exchange membrane fuel cell

In this work, coupling effects of water content, temperature, oxygen density, and polytetrafluoroethylene (PTFE) loading on oxygen transport through an ionomer thin film on a platinum surface in a catalyst layer of a proton exchange membrane (PEM) fuel cell are investigated using molecular dynamics approach. Taguchi orthogonal algorithm is employed to comprehensively analyze the coupling effects in a limited number of cases. It is found that the effect of operation temperature is the weakest among the four factors, which has the smallest effect index 14.4. Coupling effects including the PTFE loadings on the oxygen transfer through the ionomer thin film is uncovered. Less PTFE loadings should be beneficial for the oxygen transfer. The chemical potential gradient is considered as the major driven force for the oxygen transport through the ionomer thin film, and oxygen density is the dominating factor, significantly affecting the chemical potential in the thin film.     

Concentration dependence of physical properties of low temperature processed ZnO quantum dots thin films on polyethylene terephthalate as potential electron transport material for perovskite solar cell

Colloidal Zinc oxide quantum dots (ZnO QDs) prepared with varying concentrations through precipitation method were deposited on flexible ITO/PET substrates using spin-coating technique. Various characterization tools were utilized to investigate the morphological, structural, electrical and optical properties of the films. The crystallinity of the films was found to improve with increasing ZnO QD concentration (ZQ_C) as evident from the X-ray diffraction (XRD) and field emission scanning electron microscopy (FE-SEM) studies. Crystallographic and optical parameters were evaluated and explained in depth. The average nanograin size and bandgap were increased and decreased respectively, from ～5 nm to ～8 nm and 3.29 eV–3.24 eV with an increase in ZQ_C from 10 mg/mL to 70 mg/mL. Columnar structure growth of the films is revealed by AFM results. The films showed decent optical transparency up to 81%. All the ZnO films exhibited n-type semiconducting property as indicated by the electrical measurements with carrier mobility and low resistivity of 12.21–26.63 cm²/Vs and 11.84 × 10^?3 to 13.16 × 10^?3 Ω cm respectively. Based on the experimental findings, ZnO QD nanostructure film grown at 50 mg/mL is envisaged to be a potential candidate for flexible perovskite photovoltaic application.     

Antioxidant Activity of Piceatannol in Canola Oil

Piceatannol has shown to be a strong antioxidant in vivo, however, its ability to suppress lipid oxidation in foods has not been examined. The present study is to examine the antioxidant effect of piceatannol on heated canola oil compared with that of butylated hydroxytoluene (BHT). The oxidation of canola oil is conducted at 60, 90, 120, and 150 °C by monitoring the depletion of oxygen, the decrease in unsaturated fatty acids, and the changes of primary and secondary oxidation products. Results demonstrated that piceatannol can suppress lipid oxidation of canola oil in a dose-dependent manner with its effect being more effective than BHT. Practical Applications: Lipid oxidation is a major factor in the deterioration of food quality. Synthetic antioxidants, such as BHT and butylated hydroxyanisole, are used to inhibit oxidation in foods, but their safety has been always concerned. Piceatannol has exhibited a strong antioxidant activity to attenuate lipid oxidation and it should be further explored for use as a natural antioxidant in foods.     

核磁共振波谱法测定臭氧化橄榄油中的活性成分含量

以橄榄油为原料,经臭氧氧化制备臭氧化橄榄油。利用核磁共振(NMR)采集碳谱数据,积分碳谱特征峰,计算橄榄油被氧化成分的相对含量。结果表明:臭氧化橄榄油与橄榄油碳谱有明显的区别,臭氧化橄榄油在δ103.1处出现新峰,对应δ130.1处的峰高减弱,这是由于橄榄油中的不饱和双键被氧化。采用该方法测得5个臭氧化油中活性成分含量分别为21.46%、21.03%、21.31%、18.71%和24.42%。采用核磁共振波谱法测定臭氧化橄榄油的活性成分含量具有操作简单,不需要预处理,结果可靠的优点。     

一种植物油中苯并（a）芘含量测定的固相萃取前处理方法

为了建立一种准确性高、成本低的植物油中苯并(a)芘测定的样品前处理方法，基于GB 5009.7—2016以自制氧化铝柱为固相萃取柱，采用单因素试验对称样量、洗脱剂量、洗脱流速、吸附剂存放时间、吸附剂量这5个影响植物油中苯并（a）芘洗脱的因素进行研究，优化前处理条件，并对测定方法进行考察。结果表明：优化的前处理条件为称样量0.100 0 g、洗脱剂量120 mL、吸附剂（氧化铝）量22 g、洗脱流速1滴/2 s、吸附剂存放时间少于12周；方法检出限为0.2 μg/L，样品加标回收率为94.23%～100.00%，RSD为1.20%～7.36%；同一样品测定结果与SGS测定值接近，相对平均偏差为2.36%～3.50%。说明本试验方法测定结果准确，可应用于油脂企业植物油中痕量苯并（a）芘的测定。     

Heterogeneously Catalyzed Methanolysis of Gmelina Seed Oil to Biodiesel

The heterogeneous catalysis of transesterification of gmelina seed oil to biodiesel is evaluated. The oil was extracted from the seeds with n‐hexane by solvent extraction and characterized to determine its physiochemical properties. Response surface methodology was applied to optimize the effect of process variables on the biodiesel yield. The base‐activated clay catalyst performed as montmorillonite clay with the characteristic property of a Brønsted acid. It has an improved surface area after activation that enhanced its catalytic activity on transesterification reaction. Under optimal conditions, the biodiesel yield was 70.1 %, thus demonstrating that the model predicted well the biodiesel production.